In a test to determine the discharge coefficient of a 30 cm by 15 cm Venturi meter the total weight of oil (specific gravity = 0.83) passing through the meter in 2.0 minutes was 15383 N. A water-oil differential manometer connected to inlet and throat of the meter showed an average water difference during that time of 20 cm. Determine the meter coefficient and the head loss on the meter. Compute all values rounded to the fourth decimal point. Direct substitution to formula solution will have no credit points.

Q: Water leaks from a cylinder with axis vertical through a small orifice in its base at a rate…

A:

Q: The properties of three pipes connected in series are tabulated below. (a) What is the head loss…

A:

Q: 0 Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter, the…

A: Question No 1: Given data: weight of water = 3.5kn = 356.9kg Discharge will takes place in 5min As…

Q: The discharge through a 75-mm diameter orifice at the bottom af a large tank was measured be 1.734…

A: Given data  Actual Discharge  Diameter  Head

Q: 3. Neglecting losses, find the discharge in gallon per minute through the venturimeter as shown…

A: Diameter of inlet (d1) = 300 mm = 0.3 m Diameter of throat (d2) = 150 mm = 0.15 m Head difference…

Q: 3. Neglecting losses, find the discharge in gallon per minute through the venturimeter as shown…

A: from figurePressure head fall=P1γw-P2γw=0.250.25mso,v1A1=v2A2v1=v20.1520.32v1=0.25v2so,

Q: Using the value of Cd, which you have obtained by experiment, determine the throat diameter of a…

A: Solution  Given Data:- Pipe Diameter = 0.6 m  Differential Head = 0.8 m Flow Rate = 0.4 m3/s  Find-…

Q: Given water flowing through a 50 ft long pipe with a 1/2 in diameter at a flow rate of 5 gal/min,…

A: Q=5 gal per min   =5×0.1336 ft3 per min     =5×0.1336×0.305360 m3 per sec     =0.316×10-3…

Q: You run an experiment to estimate the water flow rate of the drip irrigation system in the Elon High…

A: Given data, Diameter = 11.2 cm Time t = 2 hrs.

Q: In the figure below two pipes containing the same fluid of density r = 990 kg/m3 are connected using…

A: Given data  Density Relative density Height of liquid column U tube manometer  To find Pressure…

Q: Before Impact VA VB After Impact VA' V'E

A:

Q: 3. In Figure below, sensor A reads 2.2 kPa (gage). All fluids are at 22°C. Determine the elevations…

A:

Q: Calculate length of the pipe required to bring down the concentration of chlorine from 6x105 CFU/L…

A: Given: Initial chlorine concentration, Co = 6 x 105 CFU/L Permissible chlorine concentration, C =…

Q: ERE IS A LEAK IN A HORIZONTAL 300 MM DIAMETER PIPELINE. UPSTREAM FROM THE LEAK TWO GAGES 600 METER…

A: Given:- diameter=300mm distance=600m difference of gauges=140m friction factor=0.025 To find:- water…

Q: in a sprinkler irrigation system, the following information is given: the length of the sprinkler…

A: Given: The length of pipe is LPipe=360 m. The Hazen-William constant is C=100. The gross depth is…

Q: An experiment to determine the discharge coefficient of the venturi meter was conducted and the…

A: A1=Inlet area =π4*0.312=0.07547m2 A2=Outlet area =π4*0.192=0.02835m2

Q: In the system shown, the water discharge flow rate of 0.0025 m³/s is delivered through the 8 cm…

A:

Q: Question 8 A pitot tube was installed in a pipe section and showed a maximum height of 100mm. What…

A:

Q: 3) Figure below shows a cross section through a long canal embankment. Explaining carefully the…

A: .

