Given the second order system below: G (s): A s²+Bs+A Where A = 296 and B = 18 = Determine the settling time (write the answer in four decimal places)

Q: or the common emitter amplifier circuit in Figure Q4(a), determine the low cut- ff frequency for…

A:

Q: Capacitors are used after the converter toA. smooth out the DC current.B. suppress the noise.C.…

A: A converter is used to convert the input AC voltage into DC voltage. The capacitor is used after the…

Q: TABLE 9-2.2 Total Resistance RT and Percentage of Error

A: The total resistance of the parallel resistance network can be reduced into single equivalent…

Q: 3. Draw the equivalent circuit using the superposition theorem by considering the current source to…

A: Superposition theorem: In any linear, active, bilateral network consisting of no energy sources,…

Q: A 125 m cable weighing 2 kg.s per m is suspended between two towers at the same level. The sag is 3…

A: Given cable length = 125 m sag =3 m   arc-length =2a×sinhx2a

Q: 5. Calculate the rms ripple voltage at the output of an RC filter section that feeds a 1.2 k ohm…

A: Given: Input voltage=60 V RMS ripple voltage=2.8 V No load voltage=60V Load resistance=1.2 kΩ…

Q: P.2.16: You are given two z-directed line charges of charge density +1 nC/m at x = 0, y = -1.0 m,…

A:

Q: Given the differential equation, c'"+3c"+5c'+c=r""+4r"+6r¹+r a. Poles b. Zeros C. Plot in Pole-Zero…

A:

Q: The internal resistance of a primary cell is 40. It generates a current of 0.2A in an external…

A: Given, Internal resistance, r=4 Ω Current generating, I=0.2 A External resistance, R=21 Ω

Q: 20KV20 j 1.0 Ω TX#2 10KVA 19.92KV/240V x=10% TX#1 10KVA 19.92KV/277V x= 10% Z2=4.0+j20 |Z1=6.0+j30

A: Given, Generator Voltage=VG=20KV+j0=20KV Z1=6+j3Ω Z2=4+j2Ω Transformer 1: 10KVA, 19.92KV/277V, X=10%…

Q: A single phase transformer is required to be designed to give an output of 4 A at 24 V, from 230 V,…

A:

Q: A transformer converts 460 V into 230 V. The power output is 2.3 kW, how much current is drawn into…

A: Given: A transformer converts 460 V into 230 V. V1=460 VV2=230 V The power output is 2.3 kW.…

Q: Given the transistor in the circuit below a) Find VG, Ig and ID. VGS +5 V R •10 ΚΩ + V DS -5 V 10…

A:

Q: Question 1 Not yet answered How much kWh is consumed by a 4000W electronic circuit operated for 5…

A: Given an electronic circuit consumed, Power, P = 4000 W In time, t = 5 hours 30 minutes = 5.5 hours…

Q: Derive the transfer function of dc servometer

A: Derive the transfer function of dc servometer

Q: Given the field: D = 20 [-sinØ ap + sin 2Ø aØ] Find the total charge lying within the volume 1<p <…

A:

Q: 4. Convert the following equation to its canonical POS form using boolean algebra and find out the…

A: As per our guidelines we are supposed to be the first question only. Kindly repost the other…

Q: What is the shape of a cell in GSM?

A: The solution is provided in the following section.

Q: 6 A transformer converts 460 V into 230 V. The power output is 2.3 kW, how much current is drawn…

A:

Q: Figure Q2(b) shows a BJT amplifier with ß= 120 and VBE = 0.7 V. (i) Calculate current, IB, IC and IE…

A:

Q: The following parts of this question are unrelated and should be treated separately. Is the…

A: Given:  A system has been defined by the equations dx(t)dt=-7-22-3x(t) +111-1u y(t)=121-1x(t)   We…

Q: Derive the transfer function of a two phase AC Servo Motor giving relationship between control…

A: AC servo motor has two stator fields placed at right angles to each other.   one is reference…

Q: The unit for electric displacement D is ○a. N/m² O b. no units C. C/m² d. c/m

A: It was discovered that when an electric field, E, is imposed on a dielectric material. the bound…

