Quickly plese Describe how to prepare 800 mL of a 2.0 M solution of hydrochloric acid (HCI) from acommercial solution of nitric acid with a purity of 37% and a density of 1.19 g.cm.CAUTION. Concentrated hydrochloric acid is dangerous; therefore, a special care must be takenin manipulating this chemical.Question 3.Nitric acid (HNO3) is a powerful and corrosive acid. When ordered from a chemical supplycompany, its molarity is 16.0 M. How much of the stock solution of nitric acid needs to be used tomake 8.0 L of a 0.50 M solution?

Answered: Image /qna-images/answer/4d577985-b27a-469c-9b50-b5187edb6f59.jpg

Answered: its molarity is

Science

Chemistry

its molarity is

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter4: Types Of Chemical Reactions And Solution Stoichiometry

Section: Chapter Questions

Problem 135CP: A 0.500-L sample of H2SO4 solution was analyzed by taking a 100.0-mL aliquot and adding 50.0 mL of...

See similar textbooks

Related questions

Q: Using SPECTROSCOPIC notation write the complete electron configuration for the iron atom. Using NOBL...

A: Given, 1). Using the spectroscopic notation write the complete electronic configuration for the iro...

Q: Bill Nye music v

A: In this question we have to explain the Bill Nye music video and also the other parts of the questio...

Q: the mass of o

Q: QUESTION5 Compound A has the formula C8H8. It reacts rapidly with KMN04 to give CO2 and a carboxylic...

Q: y seconds da

Q: Given the first order reaction A(g) -- > B(g) + C(g) + 3D(g) with a rate constant of 6.0x10-4 s...

A: Given :- A(g) → B(g) + C(g) + 3D(g) Reaction is first order K = 6.0x10-4 s-1 Initial concentrati...

Q: Decide whether each molecule or polyatomic ion is polar or nonpolar. If the molecule or polyatomic i...

Q: e. 85.0 g of P,O,. f. 40.0 g of CO,. g. 2.92 g of NaHCO,.

A: Note: As per company policy we are supposed to attempt first three subparts only.

Q: A student reacted 49.3 mL of 1.0 M HCl at 20.0°C with 48.7 mL of 1.5 M NaOH at 22.0°C, after the rea...

A: When HCl is reacted with NaOH, neutralisation reaction takes place and NaCl and H2O will be produced...

Q: A chemical reaction takes place inside a flask submerged in a water bath. The water bath contains 5....

Q: (a) For a sample of gas at constant temperature, its pressure multiplied by its volume is a constant...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: C. Draw the chemical structure of the following: 11. bromocyclobutane 12. propylcyclohexane 13. fluo...

A: The structure of an organic compound is written in the following steps: Determine the number of car...

Q: In precipitation of hydrogen sulfide of group II cations, there is need to add hydrogen peroxide in ...

A: Group II cations (Cu2+, Bi3+, Cd2+, Hg2+, As3+, Sb3+, Sn4+) are precipitated as sulfides.

Q: Part 1 Do not include states of matter, multiplication symbols, or extra spaces. Use brackets [] to ...

Q: In each of the molecules drawn below one chemical bond is colored red. Decide whether this bond is l...

Q: If a buffer solution is 0.280 M in a weak acid (K, = 4.9 x 10) and 0.400 M in its conjugate base, wh...

Q: CO(g) + Cl2(g) COCI2(g) The above reaction obeys the mechanism: Cl2 2CI Fast equilibrium CI + CO COC...

A: The above mechanism is formation of COCl2. Where slowest step is rate determining step. Option C is ...

Q: Green plants use light from the Sun to drive photosynthesis, a chemical reaction in which liquid wat...

A: Given Moles of CO2 = 0.085 mol

Q: 15. Iron reacts with oxygen to give iron(III) oxide, Fe2O3. (a) Write a balanced equation for this r...

A: a). Balanced chemical reaction Fe (s) + O2 (g) → Fe2O3 (s) Balance oxygen atoms by multiplying 3 i...

