Pap smears are a diagnostic test used to detect cervical cancer. Although the test has high specificity, it also has low sensitivity.  As a result, women have to be screened often.  Using the definitions of sensitivity and specificity, explain why increased frequency of screening is needed when sensitivity is low and specificity is high.

Q: What is the difference between prevalence and incidence? Over time, how are the measures of…

A: The Main difference between Prevalence and Incidence is defined as follows  Prevalence measures or…

Q: Over the past few decades, public health officials have examined the link between weight concerns…

A: To examine the link between weight concerns and teen girls' smoking, the  public health…

Q: What do you need to look for in bivariate screening (for each categorical and quantative variables)?

A: Solution:Bivariate analysis helps to determine the relationship of two variables. The possible…

Q: A simple main effect test is appropriate for analyzing which significant result?

A: Simple Effects : is appropriate for analyzing a significant interaction, follow-up tests are…

Q: Which data-collection methods are dominant in quantitative research? Select all that apply.

A: # Quantitative research:Quantitative research is the process of collecting and analyzing numerical…

Q: nen testing for differences between treatment means, the degrees of freedom for the t-statistic are

A: In ANOVA while testing the difference between the treatment means the degrees of freedom for the…

Q: Why is the response rate an important consideration in survey? And give some examples to…

A: If response rate is low, results may notdemonstrate the population as well as if response rate was…

Q: A medical journal reported on an experiment intended to see if a certain drug could be used as a…

A: Since you have posted a question with multiple sub-parts, we will solve the first 3 sub-parts for…

Q: What type of test would be ap are different from the average

A: From given data we have : sample size = 25 standard deviation = 5

Q: How to interpret the result according to the above data?

A: Decision Rule: Reject H0 if p value less than or equal to α. Let us consider, α=0.05. From the given…

Q: A consumer organization was concerned about the differences between the advertised sizes of…

A: For the given data Perform Anova single factor and select the correct choice

Q: give one disadvantage of using experience sampling and one advantage of using correlational methods…

A: Disadvantage of using experience sampling Despite the strengths and promise of this method, there…

Q: Does training in stress reduction make a difference for student success?  15 students received…

A: Given Information: Sample 1: Sample size n1=15 Sample mean M1=88 Sum of squares SS1=400 Sample 2:…

Q: Suppose we want to use systolic blood pressure to predict diastolic blood pressure. The explanatory…

A: Solution

Q: Is the test statistic in the rejection region? how do you know ?

A:

Q: You are asked to design a study to investigate the effectiveness of the Atkins diet (IV = diet, DV =…

A:

Q: the manufacturer's Web site to diagnose a printer failure, what is the most likely cause of the…

A:

Q: Did the authors note any differences in gender with regard to fish consumption and inflammatory…

A: HI, as per our policy, we'll answer the first three subparts for you.  Given:

Q: In a recent study conducted by Pulse Measurement Asia, their results show that a higher percentage…

A: Here, for this researcher, there would be two factors for males and females both, the pulse rate of…

Q: What is the explanatory variable ?

A: What is the explanatory variable ?

Q: Are the statistical techniques used in the analysis of data appropriate to the levels of measurement…

A: Statistics               Statistics is widely used to gathering the different datasets,…

Q: A survey was conducted to determine whether age affects the level of development-orientedness of…

A:

Q: What is the most appropriate test to determine if the three feed additives resulted to different…

A: a. Given claim: the three feed additives resulted to different mean cortisol level of chickens. That…

Q: How might measurement and design errors affect respondent errors?

A: Design errors can lead to non response errors as the respondent is not sure how to answer a question…

Q: A clinical trial is planned to compare an experimental medication designed to lower blood pressure…

A: Null Hypothesis: H0: There is no significant difference in mean blood pressure at baseline and after…

Q: State one possible advantage of using paired samples instead of independent samples.

A: Provide the possible advantage of using paired samples instead of using independent…

Q: What are the response variables and explanatory variables for observing vehicles to see what the…

A: In theory of statistics, response variable is a the dependent variable, where the variation of the…

Q: data has extreme scores, what is the best measure of average?

A: The mean is the average value of the data set. It is calculated by summing up all the observations…

Q: how would you collect data with people in this time of pandemic?

A: Plan ahead for different COVID scenarios, and draft a budget that assumes the worst. Recruit an…

Q: The general rational behind using Post hoc test ? Explain why using an ANOVA naturally leads to the…

A: ANOVA is the generalization of the t-tests. We use the t-tests for checking the significant…

Q: What is the predicted response value? y =

A: Given Regression Equation : and,

Q: What is the predicted explanatory value? X =

A: The regression equation is y=-3.546x-4.393.

Q: As part of a study to determine the effects of a certain oral contraceptive on weight gain, 12…

A:

Q: What type of test would best fit this problem?

A: Given

Q: Rebecca is investigating if height has any effect on red blood cell count. What is the response…

A:

Q: In a 70 item test, Chloe got a score of 50 which is the third quartile. What does it mean?

A: We know that their are 75% data points are lies below the third quartile.

Q: A measure of total variation in the observed values of the response variable is the ______. The…

A: Coefficient of determination: The coefficient of determination (R) is the percentage of the total…

Q: What type of data would you use for collecting data on lap swim time

A: Continuous Data represents measurements and therefore their values can’t be counted but they can be…

Q: What is the sensitivity of this test? What is the specificity of this test?

A: In the given table, False positive(FP) = 18 True positive(TP) = 43 False negative(FN) = 0 True…

Q: As an occupational health epidemiologist you are required to measure the effect of stress on the…

A: Given: The stress is measured based on the workers. Two different tests previously developed to…

Q: What is the most appropriate test to determine if the three feed additives resulted to different…

A: Test is that whether the three feed additives resulted to different mean cortisol level of chickens.

Q: How many students use RStudio only for data analysis? How many students use at least two software…

A:

Q: I am testing whether a new group study technique improves PSYC 214 students’ final exam grades. In…

A: type 1 and type II error

Q: How Panel Data is useful to control some types of omitted variables without actually oberving them?

A:

Q: Why are post hoc tests performed?

A: Analysis of variance test is used to analyse the significant difference among the group means in the…

Q: What is the difference between a between-subjects design and a within-subject design? Which t-test…

A: In between-subjects or between-groups study design, different people test each condition, so that…

Q: You are studying type 2 diabetes. You observe that 130 out of 200 diabetics had taken selenium…

A: Case control Study: A study which can be used for comparing two groups of participants. Here, one…

Q: What is the primary weakness of sensitivityanalysis? What is its primary usefulness?

A: Weaknesses of sensitivity analysis It assumes that changes to variables can be made independently,…