Mention six (6) applications of attenuators.
Q: 3 A complex low-pass signal has a bandwidth of 500 kHz. Identify the minimum sampling rate for this…
A: Given, Bandwidth of a complex low pass signal is fm = 500 KHz
Q: The z-transform of the function X(s)=10/(s+10) at T=0.01 sec is Select one: a. 10z/(z+0.9048) b.…
A:
Q: 1. Difference between Luminance and illuminance? 2. Difference between Lumen and Candela?
A: As per guidelines given to us,we can only provide the solution of first question in multiple type of…
Q: : Determine the total equivalent resistance at point a-b for the circuit in Figure
A:
Q: Design a circuit that will have an outcome of the highest equivalent resistance across the terminals…
A:
Q: Given the system below, find the steady-state error if R(s) Y(s) R(s) s² + 7s + 10
A: We need to find out steady state error .
Q: 3. Find the Total Resistance RAB in the circuit. 2 kll 2 kll 10 kl A O 6 kft 6 kl 6 Kn RAB 4 kn 1 kl…
A:
Q: The number sequence generated by the function x(k)=u(kT) is independent of the sampling period T.…
A: Sampling period of a signal is 1/T or it is the inverse of the frequency. Given a sequence ,…
Q: Consider the circuit shown a. Determine the initial conditions v(0~) and i(0~) b. Determine the…
A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: Base Current 10uA 29uA 3mA 5mA 2. Collector Current 30uA 6mA 2.89mA 1mA 3. Emitter Current 2.9mA…
A: The solution is given below
Q: Problem 6- A Three-phase 60 Hz transmission line has its conductors arranged in a triangular…
A: In this question we need to find capacitance , line charge current and series reactance of the given…
Q: L. Design a suitable op amp circuit to implement the following equation: 1 = 20V, – sv, ) + 6 fv, -…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: 5) Sinusoidal Steady State and Frequency Domain Analysis İn(t) Vin(t) = 5 cos(250t) 100 2 A) Solve…
A:
Q: For the transsmision line below find the average incident Power p and the average refelcted Power p…
A: According to the question, for the given circuit as shown below We need to find the average…
Q: The current element of the magnetic vector potential for volume current will be Your answer
A:
Q: In own words, how Inductor works in a circuit and what inductor is made of?
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: 1. Difference between Luminance and illuminance? 2. Difference between Lumen and Candela? 3. List…
A:
Q: LC-Tuned Circuits: Colpitts • This oscillator Example: A Colpitts Oscillator circuit having two (2)…
A: Colpitts oscillator: This oscillator has an amplifier circuit or op-amp circuit and an LC circuit.…
Q: Q4: For the class B output stage of Figure (Q3), let Vcc = 6 V and R, = 4 N. If the output is a…
A: Please refer the attached images for the complete answer..
Q: 1. When the three identical wye connected coils are supplied with 440V, 60hz 3-phase supply, the…
A:
Q: An electronic nose, in principle, can measure or identify very large number of compounds despite…
A: The Electronic nose is a multi-sensor electronic device used for detection of various chemical…
Q: Vp DD Rp2 Vo Rp1 V12 M2 M1 ViI Rs Vss 0 V SS
A: Types of differential amplifier Dual input balanced output Dual input unbalanced output Single…
Q: Calculate the amplitude ratio for the transfer function 2/(8s+4) for w = 3 .
A:
Q: I. Design a suitable op amp circuit to implement the following equation: dV f = 6(2V, – 4V, ) – 3…
A:
Q: 4 Determine The ratiated fower of stort dipote emutna2
A:
Q: Calculate the gain constant of a hypothetic laser having the following parameters: inversion density…
A:
Q: 3. Determine the thermal coefficient of resistance of copper at 50°C, then use this value to…
A:
Q: If the roots of the characteristics equation z=0.53474t0.5543 rad and sampling time%3D0.5sec., the…
A:
Q: Q.1 A single-phase diode bridge rectifier is connected to a grid with rms voltage V, 230V at 50…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: A device can be modeled as a current source in parallel with a resistance. When this device is…
A: Given A device can be modeled as a current source in parallel with a resistance. When this device…
Q: From the truth table in Table 2 below, do the following: Write the minterm Boolean expression for…
A: given here a truth table and asked to write the minterm expression for that truth table. in minterm…
Q: Q1 a) For the following system: s+ 4 (s + 2)(s + 4) i) What are the poles and zeros of this system…
A: We need to find out pole and zeros of given transfer function and state transition matrix for given…
Q: t72)ind Trans fer far XCh)-(h1) e
A:
Q: 3) Find the Thevenin equivalent circuit looking into terminals a-b in the circuit below.