Q: 1. What is the wavelength of light waves if their frequency is 5.0X1014 Hz? a. 0.60 m A b. 6.0 mm c.…

A: 1. Given, Frequency of light, f=5.0×1014 Hz

Q: What is the shape of a cell in GSM? |

A:

Q: (15 Points) Assuming an ideal op-amp in the circuit, determine the output voltage Vo- 4 ΚΩ ww 6 V 1…

A:

Q: Three loads are connected in parallel to a 240Z0° V rms of 50 Hz source. Load 1 absorbs 90 kW and 50…

A:

Q: n and be able to transform an s-domain solution rcuits with 5Ω + 20 u(t) Vx 0.5 F не 0.2 Ux 10 a b…

A: We convert the given circuit into its s domain equivalent . As initial condition of the capacitor is…

Q: Solve the following problems: Given the Pole-Zero Map below Determine: -3 •№. Imaginary 0 j Real

A:

Q: If a voltage of 20 V is applied to the coil of a relay with 50 turns and internal resistance of 1 n,…

A: Given data, Voltage, V=20 V Turns, N=50 Internal resistance, R=1 Ω

Q: Analyze the given circuit and determine the minimum and maximum input voltage that the given Zener…

A: Diode is two terminal unidirectional device. Zener diode is special purpose diode in which current…

Q: is circuit breaker good for transformer ?

A: Circuit breakers are specifically used for fuse-less protection against overloads and short-circuits…

Q: Why transformer rated in KVA ?

A: Power may be transferred between two sides of a circuit using transformers without affecting the…

Q: Please show complete solution. 1. Solve for IC, VC, VCE, VE & VCB using Approximate Solution &…

A: Given

Q: When sending images from a satellite, a gridded (frequency) noise would be added into the original…

A: We have to Give a Method the used in Satellites communication for Noise removing from Image

Q: If the electric field in an electromagnetic wave is increasing inmagnitude at a particular time, is…

A: In the electromagnetic wave, the magnetic and the electric field oscillate perpendicular to each…

Q: 31. Consider the following stick diagram. Draw the electrically equivalent transistor-level…

A: According to the question, for the given stick diagram as shown below We need to draw the…

Q: Find the equivalent capacitor and the charge on eachcapacitor. 9V. 6µF. 3µF a Find the equivalent…

A: Given data, Circuit diagram is given as,

Q: Q4 For the circuit given find mesh currents using mesh analysis. (I₁=3.33A, 1₂ = -0.67A) R₂ www R3…

A: Given,

Q: what is the reason behind parallel operation of alternators?

A: Electric power networks are linked together for reliable, cost-effective operation. Synchronous…

Q: For the circuit shown below calculate I and Iz. 1.5 ΚΩ 5.1 V ß = 200 ' 1.2 ΚΩ -12 V

A: Given circuit,

Q: The diodes that are not operated in the reverse biased mode are O a. Varactor diode O b. Tunnel…

A: Diode:- A two-terminal electrical component called a diode is one that conducts current solely in…

Q: A standard cell of 1,0185 V emf is balanced at 50 cm above a student potentiometer. A voltage across…

A:

Q: What is the shape of a cell in GSM?

A: The solution is provided in the following section.

Q: 2. Consider an NMOS transistor operating in the triode region with VGS = 3V, Vtn = 0.7V, and kn =…

A:

Q: Assuming the barrier potential at the junction for silicon and germanium to be respectively 0-7 V…

A: (a) The circuit is shown below:  The above diode is in forwarding bias, applying K.V.L in the above…

Q: Identify the right statement relating to Zener impedance a. O b. O c. O d. the ratio of change of…

A:

Q: what are the disadvantages of slip ring induction motor?

A: The slip ring induction motor, also known as a winding rotor motor, is an illustration of an…

Q: PMMC type meter has a full scale deflection of 10 mA. The resistance of the coil is 30 ohm So,…

A:

Q: (a) The emitter-stabilized bias circuit has the output characteristics as shown in Figure Q2(a). The…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.