QUESTION 1If a multiratio CT having 150:5 CT ratio with 0.104 ohm secondary resistance and the excitation current 0.2 A, I -SA Za1 ohm.a) Find the primary side of the CT and show the details of your work.b) Find the CT error and show the details of your work.

Given CT ratio = 150:5 secondary resistance = Zs =0.104 ohm Excitation current Ie =0.2 A I'=5 A…

Answered: If a multiratio CT having 1505 CT ratio…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
PROBLEM: The diode (blue line) should be at -10V not -8V SOFTWARE USED: LTspice XVII---Figure 1 is my work, and figure 2 is the correct sample. Please tell me what I did wrong. Thank you :))---Below is the .asc filehttps://www.mediafire.com/file/zxauoh86zi79nfu/EXPERIMENT_01.asc/file
a/ What is the function of the inductance L in a single phase halfwave thyristor? b/ A controlled full wave bridge rectifier has a source of 50 Sinwt with R = 10 and L = 20 mH find the d.c load current if a = 40°, then draw Vo and lo use 50 Hz freq. and B = 1.1n %3D
Moving to another question will save this response. Quèstion 3 In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True False Moving to another question will save this response. to search 近

The anode of a diode is connected to one terminal of a 1-KΩ resistor. The other terminal of the resistor is connected to the ground and the negative terminal of a 12-volt DC source is also grounded. The three components are connected in series. How much is the load current with the ideal diode?
Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Q5) The schematic circuit in PLECS for a single-phase rectifier is shown below, Thyristor Crout Probe Pulse Generator VC, pulses Probe Scope Thy Orso v Joad O R: 1 The output voltage across R is depicted in 0.5 0.0- b) 0.2 0.0 d)
Determine the voltage waveforms across each half of the secondary winding and across RL when a 100 V peak sine wave is applied to the primary winding. (Si diode used) What minimum PIV rating must the diodes have? D +25 V ----- 2:1 +100 V IN4001 0- Vin oV -25 V -S RL 10 kf -100 V +24.3 V ---- IN4001 Vot 0- alll
In the following circuit the diodes are 0.7 constant voltage model 10V Select one: C. m 10K a. None of the answers b. 2 diodes are reversely biased the 10K resistor can not have currents d. 2 diodes are forwardly biased
For the diode circuit shown below, indicate the ON/OFF condition for all the diodes given VA and VB values. Calculate Vout, Vx and all the currents that flow through the diodes. Summarize your result using a table. +4V VA VB VA OV OV 4V D₁ D₂ X 5ΚΩ D3 VB OV 4V 4V -2V 5ΚΩ VOUT
Question Completion Status: A Moving to another question will save this response. Quèstion 1 Using complete diode model and assuming that the forward resistance of thediode is 152 and a Germanium diode, the voltage across the resistance R equals to R. 5kQ 12V 11.65 V 11.7 V 12 V None of the above.
Half-wave rectifier loaded with R-L is fed with a 120 VAA 60 Hz source. 10 Ω loadFind the inductance value that limits the average load current to 5A for the resistance.
Which of the following statements are FALSE? Diodes are made from insulator material. O Diodes are designed to allow current flow in one direction. O Diodes will allow a reverse current when a large enough reverse voltage is applied. O Diodes can be used to convert AC voltages to DC voltages.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

If a multiratio CT having 1505 CT ratio with 0.104 ohm secondary resistance and the excitation current 0.2 AI-SA Zg 1 ohm. a) Find the primary side of the CT and show the details of your work. b) Find the CT error and show the details of your work.