A: The thevenin's equivalent circuit can be calculated by using the nodal analysis method. The…
Q: 330ka vo1 150KO + 15 V. 33kQ + 15 V + 20mVe W 100KO 22kQ - 50mV.W + 0.2VM vo2 12kQ 30kQ - 15 V +…
A:
Q: A small supermarket 20 m long by 15 m wide is to be illuminated to a level of 600 lx by 2400 mm 125…
A: The illuminance of a light source or bulb is measured in terms of "Lux". The luminance, whereas, is…
Q: Given the two points, C-3, 2, 1) and D(r = 5, 0 = 20, 9 = - 70), find the distance from C to D.…
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: A stone was thrown vertically with initial velocity of 49 m/s from ground, after 2 sec. another…
A: Time taken by stone A to reach the top most point is given by, tAtop=ug=499.8=4.99 sec Time taken by…
Q: How is this directly coupled- output of stage 1 directly connected to input of stage 2. Explain with…
A: Types of coupling RC Coupling Direct coupling Transformer coupling Impedence coupling
Q: 8- Explain the difference of B values between three regions (forward, reverse and saturation).…
A: BJT is a bipolar junction transistor, it is a three-terminal device consisting of a base, emitter,…
Q: (d) The branch current (in both polar and Cartesian forms): I= (e) The branch current (in both polar…
A:
Q: bläi 8 A D'Arsonval movement with 50 Q internal resistance and 100 mA FSD current. If you need to…
A:
Q: 3. In photoelectric effect, the kinetic energy of the emitted electrons does not depend on A. Light…
A:
Q: (c) Calculate / in the circuit below using (i) Kirchoff's law and (ii) Superposition theorem
A: The required parameters can be calculated by using the kirchhoff's laws and ohms law. The circuit…
Q: The voltage reflection coefficient I O is the amplitude of the reflected wave divided by the…
A: In this question we need to choose a correct option
Q: K Qt FFO K ot FF1 Clk
A:
Q: H 점 P
A:
Q: Problem 1(B)- If the fault in Problem 1(A) was a Line-Line fault between phases B and C through a…
A:
Q: Vs = 18020° f=60 [Hz] =0.5 (N] ; r. =50[N]=R ;L=50 [mH); C=0.22[µF] a) The type of transient…
A: Converting the circuit element in s-domain as L↔ℒsL,R↔ℒR,L↔ℒ1sC,Is↔ℒIss,vo↔ℒVos.
Q: 50Ω resistor, a 20mH coil and a 5uF capacitor are all connected in parallel across a 50V, 100Hz…
A:
- Mention six (6) applications of attenuators.
Step by step
Solved in 2 steps
- 4. Why the O.C.C. characteristic is non-linear?Which of the following sensors has a permanent magnet inside? Hall effect sensor thru-beam optical sensor piezo-electric sensor LVDT capacitive proximity sensor |o|0|0|6The electrical equivalent of mechanical load in induction machine is......................... a. Rr/s b. Rr/(1-s) c. Rr d. Rr*(1-s)/s
- To modeling separated excited DC motor by transfer function, you need to the math operation library to reach to the following blocks Gain Add Constant ProductHow do you do Routh Houritz criteria? What is a method that always works? Like how apply to below?The economic p.f. is the point at which the economic benefits of adding shunt capacitors just equal to the cost of capacitor True False
- • (a) Explain the operation of boost converter with voltage and current waveforms across the boost inductor. Assume continuous conduction. 9.What is characteristic impedance? How do you find it by measuring pulses?Find all types of power losses (the second photo shows the types of power losses) The weight of the car is 800 Kg The weight of each person is 75 Kg You may assume any missing parameters you need in the design appropriately (e.g., the rolling-resistance-power, air-resistance-power, the DC motor's parameters, ....etc)