O0.9 leading O 0.8 lagging

Q: click then Refresh or Reload. * Consider the circuit shown where Ip 0.4mA, and assume the diode turn...

A: The solution is given below 

Q: Coordinate Systems: Complete the following table with the correct value. Note angles (4 and 0) are i...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: Convert the decimal number -203 into a signed binary number using (1) sign-magnitude method (2) 1's ...

A: In this question,  We need to convert decimal to binary using the different different methods.  The ...

Q: 1- What does the VoH parameter of a logic IC refer to? a) The highest permissible output voltage. b)...

A: VOH  parameter of a logic IC refers to " The lowest output voltage recognized as logic 1 ".

Q: 8. The armature and shunt field resistance of a 50-kW, 220 V shunt generator is 0.026 ohm and 52 ohm...

A:

Q: Battery

A: On bread board if we move horizontally then the voltage will be different. On bread board if we move...

Q: Calculate the collector voltage for each transistor. (Hint: Capacitors are open to direct Vcc +15 V ...

A: The given circuit diagram is shown below:

Q: difference (battery) as draw the correctschematic diagram ofeach pictorial di agram. PICTORIAL DIAGR...

A:

Q: 5- Sketch the root locus diagram of a control system transfer function k(s²-2s+5) GH= (s+2)(s-0.5) i...

A: We need to find out range of K for stable system and for given damping ratio .

Q: A solenoid of length 25 cm carries a current of 10 A. If the field strength of the solenoid is 1,200...

A:

Q: A SOMA

A: The number of NAND/NOR gates required for a full adder will be 9. that is why NAND/NOR gate also cal...

Q: Example Question 1 A dynamometer-type AC ammeter made of moving coils and fixed coils with a shunt i...

A: For a dynamometer-type AC ammeter -The moving coil's resistance is,R=10ΩThe shunt resistance is,Rshu...

Q: Find the average and r.m.s value of the waveform shown below v(t), 3 2 t(sec) -2 -3 1.

A: In this question,  Voltage waveform is given.  Find the average and rms value of the voltage?  We kn...

Q: 11011.0101- 1101.0 11

A: 10 -1=1;       2-1= 1 100-001=11;      4-1=3   100-10=10     ; 4-2=2 

Q: The x-y plane separates two magnetic media: medium 1 (z> 0)with µ1 = µo and medium 2 (z < 0) withu2 ...

A:

Q: b) Obtain the Fourier series coefficient of the signal x[n] shown in Figure Q3(b). x[n] 3 4 Figure Q...

A:

Q: 4.5A 2A W- 5.6A v(D-300 con(cut) Bonus: For the circuit shown below, if the load of impedance Z has ...

A: The solution is given below

Q: Vcc R1 RC Q1 NPN +88 8 R2 RE Volts VC

A:

Q: 8. The armature and shunt field resistance of a 50-kW, 220 V shunt generator is 0.026 ohm and 52 ohm...

A: load current = load powerterminal voltage                      = 50000220                      = 227...

Q: An alternating voltage is represented by 'v' = 245 sin (134 t) volts. Find: (i) Time period (ii) Ave...

A: Given an alternate voltage is represented by, v=245 sin 314t V

Q: 30 de 60 dB/decade w (in log scale) 10 Consider the following Bode plot of a transfer function and f...

A: Brief description : In the above given question they have mentioned a bode magnitude plot of a open ...

Q: Define the unit step function find out its Laplace transform.

A:

Q: a) Explain electric drive. Draw the block diagram and explain the roles of its components.

A: Electric drive : An electric drive is a circuit which is used for controlling purpose it is used to ...

Q: n the circuit in the figure, the movement of the switch takes place at the time t= 0 for t>0 Find th...

A: Solution- Assume initially the switch 1 has been closed and switch 2 (SW2) for a long time before  t...

Q: is pluged into a slot to add features such as video,sound .,modem and networking -2 ram display card...

A: display  card used to add features such  as video, sound,  modem and networking.

Q: a) Energy conversion in electrical drive is achieved by reduction of losses in its various parts. Ex...

A: Answer -

Q: Calculate the base current IB in uA when VCC=16V, VEE=-16V , RB=9205 ohm, RC=12529ohm, RE=11879ohm ...

A:

Q: The resonance frequency wo of the circuit shown below is.. rad/s 10 mH lle 0.5 mF 102 V cos ot O 320...

A:

Q: Problem 1 Using a map, determine the Boolean expression in Product-of-Sums (POS) form of the functio...

A: In this question,  We need to determine the boolean expression in the POS form.  We know  Maxterm ce...

Q: Define the unit step function find out its Laplace transform.

A:

Q: A common bus system which is capable of transferring 2 bits at time with number of registers are 4 e...

A: Bus system- System bus included, is just a communication channel between two or more devices. There ...

Q: Arrange the following measurements in descending order: 1000 Hz, .00001 THz, 10 GHz, .01 MHz, 100000...

A:

Q: 2. Defermine the pMS Value of a semi-cirinlar currend wave nhich has a mapimum valse of a. (Nofe: th...

A:

Q: Is the thickness of an insulating material considered as the outer radius in computing the insulatio...

A: The solution is given below

Q: QUESTION 13 How many power consuming outlets may be installed on a 30 A, 120 V branch circuit in a c...

A: If power is up to 800W, Than the number of outlets will be 8 Power=30*120=360W. So, the number of ou...

Q: How does the series connection differ from the parallel connection?

A: Differences between the series connection and parallel connection.

Q: 1. If a current of 5A flows through a long wire of radius 0.002meter, what is the intensity of magne...

A: Given data: Long wire radius, r=0.002 m Current I=5 A Distance from wire R=0.04 m  

Q: An industrial plant uses two 3-phase induction motors rated at 460 V. At full load one draws 232 A a...

A: The solution is given below

Q: The primary current of a 2502,500-V rms step-up ideal transformer that delivers 80 kW to a resistive...

A:

Q: 1. An ideal 200W transformer has an input current of 2 A and an output voltage of 120 V. Determine v...

A: As per the guidelines of Bartley we supposed to answer first question only.

Q: Draw the output waveform for the zener limiting circuit. Show your analysis. 2. ANS. Will limit the ...

A:

Q: L2 Tc T K, G3 G4 H2

A: GIVEN: a block diagram FIND: reduce the block diagram using matlab code   

Q: Consider a 6 bit DIA converter with a resistance of 320 kΩ in LSB position. The converter is designe...

A: Digital to Analog converter- A “D to A Converter” or DAC translates a digital code into the correspo...

Q: V* = 10V -0.99 mS Rg = 5kn Cc eR, -0.20 ms -0.87 ms RL = I k2 -0.50 mS -0.32 mS V =-8V Consider the ...

A:

Q: 4.Find the gain vo/vs of the circuit shown below 10K O 10KO Vs Vo 20kQ

A:

Q: Calculate the required DC supply voltage VCC when RC=1813 ohms, IB=33 uA, VC=6V, R2=5425 ohms, RE=3...

A:

Q: What are the different integrated circuits and describe the characteristics of each.

A: With the avadacment of IC's , The design and development of complex circuits becomes very easy and i...

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as ...

A: Answer -

Q: Q/ The output signal from an AM modulator is: s(t) - 5cos(1800m t) 20cos (2000m t) 5cos (2200m t(a) ...

A:

Q: A 220V shunt Motor has an armature resistance of 0.062Ω and with full field has an emf of 215V at a ...

A: The armature current of the shunt motor corresponding to the full field emf and speed of 960 rpm is ...

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.