PgageU-shaped liquid manometer is connected to a closed tank,which contains water and air. The gage pressure in the tankis Pagge = 30 kPa. The manometric fluid is mercury, withdensity pmercury = 13600 kg/m³, and the water density is Pwater1000 kg/m³. Determine the readings of the liquidmanometer (h = ?), as shown on the figure, if the specificweight of the air is neglected.AirImWaterImIm%3DhMercury

Name: PgageU-shaped liquid manometer is connected to a closed tank,which co
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: PgageU-shaped liquid manometer is connected to a closed tank,which contains water and air. The gage pressure in the tankis Pagge = 30 kPa. The manometric fluid is mercury, withdensity pmercury = 13600 kg/m³, and the water density is Pwater1000 kg/m³

Answered: Image /qna-images/answer/53d37754-3575-4057-bd94-c8c8cc05a509.jpg

Engineering

Mechanical Engineering

naped liquid manometer is connected to a closed tank, contains water and air. The gage pressure in the tank 30 kPa. The manometric fluid is mercury, with I Pmercury = 13600 kg/m³, and the water density is Pwater 0kg/m³. Determine the readings of the liquid heter (h = ?), as shown on the figure, if the specific of the air is neglected.

naped liquid manometer is connected to a closed tank, contains water and air. The gage pressure in the tank 30 kPa. The manometric fluid is mercury, with I Pmercury = 13600 kg/m³, and the water density is Pwater 0kg/m³. Determine the readings of the liquid heter (h = ?), as shown on the figure, if the specific of the air is neglected.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.121P: One side of the container has a 03-m square door that is hinged at its top edge. If the container is...

See similar textbooks

Similar questions

One side of the container has a 03-m square door that is hinged at its top edge. If the container is filled with water, determine the smallest force F that must be applied to the bottom edge of the door to keep it closed.
An inverted differential manometer is connected to two pipes A and B which convey water. The fluid in manometer is oil of SG= 0.8. For the manometer reading shown in the figure, find the pressure difference between A and B. X 30 cm 20 30 OIL OF Sp. gr. 0.8 -X
As shown in the figure, an inclined manometer is used to measure the pressure of the gas within the reservoir. The manometer fluid is mercury, which has a density of 845 Ib/ft3. The manometer fluid rises a distance d = 12 inches along the manometer tube, which is inclined e = 20° from the horizontal. The atmospheric pressure is 14.7 Ibf/in? and the acceleration of gravity is 32.2 ft/s?. Patm = 14.7 Ibf/in.? Gas reservoir g = 32.2 ft/s? a 20 in. Mercury (p = 845 Ib/ft³) Determine the gas pressure, in Ibf/in?. Express the pressure as a gage or a vacuum pressure, as appropriate, in Ibf/in2.
Q5 A U-tube manometer similar to that shown below is used to measure the gauge pressure of water (mass density p = 1000 kg /m3). If the density of mercury is 13.6 x 103 kg /m³, what will be the gauge pressure at A if h1 = 0.45 m and D is 0.7 m above BC. Wwater Wmercury
The pressure of the natural gas installation is as follows.As you can see, mercury (mercury), oil (oil) and water (water) fluidsIt is measured with a manometer. Open end of the manometer (X + 85)It is under the influence of kPa ambient pressure. The relative content of mercury and oil (relative to water)density (SG) and density of water (ρwater = 997 kg / m3) is known.Determine the absolute pressure in the installation (X=00)
The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
An air-filled, hemispherical shell is attached to the ocean floor at adepth of 10 m as shown in fig. A mercury barometer located inside the shell reads 765 mmHg (absolute pressure inside the shell)m, and a mercury u-tube manometer designedto givethe outside water pressure indicates differential reading of 735 mmHg as illusrated. Based on these data,what is the atmospheric pressure at the ocean surface for seawater (SG=1.03)
2. The gage pressure of the air in the Oil tank is measured to be 65 kPa. Find SG = 0.72 the differential height (h) of the 75 cm column. Specific gravities (SG) of Air -Water the manometer fluids are given in 30 cm -Mercury SG = 13.6 h the figure. Assume that the density of water is 1000 kg/m³.
2. The tank shown contains alcohol (SG=D0.78) and covered by a circular plug 1.2 m in diameter. Calculate the hydrostatic force F Am acting on the plug and its center of pressure. 8m 1.2 m 3. The gate as shown is 3 m normal to the page. It keeps the two liquids from mixing with each onough clocuro botween the oil and
mm and (c) the value of y in millimeters. waler 9.79 kN/m. (@) Determine the pressure pA in kPa, (b) the value of h in Thaid is prevented from moving to the top of the tank. Use unit weight of The pressure -13.4 KPa gage and pe 13.42 kPa gage. Assume the cleaning mall open cylindrical tank containing cleaning fluid (s.g.-0.8) at a height h. KAoindrical tank contains water at a height of 55 mm, as shown. Inside is a Problem 2-52 Ans: (a) 12.88; (b) 10.2; (c) 101 PA Air Water 55 mm Mercury (s.g. 13.6) Problem 2-53 mtal manometer shown is measuring the difference in pressure two RAPES. The indicating liquid is mercury (specific gravity13.6), h is 675 225 mm, and ha is 300 mm. What is the pressure differential umEthe two pipes Ans: 89.32 kPa
Consider a U-tube manometer used to measure the density Pa of liquid A, as shown below. Mercury is used as the base liquid for the manometer with density Phg = 13600kg/m³. If hng = 5mm and ha = 22.4 mm, find Pa. ha Pa U Phg hng
The pressure difference between an oil pipe and water pipe is measured by a double-fluid manometer, as shown in the figure. For the given fluid heights and specific gravities, calculate the pressure difference AP= PB - PA. The specific gravities are 13.5 for mercury, 1.26 for glycerin, and 0.88 for oil. Take the standard density of water to be pw=1000 kg/m³. The heighth of mercury in the manometer is 25 cm. Water SG=1.0 Mercury SG= 13.5 55 cm The pressure difference is Glycerin SG=1,26 10 cm 12 cm Oil SG=0.88 kPa.