Answered: If there are 2800 calls arriving per…

If there are 2800 calls arriving per hour to a trunk circuits without blocking, calculate the offered traffic for an average calling time of 1.76 minutes and compute the GoS for 2812 simultaneous c

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.14MCQ

See similar textbooks

Related questions

Q: So cosh 3t u(t)

A: Solve the problem

Q: A homogeneous dielectric (ɛ, = 2.5) fills region 1 (x S 0) while region 2 (x2 0) is free space. %3! ...

A: Given, A homogenous dielectric fills region 1 x≤0 while region 2 x≥0 (a) D1=12ax-10ay+4az nCm2 (b) E...

Q: a. The total vector voltage in rectangular coordinates. b. The magnitude of the voltage that a voltm...

Q: Given that the lower cutoff frequency is 20 Hz and the higher cutoff frequency is 2 kHz. Calculate t...

Q: Determine I, and I, using current division

Q: A balanced 3 phase load draws 75 amperes line current at 230 volts line to line and 0.848 lagging po...

A: In this question, A balanced 3 phase load draws 75 amperes line current V=230 volts line to line Po...

Q: Consider the circuit diagram below. If two identical capacitors must be used to smooth the output, w...

A: Above shown is the circuit of full wave bridge diode rectifier with Capacitive filter which reduces ...

Q: 3. R=__Q 1=12 mA E= 12 V

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below

A: In this question, We need to find the branch currents indicated in the network shown below using the...

Q: approximate voltage amplitude and frequency of the waveform below

Q: Determine the resistance of the insulation in a length e of coaxial cable. b

Q: QUESTION 29 The number of address lines on a 64MX4 chip is: 256M 64M 64 26 20 6 4 O0000

A: The solution is given below

Q: Which side the filter is select (upper or lower)? Explain that at AM-SSB?

A: The solution is given below

Q: 1- Explain the operation of the PCM encoder used in module ED-2960F. 2- Discuss the advantages and d...

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any ...

Q: Derive the following: • The Cu saving for step-up auto transformer with drawing. • The shift angle o...

A: Answer -

Q: Describe and compare the characteristics of TTL and CMOS Logic families

A: Since you have asked multiple question, we will solve the first question for you. If youwant any spe...

Q: Impedances Z1 connected in series. Express the total impedance in polar coordinates. (Please check t...

Q: x(1) = 4(t + 2)u(t + 2) – 4tu(1) – 4u(t – 2) – 4(1 – 4)u(1 – 4) + 4(t – 5)u(t – 5). %3D find and ske...

Q: 3kVA, 230/115V transformer is tested with the following results: Open circuit test: Vac = 230V ; Ica...

Q: 9.1. Determine which of the following discrete-time functions is different: (a) x[n] = u[n] + u[-1 -...

Q: Squirrel-cage rotor bars are not always placed parallel to the motor shaft, but are sometimes skewed...

A: Squirrel-cage rotor- The squirrel cage induction motor has rotor with short circuit end rings. The r...

Q: 1. A 500-V, 50-Hz, 3-phase induction motor develops 14.92 kW inclusive of mechanical losses when run...

A: In this question, 50Hz , 3phase , develop power Pd= 14.92kW Rotor frequency Nr= 995rpm Power factor...

Q: QUESTION 2 ow many address lines are used in the entire sys elow? Type out the number, for example: ...

Q: From the given circuit, find: the upper cutoff frequency of the system. a) 8.6 MHz, b) 10.77 MHz, c...

A: The upper cutoff frequency of the amplifier is due to the presence of internal capacitance and the l...

Q: I. For z1 = 3 – j5 and z, = -2+ find the polar form of the following: 3' d. Re[-? Z1 e. Re[÷ ] f. (z...

Q: 3. For the following circuit assume r 33.4 2 a. Draw the small signal equivalent circuit. b. Find th...

A: a) b) Input Impedence = RE || re Given that , RE = 68 Kohm r...

Q: a. Explain autotransformer starting method and wye-delta starting method of 3-D induction motor with...

A: Since you have posted the multiple questions so we are supposed to answer 1st one.

Q: In the experiment (Differential amplifier) answer the following: Theoretical Calculations: 1. When i...

A: Solve the problem

Q: Consider a transformer where the secondary winding is connected in series to a resistor with resista...

Q: 4) How much energy does a 5mF capacitor connected to a 3v battery store? A)67.5 mJ B)7.5 mJ C)22.5 m...

A: Given: Capacitance, C=5 mF Source, V=3 V

Q: Simplify the following Boolean Expression using Boolean Rules and De-Morgan's Theorem; ww w 1. (ABC ...

Q: R3 If R3 R1 R1 V, V1 Vat A R2 V2 R2 A oVat V2 R4 Ov Figure 2(b)Figure2(c)

Q: Two charged parallel metal plates are separated by a distance d and a potential differen ce of VAB b...

A: Solution- a) Force on electron is towards left plate so electric field is to the right. ...

Q: Question 5 Consider the single-element varying Wheatstone bridge shown below. The gain is: 6982 6982...

Q: 2. To what type of circuit does a differential amplifier correspond?

A: Differential amplifier is circuit which gives the output voltage corresponding to difference in the ...

Q: 9.15. (a) A continuous-time signal x(t) cos 2nt is sampled every T seconds. resulting %3D the discre...

Q: Vpp Voo 2) NMOS CL R2 VTN = 5V Vout Rsig un Cc SooMm MI RL SOum ki = 100 MA/v> Usig RI Cs a = 0,00| ...

