Answered: I) Write Erlang B formula. Mention its…

Engineering

Civil Engineering

I) Write Erlang B formula. Mention its uses in traffic engineering. II) Explain briefly about Orthogonal FDMA ?

Residential Construction Academy: House Wiring (MindTap Course List)

4th Edition

ISBN:9781285852225

Author:Gregory W Fletcher

Publisher:Gregory W Fletcher

Chapter1: Residential Workplace Safety

Section: Chapter Questions

Problem 20RQ

See similar textbooks

Related questions

Q: Determine the angular velocity of member CB measured counterclockwise. Express your answer using…

A: First we need to draw the FBD of the given system following which the required parameters can be…

Q: 3. Compute the Time Mean Speed and Space Mean Speed Vehicle Time (s) Speed (km/hr) A 15 100 25 150…

Q: Question1: At a signalized intersection, the coming car turns either left or right or goes through.…

Q: What is the velocity (v) of a stream with a discharge (Q) of 1.20 × 103 m3/s and a cross-sectional…

A: Given data in question Discharge 1.20×103 m3/s Area 3.73×103 m2 To find out Velocity of stream

Q: Q1: [ 50 M]: You are given the following data of an engineering project. 1- Draw the arrow diagram…

Q: ) REFER TO THE TABLE BELOW TO FIND THE LOWER SPEED LIMIT, HIGHER SPEED LIMIT AND MEDIAN SPEED LIMIT.…

A: To Find :- Lower speed limit Higher speed limit Median speed limit

Q: Given the following end-sections of a 15-m wide road whose side slope is 1.5:1. 8 4 4 + 580 4 + 450…

A: For chord distance 20m Chord distance / degree of curve = 2πR/360 Using this radius find as below

Q: Compute the flow of traffic Compute the traffic density . Compute the spacing of vehicles

A: Given data- Peak hour factor (PHF)= 0.90 Space mean speed(V) = 90km/hr Time (t) = 5 min= 5 ×60 sec…

Q: 5. Which among the following is the formula for volumetric flow rate? a) Q = v/A b) Q = Av %3D c) Q…

A: Volumetric flow rate is defined as volume of fluid passing per unit time. It can also be defined as…

Q: 2. Figure shows the captured aerial photography showing the locations and speeds of 4 vehicles…

A: Space mean speed is the harmonic mean of spot speed. Space Means Speed = 4 / […

Q: Derive trapezoidal speed time curve

A: Answer To derive the trapezoid speed time curve we need to draw trapezoidal plot between speed and…

Q: Bias (a) (b) (c) FIGURE 1.20 Exactness of measurements: (a) precise but not accurate, (b) accurate…

A: Accuracy is the condition which shows that calculated or observed value is close to true value or…

Q: An engineer sets up a transit at a point inside a triangular lot and observes the bearings and…

Q: FLow entities: consists of vehicular control and flow control; vehicle routing, scheduling, and…

Q: Given the following end-sections of a 15-m wide road whose side slope is 1.5:1. 8 4 6 4 + 580 4 +…

Q: A man walks along a 50 meter course with following number of paces 68,69,67,69,68. if the average…

A: Find Average number of paces:Avgof number of Pace=68+69+67+69+685=68.2Find the SpeedS=50m×Avg…

Q: itoring become usef

A: traffic analysis is a necessary step for the construction, repair, and extension o new roads.…

Q: 1. Please answer the question: Reynolds number equation is 180001 O A) V*D/dynamic viscosity O B)…

A: Let us analyse the question in step 2.

Q: syster Y 300 Ibs 500 Ibs 1' 1' A 200 Ibs 220 Įbs 380 Ibs 150 Įbs 150 Įbs B.

Q: dy x³ex² dx ylny

A: Hello dear this is the solution of your problem Please see the attached solution, thanks

Q: Explain Traffic Flow model and derive it's generalized form.

A: Traffic flow:- Traffic flow is the study of interaction between travelers like pedestrians, cyclist,…

Q: Ford® Mustang Cobra™ The accompanying table shows time-to-speed data for a 1994 Ford Mustang Cobra…

A: The Trapezoidal Rule is finding the area of trapezoid made by each interval. Let's say time is on…

Q: Write the two types of acceleration?

A: Acceleration is defined as the rate of change in speed with respect to time. The term acceleration…

Q: (b) As a civil engineer, you are involved in highway road constructions. Discuss the purpose of…

A: - Transition curve can be defined as a curve where straight road with horizontal alignment is change…

Q: An engineer sets up a transit at a point inside a triangular lot and observes the bearings and…

Q: What is the angular speed of a carousel which operates at 1.213 rpm? *

A: It is required to find angular frequency in radians per second from given rpm value.

Q: P-0SCApu The population of Pekan Tong Yee in the year 2010 is 137 558. If the population growth is…

Q: In the diagram shown, the correct steps for drawing a triangle starting from point A TO point C in…

A: Given,

Q: Problem No. 1 If the x and y components of a particle’s velocity are vx = (32t) m/s and vy = 8 m/s,…

A: given data , vx=32tvy=8m/s y=f(x) if x=0, y=0 and t =0 x=∫32dtx=16t2+c1when c1=0x16=t2→1

Q: Calculate the end area for the following stations with 30-ft wide roadway and 4:1 slop:…

Q: An engineer set-up a transit inside a triangular lot and observes the bearings and distances of the…

Q: Project a two-lane-two-way road that passes through mostly wavy terrain according to your data and…

Q: 4. The velocity of a point in a flow is a) along the streamline b) tangent to the streamline c)…

A: streamline = the path of a particle in a fluid relative to a solid body past which the fluid is…

Q: Basis of speed limit:

A: Speed limit is the maximum limit above which vehicle is not allowed

Q: Explain the difference between average and instantaneous speed.

