Given that lin=2A and R=10 ohm. Using source transformation, the below circuit can be replaced with: R Iin O a. Voltage source (0.2V) with a parallel resistor (10 ohm) O b. Voltage source (20V) with a parallel resistor (10 ohm) O c. Voltage source (20V) with a series resistor (10 ohm) O d. None of the answers O e. Voltage source (0.2V) with a series resistor (10 ohm)

Given that lin=2A and R=10 ohm. Using source transformation, the below circuit can be replaced with: R Iin O a. Voltage source (0.2V) with a parallel resistor (10 ohm) O b. Voltage source (20V) with a parallel resistor (10 ohm) O c. Voltage source (20V) with a series resistor (10 ohm) O d. None of the answers O e. Voltage source (0.2V) with a series resistor (10 ohm)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 16PP: An R-L series circuit contains two resistors and two inductors. The resistors are 86 k and 68 k ....

See similar textbooks

Similar questions

A current source with parallel resistance can be converted into a voltage source with ---- resistance. series parallel series or parallel O no
A RL series has two resistors and two inductors. The Z of the circuit is 1000 ohms. The XL of the inductors is 220 ohms and 470 ohms. one of the resistors has a resistance of 300 ohms. What is the resistance of the other resistor?
PARALLEL CIRCUIT: R1 R2 R3 INSTRUCTION: TO MEASURE THE CURREHT OF RI,R2 & 23 REDRAW THE CIRCUIT & INTEGRATE THE AMMETER INTO THE CIRCUIT.
When R5 is replaced by an open switch, what is the value of Req? When points AB has a Voltage of 12V, how much is the current in R10? When points AB has a current of 8A, How much is the voltage in R10?
solve by ohm's law solve the following mixed circuit 1.Intensities of resistances 2.Voltages of resistances 3 .power of each resistor
The voltage divider shown in the figure has a potential difference (V) between point A and B and a potential difference (VO) between points C and D. What is V FO? A B RM 2R O A. 2 OB. 4 O C.3 OD. S M 2R R :2R C D
Draw the output voltage waveform for the circuit in (b), and (c). and include the voltage values. R₁ www 47 ΚΩ +25 V +12 V 1 -25 V -12 V (b) (c) (a) R₂ • 4.7 ΚΩ out
Write down the steps on how to Series Resistors Voltage Division
Explain this circuits in detail EQU 2 X'+XY
6- What is the total resistance of the mixed circuits shown in the following Figure? Note that each resistor has resistance 6.00. (a) R₁ R₁ R₂ R3 R₁ (b) R₁ Em سره سره R₂ R3 R₁ R₂ Em
In the circuit in the figure, the amplitude of the input current is 5 Amps and its phase is 0 degrees, the amplitude of the input voltage is 18 volts and its phase is 90 degrees. How many volts is the amplitude of the voltage phasor V on capacitor C1? Values of the elements in the circuit:R= 14 OhmsC1= 10j OhmsC2= -3j OhmsL= 4j Ohms
R A IOLL 4) 2A A 2a R4 20V a) Find the voltage at point A due to the 20V source only. b) Find the voltage at point A due to the 2A current source only. c) Find the voltage at point A when both are activated.