Answered: Q3 Using superposition, determine the…

Q3 Using superposition, determine the current through the inductance XL for each network in Figure below? R W # 40 89 E₁ = 10V 20 E₁₂ = 40 V / 60° 60

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: NOR Inputs . 0 1 0 1 1 0 А ADO-O B NAND A ㄷ XOR Logial Operations Output X-AVN 1 0 Truth Table INPUT…

Q: Q2. Aşağıdaki devrede akım ve gerilimi değerlerini bulunuz ve yandaki tabloya yazınız. Çözüm için…

A: We need to find out the current and voltage for given circuit

Q: A 1000-turn coil is wrapped around a magnetic core, with a current of 2.5 amperes. If the total core…

A: We need to find out the flux

Q: 1 Utilizing the Routh-Hurwitz criterion, determine the stability of the following polynomials: (a)…

A: Given the characteristic equations,to determine the stability of the polynomials using RH CRITERION.

Q: 7) A linear spring has a spring constant of 20 N/m. How far would it have to be stretched to have a…

A: We need to select correct option for given spring energy

Q: The voltage-flux adjustment of a certain single phase 220 V induction watthour meter is altered so…

A: Given: Supply voltage, V = 220 V The meter is altered so that phase angle between flux and applied…

Q: 5 Consider the power system shown in Fig. 11.90. Calculate: (a) the total complex power (b) the…

Q: A multitap transformer has 100 turns on the primary, 100 turns between B and C, 1000 turns between A…

A: Given: Primary turns, N1=100 Turns between BC, NBC=100 Turns between AD, NAD=1000 Turns between AC,…

Q: An amplifier with 20dB gain is connected to another with 10dB gain by means of a transmission line…

Q: Assuming that a 4-bit ADC channel accepts analog input ranging from 0 to 5 volts, determine the…

A: NOTE:as per our company guidelines we are supposed to answer only first 3️sub-parts. Kindly repost…

Q: Calculate V2, applying nodal analysis

A: It is given that:

Q: How: For the fixed bias BJT circuit B = VCEIC, RL=82 and UCC = 24 U; determine the maximum Powe Ans:…

A: Given, Vcc = 24 volts RL = 8 ohm

Q: Find the Fourier Transform of the following. A. (t)=4e-²t+2u(t-1)

Q: Vs +1 + R VR IR + VL + LV- IL I. C

Q: The two plates are connected across a 12 V battery of a two flat metallic plates are 0.5 centimeter…

A: given circuit of capacitor

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

A: Given

Q: using ideal elements calculate the steady state levels of I1, I2, I3, V1, V2, V3

Q: A 50 HP, 440 V, 3 Phase, 60 Hz, 6 Pole squirrel cage induction motor is operating at full load and…

Q: EXAMPLE (1):-by using Maxwell current method find the currents (11,12,13) in for the circuit in Fig.…

Q: Find the voltage Vo(w) in the circuit below. Let Vs = 8 V. - +20 Ht 252 IF €122 0.5H Ks +

A: Given circuit :

Q: A medium-rise building with inductive loads has an average consumption of 40 kW and 26 KVAR. At the…

A: In this question we need to find average current , effective impedance and surcharge

Q: (a) Minimise the following Boolean expressions using Boolean algebra or Karnaugh maps, and draw the…

A: a) To minimise the given Boolean expressions using Boolean algebra or karnaugh maps And also draw…

Q: EXAMPLE (2):- If (100 j) of energy consumed during (5 second) what is value of the power will…

A: According to unit dimension, 1 joule = 1 watt-sec Energy = 100 Joules Time = 5 sec

Q: 210⁰ and Ic=980 cis - 60°. Find the negative sequence of phase B current. 11. The phase B current of…

A: In this question we need to find a current in line B

Q: Q3:- Calculate the frequency of the output F2. TFF F-8 KHz CK TFF CK F2

A: Given the asynchronous T-flipflop. Input clock frequency=8KHz. The output frequency is,

Q: Stery readings, calculate the complex impedance of the mystery component. Where X and Y are the last…

