One mole of an ideal monatomic gas, initially at a pressure of 1.29 atm and a volume of 0.0152 m3 , , is heated to a final state where the pressure is 6.29 atm and the volume is 0.0552 m3 . The gas constant is 8.31447 J/mol · K . Determine the change in entropy for this

Q: Determine the force in each member of the figure shown below and state if the members are in tension…

A:

Q: Given : STEADY STATE COMPRESSOR INLET PRESSURE: IN LET VOLUMETRIC AIR 15 lb f/in² FLOW RATE GOES…

A:

Q: The circular concrete culvert rolls with an angular velocity of w = 0.58 rad/s when the man is at…

A: In this problem we will use the moment equation and the relative acceleration approach.

Q: A shell-and-tube heat exchanger operates with two shell passes and four tube passes. The shell fluid…

A: Write the given data. For ethylene glycol,Thi=140 °CTho=80 °Cm˙h=4500 kg/hch=2742 J/kg°CFor…

Q: A quantity of ideal gas is contained by a moving piston within a leak tight cylinder with initial…

A: Detailed explanation and solution of the above problem uploaded in below picture.

Q: The T-bracket is formed by welding together two cylindrical rods AB and CD. If the allowable shear…

A: Given question is related to mechanical design and mechanics.   Given data:  allowable shear stress…

Q: QUESTION 4 Calculate the head loss and the pressure drop due to fluid friction when water, with a…

A:

Q: Application of polymeric coatings to fibers can be accomplished by drawing a fiber through a bath of…

A:

Q: 1.6-5 Three pieces of wood are glued together and to rigid supports (see figure on page 44). A force…

A: Given:Force acting on the blocks, F=14 kNLength of the block, l=150 mmwidth of the blocks, w=90…

Q: Ethanol at 20°C flows at 125 U.S. gal/min through a horizontal cast-iron pipe with L=12 m and d= 8…

A: Given: V˙=125 gal/min L=12m d=0.08 m ρ = 789 kg/m3   μ = 0.0012 kg/m⋅s fMoody ≈0.0282

Q: F6-20. Determine the reactions at D. 4 m B 10 kN 3 m3 m3 -3 m m3 m3 m -3m- 15 kN Prob. F6-20 C D

A: Draw the free-body diagrams of all members AB, BC and CD.

Q: Find the volume of the propane tank. Assume IPS units, set before you begin to sketch the part.. The…

A:

Q: Q2. A compound shaft supports five pulleys that transmit different amount of torques as shown in…

A: Given: The torque at A, TA = 153 kNm The torque at B, TB = 1767 kN.m The torque at C, TC = 1394 kN.m…

Q: problem 1 1) A stream of 21,000 kg/h of steam flows steadily through of a turbine, entering at 3.5…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: - B с -6-4

A: Given,

Q: B. A substance has a total volume of 1.25 m³ and is under gravity at 9.65 m/s². m (kg) v (m³/kg) w…

A:

Q: 1.Equivalent resisitance through entire system 2.Current being drawn from battery 3.Current…

A: 1) Equivalent resistance of circuit, R=R1R2R1+R2 2) Current drawn from battery,…

Q: IN FLUID MECHANICS, THE DIVERGENCE OF VELOCITY EXPRESSES In fluid mechanics, the divergence of…

A: In fluid mechanics, the divergence of velocity expresses a volume dilatation rate.

Q: A thin film of oil, on the surface of glass , results in destructive interference. If the wavelength…

A: Given  Nair = 1 Noil = 1.45 Nglass = 1.52 Incident light = 650 nm   Using formula for destructive…

Q: 108 FLUID MECHANICS 3-48 Consider a double-fluid manometer attached to an air pipe shown in Fig.…

A: We have to determine the specific gravity of fluids 2 Specific gravity =13.55 Atmosphere pressure…

Q: Consider a mass of 500 g placed at the end of a spring with stiffness constant 100 N/m and hanging…

A:

Q: 3. (a) As shown in Figure P3(a), water flows in a rectangular channel which is 5.0 m wide. The…

A:

Q: 16.62 Two uniform cylinders, each of mass 7 kg and radius r = 125 mm. are connected by a belt as…