A: The overall distance traveled by the object in a given time frame is the average speed. A scalar…

Q: Given the following end-sections of a 15-m wide road whose side slope is 1.5:1. 5 8 4 6 4 + 580 4 +…

Q: Given data: U-4 cm/s V-7 cm/s t325 Find acceleration

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: Q2: Find the solution of the differential equation, y" – 7y' + 12y = 8sinx + e3x?

Q: Find the differential equation whose complete solution is y=c1e-x+c2ex+4x

A: Given:- y=c1e-x+c2ex+4x

Q: In the diagram shown, the correct steps for drawing a triangle starting from point B in the AutoCAD…

A: The steps are as: Draw the line of length 40.00 making an angle of 0° with horizontal. (Enter…

Q: 8) Explain briefly why the regions in the below given graph have curved boundaries rather than…

A: An elastic material has linear relationships between stress strain only till the proportionality…

Q: Minimum flow used to make check for * Diameter min. velocity None of these max. velocity

A: Option 2 is the correct option.

Q: An engineer sets up a transit at a point inside a triangular lot and observes the bearings and…

Q: Explain the setback in direct timing procedure of measuring stop speed

A: Distance a vehicle travel from the time which the break is applied and vehicle get completely…

Q: Find the complete solution of the differential equation? 100 dy +5x+ 4y dx dx²

Q: 1. A fransportation engineering study was conducted to defermine the proper design of bike lanes.…

A: The solution is in step 2:

Q: the road stretch (in vehicles/h) is

A: Given data, Average free flow speed,V=60 km/hJam density on a road, ρj=120 vehicles/kmFor a linear…

Q: The following cross-section notes of the road was examined to calculate volumes. The width of the…

Q: Q3: Given the ordinate of 2 hr. UH. Drive the ordinate of 8-hr. U.H? T(hr.) 2-h UH 300 4 720 6 800…

A: Let's solve above problem using S-Curve method.

Q: *?From the figure, determine R.L of Q from A a1 h B D H1 H2 R. Lof Q = R.L of A +h+ H2O R.Lof Q =…

Question

I) Write Erlang B formula. Mention its uses in traffic engineering.

II) Explain briefly about Orthogonal FDMA ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

(I) :

VIEW

(II) :

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Considering Figure 5-4b, what is the name of GVF in the second channel? Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. b) a M3 b C2 n d Yul M2 S2 Yc S₁5 1 2 1 3 $₂ NDL₁ M2 1 CDL Ynz NDL₂
landscape orientation without erasures 1. The cross section shown in the figure is a structural member known as a z- section Compute the following: (1) cross sectional area, (2) centroidal moment of inertia,Ixo And (3) centroidal moment of inertia, Ivo 3/4 3/4 3.5 Yo 2.625 -3/4 1.375 3.5 -X₂ 113/4
Problem 1: 2m 2m 3m Im Im 2m Am 5m 3m 3m A2 A2 5m 4m 4m 4m 4m 2m A3 7m 9m 8m 4m A3 4m A4 2m 2m 3m 3m Im ANSWER E ONLY 3m 6m 4m Im 5m A4 The top view of Lake Chan is shown in the figure on the left. Cross sections A2, A3, and A4 of Lake Chan are shown on the right. Compute for the ff: (a) Area of A2, A3, and A4 (b) Total Volume using Average End Area Method in m3 (c) Area of mid-section between A1 and A2, A2 and A3, A3 and A4, A4 and A5 (sketch each mid-section) (d) Total Volume using Prismoidal Method in m³ (e) Difference between total volumes acquired from the two methods
Solve the following problem using both analytical(vector or scalar) and graphical (IC center)methods
1) Locate the centroid y of the cross-section and determine the moment of inertia of the section about the x-axis (set variable z to be the last digit in your ID number. For example if your ID number is 12345 then the marked distances with the letter z are 0.45 m and 0.35 m). Failing to use the right digit will result into not grading the question) A bh C 4 = hb 0.4zm x' 0.05 m 0.3zm -- 0.2 m 0.2 m 0.2 m 0.2 m
Solve problem 1 and hurry up please
llo Tutors! Please help me to solve this problem and show the complete solution (including diagrams)Please don't answer it if you don't know the right answer/solution..And to those tutors who is just copying from chegg,shame on you?You didn't even know that those answer from chegg is incorrect..You just copy pasted it?Here is the problem,hope you will help me..Thanks❤️ 2.) A two-lane highway with a design speed of 65 km/h crosses a single railroad track that serves trains traveling at 150 km/h. The highway serves a new development with a significant percentage of school-age children in the population necessitating the selection of a large school bus (68 passengers) as the design vehicle. If the crossing is controlled by a stop sign, determine(a) The minimum sight distance along the two-lane highway that will ensure all vehicles stopping at the stop line;(b) The minimum distance along the railroad track a bus driver should see that will allow him or her to cross the track safely after…
Note: Replace all zero digits of your ID number by number "2" Problem #8 A (m) E Y (N) Use X = Last 3 digits of ID number Y = Last 2 digits of ID number A = 4th digit of ID number 2 m B = 5th digit of ID number %3D C = 6th digit of ID number F X (N) е.g., ID # = 12-3456-789 X = 789 2 m Y = 89 A = 4 A В B = 5 C = 6
ASAP. The topic is elements affecting the traffic system. (Highway and Railroad Engineering)
Show complete solution in finding the d10, d30 and d60 and also graph using the graph presented
The velocity and acceleration of point B is shown. Determine the angular velocity and acceleration of bar AB and OA Vg, ag 100 mm Vg = 5m/s, ag = 2m/s² %3D OX=40mm AX=30mm mm A AB = 200 mm peodn Choose a file
Why Nc=9 and Nq=1?