Q. 1 (a). For a given solar cell, the obtained current and voltage values with respect to loadresistance in the circuit (as shown in the figure) are tabulated below. Distance betweenthe solar cell and the light source is 11 cm. Calculate the efficiency for the given solarcell?Kindy hedle te t w pdraChtie er he utity g 00CurrentVoltage(V)SOLAR CELL C t elar tety ef"APPARATUSLoadresistance(mA)(Ohm)1510480.55The reaperint ry t deta22430.7533351.2FesitanceMeter47301.4Hater68201.5150101.6470041.65

Answered: Image /qna-images/answer/8883ff43-459e-4f89-b203-0bc1a5d54f80.jpg

Q. 1 (a). For a given solar cell, the obtained current and voltage values with respect to load resistance in the circuit (as shown in the figure) are tabulated below. Distance between the solar cell and the light source is 11 cm. Calculate the efficiency for the given solar cell? Load Voltage (V) ight() SOLAR CELL C "APPARATUS Current resistance (mA) (Ohm) Arat the er 10 48 0.55 22 43 0.75 33 35 1.2 47 30 1.4 68 20 1.5 150 10 1.6 470 04 1.65

Q. 1 (a). For a given solar cell, the obtained current and voltage values with respect to load resistance in the circuit (as shown in the figure) are tabulated below. Distance between the solar cell and the light source is 11 cm. Calculate the efficiency for the given solar cell? Load Voltage (V) ight() SOLAR CELL C "APPARATUS Current resistance (mA) (Ohm) Arat the er 10 48 0.55 22 43 0.75 33 35 1.2 47 30 1.4 68 20 1.5 150 10 1.6 470 04 1.65

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Similar questions

20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ
2. Fifty identical photovoltaic cells are connected in series. Every solar cell has a light generated current of 5.0 Amperes at 25 degrees Celsius. With a dark saturation current of 9 x 10-10 Amperes, a parallel resistance of 8.0 Ohms and a series resistance of 0.008 Ohms. Calculate for the current, voltage, and power delivered when the pn voltage of each cell is rate at 0.6 Volts.
A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
Determine the current flowing through Resistor R1 (111160)
Convert following number in the given radix system.(a) (1010.011)2 to (…………)10(b) (0.513)10 to (……….)8
Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a) Exciting current (ii) Ic (b) Magnetizing Current (iii) Ie (c) core loss current
An ac resistance is higher than a dc resistance. True False
Figure (El1) 12- For the electric circuit shown in the figure (E12), determine the value unar of (R) if the current trough the branch AB is zero and the total current is 1A. Note that all the values of resistors are in ohm. 1.5 B. R 10V Figure (E12) d by
A wire carries a current, ? = 3 cos 314? ?. What is the average current over 6 seconds?a. 0.0016 A b. 0.0019 A c. 0.0020 A d. 0.0024 A
Why Pout will not increase bu 75% So why we did not use (1+0.75)(S)Pf and only we use 0.75(s)(pf) why we did not increase it ?
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
2. For the characteristics below. Determine the ff: a. ac resistance at l,=2mA. b. ac resistance at I,=25 mA c. Compare the results of part (a) and (b) to the dc resistances at each current level. Ip(mA) 30 25 20- 15- 10- 2 Ala 0.1 0.2 0.3 0.4 0.5 0.6 0.7 08 0.9 Vo(V) AV