Prob.19. Find the load impedance Zz so that maximum power can be transferred to it in the circuit as shown in fig. 2.72. Also calculate the transfer power. V = 1020° j5 2 -j5 nZL Fig. 2.72

Q: If you want a characteristic RL time constant of 1.00 s, and you have a 500 Ω resistor, what value…

A: Given: t =1 s R =500 ohm

Q: A balanced three - phase, three - wire abc system has delta - connected load witha 50 Q resistor, a…

A:

Q: Show that the two expressions for inductance given by have the same units.

A: Given:  Inductance

Q: can someone please explain to me how a dynamic microphone involves magnetic flux and faradays law in…

A: Dynamic microphone

Q: Consider an LC circuit in which L = 520 mH and C = 0.128 µF. (a) What is the resonance frequency w,?…

A: L = 0.52 H   C = 0.128 micro farad

Q: An ideal air-core solenoid has a length of 6.5 cm, area of 2 c and 3000 turns. Find the…

A: Length , l = 6.5 cm = 6.5 x 10-2 m Area , A = 2 cm2 = 2 x 10-4 m2  Number of turns , N = 3000 turns…

Q: Find the inductance of an RL circuit if the resistance is 0.5?and the current increases to ¼ of tis…

A: resistance (R) = 0.5 ohm Time (t) = 1.5 seconds Current = Imax4

Q: A simple RL circuit includes a 0.125-H inductor. If the circuit isto have a characteristic time of…

A: The expression for the characteristic time of RL circuit is τ=LR Here, R is the resistance of the…

Q: If the Maximum value for the sinusoidal waveform is 200V, the voltage peak to peak will be O 400V O…

A:

Q: A series RLC circuit has resistance R = 12.0 Ω, inductive reactanceXL = 30.0 Ω, and capacitive…

A: Part A:

Q: Given that fora series LCR circuit the equation is RdV LCV V 0 /P L dt If a similar equation is to…

A:

Q: An oscillating LC circuit, with L = 1.5 mH and C = 0.01 µF, stores a maximum energy of 10 uJ. al…

A:

Q: A 1.7 kg body oscillates in SHM on a spring that, when extended 2.4 mm from its equilibrium…

A: Write the expression for the angular frequency of oscillation.

Q: A lab tech observes that the current in a coil of conducting wire goes from i, At = 0.200 s.…

A: By general definition the voltage in in an inductor is defined as E = L di/dt  .L = Inductance di =…

Q: the phase between the current and EMF converge to as f>> fo, where fo is the resonant frequency?

A:

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 N resistor, what value…

A:

Q: A fully-charged capacitor with C = 1137F is connected in series with a resistor (w/ R = 867N) and an…

A:

Q: * Prove that acceleration equals 4pi^rF^2...where F is frequency.

A:

Q: 0 Find the voltage vo(t) in the circuit of Fig. by means of the Laplace transform. 1Ω 10u(t) A 0.5 F…

A:

Q: What inductance must be conneded to Itpt capacitor r capable g getlereting 620mm Gie. Visible)…

A: The speed of the light is c = 3x108 m/s. The wavelength of the light is λ=620 nm=620×10-9 m. The…

Q: QI-A) A sinusoidal vohage v,(t) = 20 sin wtis passed through half wavarectifier. Find 1) The period…

A:

Q: Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.

A: From Ampere’s law

Q: The alternating current having a sinusoidal wave shape has a maximum value of 38.3 amp. What is the…

A: Maximum value of current = 38.3 A

Q: An ideal air-core solenoid has a lngth of 6.5cm, area of 2cm^2 and 3000 turns. Find the…

A: The self-inductance of the given solenoid is  Ls=μ0N2Al=4π×10-7 T·m/A300022 cm210-4 m 1 cm26.5…

Q: Show that ε and dΦm /dt have the same units.

A: Emf ε is the energy per unit charge. ε=Eq Here, E is the energy and q is the charge. The dimensional…

Q: In the Maxwell bridge shown in Figure2, let the fixed-value bridge components have the following…

A:

Q: Estimate the phase shift between the below two sinusoidal signals in degrees 10 as 00 05 10 000 0005…

A: The equation of first wave: V= A cosω t The equation of second wave: V=A cos( ω t +ϕ) from graph:…

Q: For what absolute value of the phase angle does a source deliver 74 % of the maximum possible power…

A: The expression for the phase angle is,

Q: A large water main is 2.50 m in diameter and the average water velocity is 6.00 m/s. Find the Hall…

A: Given, a large water main is l=2.50 m in diameter and the average water velocity is v=6.00 m/s. To…

Q: A sinusoidal signal has a 580.59 V peak to peak amplitude. What is its RMS value, to 3 significant…

A: Given,

Q: What inductance must be connected to a 20 pF capacitor in an oscillator capable of generating 590 nm…

A:

Q: If the peak value of a 1.5-kHz audio oscillator is 25V, what is the instantaneous voltage when ϴ =…

A: ϴ = 215 degree Vmax=25 V

Q: An electric generator produces an alternating voltage given by AV = NBAwsin(wt). What is meant by…

A:

Q: It is desired to tune the natural frequency of an LC circuit to match the 91.3-MHz broadcastsignal…

A: To determine: The inductance required to tune the natural frequency of an LC circuit in FM radio…

Q: Electrical oscillations are initiated in a series circuit containing a capacitance C, inductance L,…

A:

Q: Suppose that a rectangular toroid has 2000 windingsand a self-inductance of 0.040 H. If h = 0.10 m ,…

A: Given Data: The number of winding is, N = 2000. The self inductance is, L=0.040 H. The height is, h…

Q: A 2.8 kg body oscillates in SHM on a spring that, when extended 5.4 mm from its equilibrium…

A:

Q: A 0.50 kg body oscillates in SHM on a spring that, when extended 2.0 mm from its equilibrium…

A:

Q: Why, in practice, a fully charged capacitor and inductor will dissipate its energy?

A: In this question we have to answer why in a fully charged capacitor and inductor energy is…

Q: If you want a characteristic RL time constant of 1.20 s, and you have a 490 2 resistor, what value…

A: The time constant for an RL circuit is defined by τ=LR. L is the self-inductance of the inductor and…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.