Q: A pipe has a diameter of 20 mm and a length of 80 m. A liquid having a kinematic viscosity of 4 x…

A:

Q: As shown in Figure 1, an ideal gas flows isentropically from a large tank into a converging ozzle…

A:

Q: Determine the head loss due to sudden enlargement in a pipe from a diameter of 200 mm to 400 mm when…

A: Given: Initial diameter, D1 = 200 mm = 0.2 m Final diameter, D2 = 400 mm = 0.4 m Flow rate, Q = 250…

Q: A horizontal venture meter is used to measure fluid flow from the tank with the inlet and throat…

A:

Q: A discharge of 750 liters/sec flows through a pipe having a diameter of 400 mm and a length of 65 m…

A:

Q: The discharge in a rectangular channel is given as Q = V*W*H, where V is the measured velocity, W is…

A: The given data is as follows:

Q: PROBLEM 1: Both a gage and a manometer are attached to a tank lo measure pressure, Given the reading…

A: The values and diagram given in the question are as follows

Q: Q1/ A horizontal venture meter shown below, the diameters D=160 mm, d= 80 mm used to measure the…

A: Given D = 160mm         d = 80mm         g = 9.81m/sec² = 9.81*10³ mm/sec²          Q = 50lit/sec =…

Q: 1. A capillary tube viscometer as shown in Figure 1 is being used to measure the viscosity of an oil…

A: Given : Tube inside diameter, D = 2.5 mm Length between manometer taps, L = 300 mm Manometer…

Q: A cylindrical tank contains three liquids of specific gravities: 0.80, 1.00, and 1.50. Each liquid…

A:

Q: In testing a fire pump, it is desired to flow 500 gpm (1890 liters per minute) from a 1 3/4-inch (45…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A differential manometer is attached to a pipe as shown in the figure below. Calculate the velocity…

A: Given data  Deflection in manometer  Specific gravity  To find Velocity

Q: Consider the system shown in the figure. If a change of 0.9 kPa in the pressure of air causes the…

A:

Q: Two tanks connected by three pipes in series are shown in Figure 2. The lengths of these pipes are…

A: Calculate entry loss and friction loss for the first pipe:

Q: A cylindrical tank contains three liquids of specific gravities: 0.80, 1.00, and 1.50. Each liquid…

A:

Q: A horizontal venturimeter 9 cm x 4 cm is installed in a 9 cm water pipe. A differential…

A:

Q: A roof tank supplies water as shown in Figure 1. Calculate the minimum height (H) in metre required…

A: Given - Static head = 1.5m Velocity  = V1.01/s   Formula used -  Htotal = Static headHs + Dynamic…

Q: Question 1 5 pts The flow rate in a pipe with 750mm diameter is 100 Liters per second. The fluid is…

A:

Q: 0 Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter, the…

A:

Q: In the figure shown pipes are in parallel connection with properties given. If the flow into the…

A:

Q: 1. Water flows in a 400 mm diameter pipe at the rate of 500 liters per second. The pipe has a length…

A:

Q: In the system shown, the water discharge flow rate of 0.0025 m³/s is delivered through the 8 cm…

A:

Q: Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter, the…

A: ''Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Using an actual flow rate of 0.18 m3/s as measured by the Venturi meter, and a pressure drop of…

A: Density of air (ρair) = 1.19 kg/m3Density of water ρwater = 1000 kg/m3Upstream cross sectional area…

Q: An oil of specific gravity 0.89 is flowing through a horizontal venturimeter fitted to a 242 mm…

A: It is required to find head difference in m of oil, theoretical and actual discharge, coefficient of…

Q: A pitot tube was installed in a pipe section and showed a maximum height of 100mm. What is the flow…

A:

Q: The total head loss in the pipe system shown in the figure below is 15 m. Assume f= 0.02 for all…

A:

Q: D Water Gs=1 1. In a test to determine the discharge coefficient of a 70 by 35 mm Venturi meter, the…

A:

Q: The following observation were made using a current meter: The rating formula is V=aN+b Find the…

A:

Q: A calibration test of a 0.00785 m2 circular sharp-edged orifice in a vertical side of a large tank…

A:

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.