Q/ Air is to be bubbled through the solution in the reactor CSTR, in order to strip out of the solution trace amounts of a solvent that have contaminated the water. The rate of loss of the solvent from the solution can be characterized by the equation r = -0.03/min c , where c is the solvent concentration. What fraction of the solvent will be removed from the water as it passes through the reactor with residence time is 26.4 min.

Q/ Air is to be bubbled through the solution in the reactor CSTR, in order to strip out of the solution trace amounts of a solvent that have contaminated the water. The rate of loss of the solvent from the solution can be characterized by the equation r = -0.03/min c , where c is the solvent concentration. What fraction of the solvent will be removed from the water as it passes through the reactor with residence time is 26.4 min.

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter34: Indoor Air Quality

Section: Chapter Questions

Problem 4RQ: Three different biological contaminants are ______, and _______.

See similar textbooks

Similar questions

Q1: A) : Oxygen (A) is diffusing through nondiffusing carbon monoxide(B) .The total pressure is 1*105 N/m2 and the temperature 298 k. The partial pressure of oxygen at two phases 3.0 mm apart is respectively 12000 and 7500 N/m?. The diffusivity of the mixture is 1.78 *10 5 m?/s. Calculate the rate of diffusion of oxygen in kmol/s through each square meter of the two planes. IR I. Resaleul f.ucion f oxugon (Al through
For the diffusion coefficient K = 0, the above equation becomes: If known: The flow velocity is constant, U = 0.5 m/s Channel length 1000m Δx = 100m Δt = 1000 sec When t = 0, the concentration along the channel is zero [C(C,0) = 0] The boundary conditions along upstream & downstream are 2 & 0 respectively Calculate the above equation using the concentration C(x,t) & carry out until Time step k-5 with scheme: a. Explicit b. Implicit
Soooolve
a) Assuming the effluent from the pulp and paper plant has a daily discharge of 15 m3/s, calculate the daily loading values for TSS and BOD5. (Remember: Loading (kg/day) = Q (m3/s) x concentration (mg/L)) **don’t forget your unit conversions and show your work if you can Assume a BOD5 concentration of 10 mg/L, and a TSS of 20 mg/L.
Q6: The diffusion coefficients for carbon in nickel are given at two temperatures, as follows: T(°C) D (m/s) 5.5x10 14 3.9x10 13 600 700 a) Determine the values of De and the activation energy Q. b) What is the magnitude of D at 850 °C?
A steam trap is a device to purge steam condensate from a system without venting uncondensed steam. In one of the crudest trap types, the condensate collects and raises a float attached to a drain plug. Whenthe float reaches a certain level, it “pulls the plug,” opening the drain valve and allowing the liquid to discharge. The float then drops down to its original position and the valve closes, preventing uncondensed steam from escaping.(a) Suppose saturated steam at 25 bar is used to heat 100 kg/min of an oil from 135°C to 185°C. Heat must be transferred to the oil at a rate of 1:00 x 10 4 kJ/min to accomplish this task. The steam condenses on the exterior of a bundle of tubes through which the oil is flowing. Condensate collectsin the bottom of the exchanger and exits through a steam trap set to discharge when 1200 g of liquid is collected. How often does the trap discharge?(b) Especially when periodic maintenance checks are not performed, steam traps often fail to close completely…
The concentration of salt ? g/L in homemade soap is given as a function of time as follows: ??/dt = (0.37? − 0.03)? At the initial time, ? = 0 minute, the salt concentration is 20 g/L. Choose a step size in a range of 1 < h ≤ 1.5 minutes for the interval from 0 to 8h minutes and apply THREE (3) numerical methods to compute the salt concentration. Select the best numerical method to estimate the salt concentration and justify your answer. method 1: ruler's method
A river has a flowrate of 3 m3/s. A stream discharges into the river at a flowrate of 0.05 m3/s. A tracer is added to the stream for research purposes. Determine the minimum concentration of tracer in mg/L that must be achieved in the stream so that 1.0 mg/L of tracer can be measured after the river and stream mix (downstream)? What mass rate in kg/d of tracer must be added to the stream? (Assume complete-mix reactor).
A river section shown has an initial volume of 600m with 750g of phosphorus. The discharge from the upstream is 100 carrying 2g of phosphorus per cubic meter. A small factory releases their treated wastewater to the river at 20- with 1.5g of phosphorus per cubic meter. The discharge at the downstream side is 120 Assume that the river mixture is uniform for the given section. day day day a) Determine the equation for the mass of phosphorus in the river section at any time, m(t). b) How many days will it take for the phosphorus concentration in the river section to be 1.75 ?
FOLLOW THESE STEPS FOR UPVOTE Given Required Diagram Solution Conclusion Do not round off while solving. Question: To compensate the possibility of bursting in a 300,000 Li tank containing octane initially at 25°C, it was integrated by a movable roof that allows the expansion of the gas inside. If the designed temperature of the tank during the operation varies between 15°C and 50°C and the diameter of roof is 5000 mm, determine the displacement (millimeters) of the roof during the minimum and maximum operating temperature assume that the pressure remains constant at atmospheric value for safety reason.
Psychrometric process A room has dimensions of approximately 10m x 10m x 3m. Assume the air inside the room to be at T= 20 oC, P = 100 kPa, Relative Humidity = 50% a. If all of the water vapor in the air of the room could be converted to liquid at the same temperature, what is the volume of the liquid (mL)? b. If the room temperature were slowly cooled without changing the composition of air, at what temperature would you expect to see condensation occurring (oC)?
Combustion of a fuel sampie in a bomb calorimeter increases the temperature of the entire system by 5.10 °C if the calorimeter contains 1500 g of water, but only by 4.00 "Cif the calorimeter contains 1950g of water. What is the heat capacity of the dry bomb calorimeter assembly? Assume that the specific heat capacity of water is 4.18 J A. 570 J "C- B. 912 J "C-1 C. 722 J "C- D. 366 J "C-1 E. 494 J "C-