Q: Which of the following statements is correctly labeled as true or false? Choose all correct answers ...

A: We will see each statement if it's true or false and why.

Q: thermometer A sample of polystyrene, which has a specific heat capacity of 1.880 J-g¯°c¯³, is put in...

Q: Br F Na OMe O2N

A: Mechanism of aromatic nucleophilic substitution reaction:

Q: The last slide of the video on applications of the Boltzmann distribution describes the behavior of ...

A: Hydrogen gas molecule are diatomic molecule and the gas is at thermal equilibrium.

Q: Consider the pressure of a height of 10 km in a volume of air, M = 0.0289 kg/mol. If the pressure %3...

A: Solution - According to the question - Given values - P at T = 300 K P1 = 101.325 *exp (-0.0289 * 9....

Q: Using tabulated K, and Kg values, calculate the pH of the following solutions. Answer to 2 decimal p...

A: Given, The volume of HOCl = 95.00 mL Molarity of HOCl = 1.100 M The volume of NaOH = 40.00 mL Molar...

Q: Using specific heat eap A chemical reaction takes place inside a flask submerged in a water bath. Th...

A: The heat transferred ( q ) can be found out using the equation, q = m × C × ΔT m = mass...

Q: Calculate the molal concentration, m of a solution that contains 12g of Magnesium hydroxide, mg (OH)...

A: Answer: Among different ways of representing the concentration of a solution, molality is one method...

Q: A chemist carefully measures the amount of heat needed to raise the temperature of a 506.0 g sample ...

A: Given Mass (m)= 506.0 g Initial temperature (Ti) = -2.4 °C Final temperature (Tf) = 21.6 °C Heat n...

Q: Hydrogen chloride and oxygen react to form water and chlorine, like this: 4HCI(g)+O,(8) 2H,0(g)+2Cl,...

Q: V.) A compound with molecular formula C8H10O has the following proton NMR spectrum. Determine the nu...

A: NMR spectroscopy is a very important tool for the determination of the structure of the organic comp...

Q: Base on the information in the table (see pictures attached) predict the ppm range you would expect ...

A: The given structure of the compounds are :

Q: In terms of collision theory, When is a chemical reaction occurs? A. chemical bonds are broken by ...

Q: A mixture of helium and oxygen gas is compressed from a volume of 96.0 L to a volume of 23.0 L, whil...

Q: Balancing using only oxidation number method. Please show complete steps in balancing. Don’t skips i...

A: The solution is as follows:

Q: pH

Q: A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into gas...

Q: What are the different methods to pack a column? Point out two ways in which thev differ from each o...

A: A question based on analytical separations that is to be accomplished.

Q: . Calculate hHg (Density water = 1.00 g/mL Density of Hg = 13.6 g/mL) %3D %3D

Q: 4. Draw both chair conformations of menthol. Circle the one with lower energy and briefly justify yo...

Q: An iron atom has a mass of 9.27 × 10¯ - 23 g and a cooking pot has a mass of 0.500 kg. Use this info...

A: Given, Mass of 1 iron atom = 9.27 × 10-23 g Mass of cooking pot = 0.500 Kg = 500 g a) mass of 1 mole...

Q: Drow the most electron-rich carbon atom in ho Compound below:

A: We have to determine the most electron-rich carbon atom in the given atom.

Q: 1) List the following in order of decreasing size: a) CiK Mg Na Rb b) Cư Cư Cu c) Mg Na AP 2) Rank (...

Q: REACTION WITH SODIUM 1. Place 2 mL of each of the following alcohols in separate dry test tubes: eth...

A: The reaction are as follows:

Q: Is phenol and p-nitrophenol anticipated to inductively withdraw (-I) or donate (+I) negative charge ...

Q: If the actual yield of the reaction was 75% instead of 100%, h was over?

A: This is a multiparts question. According to guidelines in multiparts question We can solve only the ...

Q: A mixture contains 0.400 mol of gas A, 0.500 mol of gas B, and 0.120 mol of gas C. What is the total...