A:

Q: |F₁ = 200 N 30% 40° F₂ = 300 N

A: Given,

Q: A large, open-topped water tank is being filled from above by a 1.0-cm-diameter hose. The water in…

A: Given data:- Diameter of the hose =1 cm Flow rate of the water in hose =11 cm/s Diameter of the hole…

Q: 3. Two immiscible liquids A and B are in a container. A 100-g object is dropped onto the container…

A: Solution: Given Data: m=100 gVA=0.47VVB=0.53Vρ=7.6 g/cm3 V is the volume of the object.   To Find:…

Q: 2. A wire is stretched between 2 rigid posts separated by a distance L. If the surrounding…

A: In this problem, the temperature T2 is less than the temperature T1. It means the wire is cooled…

Q: Obtener el centroide de la siguiente figura. -300 mm 150 mm 150 mm 75 mm 100 mm 100 mm

A:

Q: 7-48 Water vapor enters a compressor at 35 kPa and 160°C and leaves at 300 kPa with the same…

A: Given:Pressure and temperature at compressor inlet, P1=35 kPa and T1=160°CPressure at compressor…

Q: Locate the centroid (x, y) of the area.

A:

Q: 3. Locate (calculate) the X-X and Y-Y centroidal axes for the area shown. Make sure to draw the…

A:

Q: For the beam shown below, assume that E/= 6 x 104 kN-m² is constant through the length of the beam.…

A:

Q: The spool has a mass of 150 kg and a radius of gyration of kg = 0.3 m. (Figure 1) Figure 250 mm 400…

A:

Q: Pressure difference required for pipe with elevation change. Water at 68°F is to be pumped through…

A:

Q: Draw the correct Free Body Diagram (FBD). Express/Solve the:  a. Coordinate direction angles (α, β,…

A:

Q: The 520-lb beam is supported at A and B when it is subjected to a force of P = 1000 lb as shown.…

A:

Q: Two spheres look identical and have the same mass. However, one is hollow and the other is solid.…

A: Given: Two spheres look identical and have the same mass. However, one is hollow and the other is…

Q: A steady-state system for producing power consist of a pump, heat exchanger and a turbine. Water at…

A:

Q: A domestic refrigerator with a 2.2 copper remove heat from the refrigerated space to A rate of 75…

A: Given Data- COP=2.2 Heat remove from refrigerated space = 75 kj/min We have to find all three points

Q: 3) Describe in words and with a sketch a process that is consistent with the qualitative work-energy…

A:

Q: A wire made from Material Y has a 3 millimeter [mm] diameter and is 1.25 feet [ft] long. A stress…

A: Given data:- A wire made from Material Y  Diameter of a wire = 3 millimeter [mm]   length of the…

Q: 15. A brass condenser tube 1.0 in. in diameter and 4 ft long has a wall thickness of 0.065 in. What…

A: Given:  d = 1 in L = 4 ft = 48 in  t = 0.065 in Apparent factor of safety = 10 Collapsing pressure =…

Q: 26 KN 13 12

A: Given,

Q: 3-50/Consider the system shown in Fig. P3-50. If a change of 0.7 kPa in the pressure of air causes…

A: Given Specific gravity of mercury SGhg=13.56 and Specific gravity of brine SGbr=1.1 Write the static…

Q: Ideal vapor-compression refrigeration cycle functions at steady state. Working fluid is Refrigerant…

A:

Q: Q.4: A shaft subjected to tensile load has stress-strain curve is define by 125+185 01 find the…

A:

Q: The 8-kg pendulum is released from rest at A. Initially, the pendulum swings about O, but after the…

A:

Q: Determine the forces in members BG, CG, and EG of this truss. The horizontal members are all 4 m…

A:

Q: A horizontal boom is used to support the sign of a coffee shop. The boom itself is supported by a…

A: Given: complete the force diagram by ensuring properly labeling and all forces have been included.

Q: Determine the magnitude of the vector difference V' = V₂ - V₁ and the angle 0x which V' makes with…

A: Givena=2b=3V1=10V2=14θ=55o

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.