A: Answer -

Q: Obtain the transfer function of the electrical system. E¡ (s) R R

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.

Q: R. V. In the circuit above inductance L =1 mH, capacitance C= 2.2 nF and resistance = R0.32 kohm Wha...

Q: For the circuit in the figure obtain the contribution of the sources of (Y)V and (X)V to vz. Note: V...

A: This problem comes under electrical network theory . It is related to super position theorem . In th...

Q: Implement the Simple adder with Sum and Carry, and generate the simplified equations from the k-Map

Q: Q2: (5) volts zener diode is used in the circuit of fig (2), if I zmin is (10) m Amp. and the maximu...

A: As per our guidelines, we are supposed to answer only one question at a time. Please repost the othe...

Q: For the circuit in Figure 1, set up the supernode equation. Response format: Ava ± Bvb ± Cvx = D 2)...

Q: 70 50 30 -30 -50 -70

Q: 5. What capacit in series with a 1.5-k2 resistor will draw 50 mA from a 120-V, 60-Hz source?

A: Brief description: Capacitor is an electrical element which is used to store the charges in the form...

Q: 1. An aluminum wire has a resistance of 80 ohms at 30 degree Celsius. Determine its resistance when ...

A: We need to find out resistance at given temperature of aluminium

Q: E,(s) of the electrical system. E¡ (s) Obtain the transfer function R2 ww R R ww R2 R2 ww

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly re...

Q: 4. What is the application of AM-SSB?

A: (i) AM-SSB is used for long distance transmission of voice signals. (ii) AM-SSB is used in the trans...

Q: Q2: Draw the block diag ram for the Following system described by Zcn).

A: It is given that: z(n)=y-nyn=2xn-xn-2+2yn-1

Q: Differentiate Single-Phase Motor Starter to the Three-Phase Motor Starter.

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Concept explainers

Uplink and Downlink Segment

The uplink and the downlink are the terminologies that are used in the satellite communications. The data when sent from the ground to the satellite is called the uplink and data when sent from satellite to ground is called downlink. The uplink and the downlink process goes in parallel and this is also a two way communication.

Question

If there are 2800 calls arriving per hour to a trunk circuits without blocking, calculate the offered traffic for an average calling time of 1.76 minutes and compute the GoS for 2812 simultaneous calls.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Uplink and Downlink Segment of Satellite

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a group of trunk is offered 900 calls during the busy hour & 10 calls are lost along with the average call duration of about 5 min, then what would be the grade of service. 75 74.167 0.011 0.833
GIVEN: Three-phase System Data: 30 Source ZLine 30 Load Ean Zan = Zbn = Zen = 0.1 + j1.5 n Source: 12020° v; Epn = 1202 – 120° v; Een = 1204120° v (grounded neutral) Line Impedance: Zline a = Zline b Zline c = 1+ j2 N; C Load Impedance: Zab 40 + j30 N; Zbc = 40 – j30 N; Zca = 50 + j0 N %3D %3D
In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2 minutes. Calls that fail to seize a circuit are immediately dropped. Determine the probable amount of blocked traffic in Erlang
Which of the following statement is related to National Telecommunication Authority (NTA) in telephone call routing? O NTA responsible for national numbering plan only. O NTA responsible for nation-wide service numbers only. O NTA responsible for both national numbering plan and nation-wide service numbers. O None of these.
Among the following which statement or statements are True? Select one or more: The difference in the transmission delay between the fastest and slowest pairs of the same un-twisted pair cable is called Delay skew The difference in the propagation delay between the fastest and slowest pairs of the same un-twisted pair cable is called Delay skew The difference in the propagation delay between the fastest and slowest pairs of the same twisted pair cable is called Delay skew The difference in the propagation delay between the fastest and slowest pairs of the same un-twisted pair cable is called Delay distortion
Discrimination (Selectivity or coordination) Problem: Given the below single line diagram where, the red curve is for a PD1 circuit breaker (Upstream). The blue curve is for a PD2 circuit breaker (Down stream) SUPPLY See the following curves to check the discrimination at the red, green and blue arrows (if the fault happened at the downstream PD2) N NOT DISCRIMINATING WITH UPSTREAM DEVICE 4h 2h 1h 30 m 10 m 50 s 8s 5s 25 0,800 s 0.500 s 0.300 s 200s 0.080 s 0.050s 8838: 0.010s 0.0050 s 0.0010s Current (A) The time selectivity between PD1 and PD2 if the fault happens at PD2 for a current rating coincides with green arrow is Select one: O a At = 47seconds 1/20/22, 4:08 PM O b. At = 27seconds Oc. At = 57seconds Od. At = 37seconds O e. None of these Of At = 7seconds Tripping Time
7. Higher slopes are required in cases where there is a lot of mismatch between the CTs at various terminals. Explain. V
There is a linearity error in the following relationship: 10 8. 0. 0.0 0.5 1.0 1.5 2.0 Distance in (cm) True False Resistance (kohms) 2.
Explain the importance of return loss in transmission cabling and its effects on network performance.
I want a solution in less than 30 minutes Often, the network is referred as an infinite bus when a change in input mechanical power or in field excitation to the unit does not cause an appreciable change in a. system frequency or terminal voltage b. Total production cost c. system frequency and terminal voltage d. system frequency alone
The X/R circuit ratio of an automatic reclosure is inversely proportional to the asymmetrical factor True False
i. What are equipments used for dynamic voltage regulation in PST2200 Simulator. ii. Why voltage regulation is important in Transmission lines? Explain. i. Voltage regulation may be negative for inductive load !!