Q: Measurements show that the energy of a mixture of gaseous reactants decreases by 206. kJ during a ce...

A: We have to predict the type of reaction and change in enthalpy.

Q: Comment on the strengths and limitations of particle sizing using sieve analysis. Suggest an alterna...

A: Sieving is a technique for particle sizing which is performed to separate a sample based on its part...

Q: Arrange the following aqueous solutions, all at 25°C, in order of decreasing acidity. Rank from most...

Q: A mixture of nitrogen and hydrogen gas is compressed from a volume of 94.0L to a volume of 88.0L, wh...

Concept explainers

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.

Question

Quickly plese

Describe how to prepare 800 mL of a 2.0 M solution of hydrochloric acid (HCI) from a
commercial solution of nitric acid with a purity of 37% and a density of 1.19 g.cm.
CAUTION. Concentrated hydrochloric acid is dangerous; therefore, a special care must be taken
in manipulating this chemical.
Question 3.
Nitric acid (HNO3) is a powerful and corrosive acid. When ordered from a chemical supply
company, its molarity is 16.0 M. How much of the stock solution of nitric acid needs to be used to
make 8.0 L of a 0.50 M solution?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Vitamin C has the formula C6H8O6. Besides being an acid, it is a reducing agent. One method for determining the amount of vitamin C in a sample is to titrate it with a solution of bromine, Br2, an oxidizing agent. C6H8O6(aq) + Br2(aq) 2 HBr(aq) + C6H6O6(aq) A 1.00-g "chewable" vitamin C tablet requires 27.85 ml of 0.102 M Br2 for titration to the equivalence point. What is the mass of vitamin C in the tablet?
What volume of a 0.3300-M solution of sodium hydroxide would be required to titrate 15.00 mL of 0.1500 M oxalic acid? C2O4(aq)+2NaOH(aq)Na2C2O4(aq)+2H2O(l)
A 25-mL sample of 0.50 M NaOH is combined with a 75-mL sample of 0.50 M NaOH. What is the concentration of the resulting NaOH solution?
A 8.50 g sample of KCl is dissolved in 66.0 mL of water. The resulting solution is then added to 72.0 mL of a 0.280 M CaCl2(aq) solution. Assuming that the volumes are additive, calculate the concentrations of each ion present in the final solution.
A mountain lake that is 4.0 km × 6.0 km with an average depth of 75 m has an H+(aq) concentration of 1.3 × 10−6 M. Calculate the mass of calcium carbonate that would have to be added to the lake to change the H+(aq) concentration to 6.3 × 10−8 M. Assume that all the carbonate is converted to carbon dioxide, which bubbles out of the solution.
One half liter (500. mL) of 2.50 M HCl is mixed with 250. mL of 3.75 M HCl. Assuming the total solution volume after mixing is 750. mL, what is the concentration of hydrochloric acid in the resulting solution? What is its pH?
The equivalence point for the titration of a 25.00-mL sample of CSOH solution with 0.1062 M HNO3 is at 35.27 mL. What is the concentration of the CsOH solution?
A 0.500-L sample of H2SO4 solution was analyzed by taking a 100.0-mL aliquot and adding 50.0 mL of 0.213 M NaOH. After the reaction occurred, an excess of OH ions remained in the solution. The excess base required 13.21 mL of 0.103 M HCl for neutralization. Calculate the molarity of the original sample of H2SO4. Sulfuric acid has two acidic hydrogens.
Three acid samples are prepared for titration by 0.01 M NaOH: 1 Sample 1 is prepared by dissolving 0.01 mol of HCl in 50 mL of water. 2 Sample 2 is prepared by dissolving 0.01 mol of HCl in 60 mL of water. 3 Sample 3 is prepared by dissolving 0.01 mol of HCl in 70 mL of water. a Without performing a formal calculation, compare the concentrations of the three acid samples (rank them from highest to lowest). b When the titration is performed, which sample, if any, will require the largest volume of the 0.01 M NaOH for neutralization?