Q: What maximum voltage can be connected across a 0.5 W, 270 2 resistor without exceeding the rated…

A: Given: Power rating, P = 0.5 W Resistance, R = 270 Ω

Q: If the magnetic flux through each turn of the coil consisting of 200 turns is (t²-3t) milli-Webers,…

A: Given, A coil consisting of, Flux, φ=t2-3t mWb Number of turns, N = 200 Time, t = 4 sec

Q: Vs +1 + R M VR IR + VL L V + C I. IL Consider the RLC circuit shown. The sinusoidal voltage source…

Q: In a BJT common emitter configuration,

A: BJT (bipolar junction transistor)A transistor having a three terminal made up of semiconductor…

Q: 1. Reduce the network below to the smallest possible number of components if each inductor is 1 nH…

A: Given here electrical network and asked to reduce the network to the possible combinations.

Q: Let R₁ = R3 = 4 *2.101 Consider the difference amplifier circuit in Fig. 2.16. 10 ks and R₂ = R₁ = 1…

Q: resonace

A: Resonance frequency- The frequency at which inductive reactance is equal to capacitive reactance it…

Q: 2. Simplify the Boolean function F = ((XY + XYZ) + X(Y+ XY))?

Q: Determine the Fourier transform of the following: a. sgn(t) b. eat c. sin wot d. cos wo t e. theat

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: Q1 Calculate I₁ and 12 in the two-port of Figure? 2/30° V 292 211=692 Z12=-j42 221=-j4Q2 222=892 V₂

Q: 1. Solve for the current in the 4-Ohm resistor by using a) Superposition b) Thevenin's Law 10 Ω 18…

A: In superposition theorem,we deactivate all the sources keeping only one source active at a time. In…

Q: If a = 0.98, Ico= 6 μA, & lg = 100 µA for a transistor, then the value of lc will be (1.) 2.3 mA…

Q: (b) Find the state transition matrix for the digital system given by X (k+1)= [13]x (k)

A: Given A digital system represented in Matrix,we need to determine the state transition matrix.…

Q: Q4. a) Figure 4 depicts a simple DC motor, its armature winding consisting of a single turn of…

A: A DC motor is a Electric device which converts the electrical energy into physical motion. The…

Q: Cascading of transformers to generate the high voltage AC then a. Both stages of the primaries of…

A: When very high voltage are applied across the insulator the dielectric strength of the insulator…

Q: Answer the 4th question about the minimum VAR at the bottom only. Thank you.

A: In this question we need to find minimum KVAR the capacitor should produce so that surcharge is 0%

Q: 2. Solve for: a) Iab, b) Icb, c) Ibd by Maxwell's mesh equation. ডা

Q: Q1: A. a lossless transmission line, with a length of 0.22, has an equivalent inductance 2500 time…

Q: Prove the equation shown below: R + vi (t) RE www C + vo(t) R₁ Output offset voltage Vo = Vos (1 +…

A: Offset voltage voltage occurs in op Amp due to mismatch in input terminal resistance Offset output…

Q: Your aunt living in the USA sent an appliance that has impedance equal to 10 + j3 22 at 60 Hz. She…

A: We use method A to solve this question

Q: For this problem, please use the figure below. For the magnetic core, the mean length is 50 cm,…

A: Given information, The mean length of the core Lc=50 cm. Cross sectional area of the core Ac=5 cm2.…

Q: Vs +1 + R www VR IR + VL LV. + C I. IL Consider the RLC circuit shown. The sinusoidal voltage source…

Q: 3. Find the line currents and the real power absorbed by the load. Caution: There is no neutral wire…

A: Solution - The given circuit diagram is shown below,

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Q3 Using superposition, determine the current through the inductance XL for each network in
Figure below?
R
W
H6
80
E₁ = 10 V 200
E₂ = 40 V / 60°
40
ell
360

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a phase to ground c. none of the answers O d. Between phases
QUESTION 9 E-06, PC-02. Three inductors 5 mH, 15 mH and 25 mH are connected in series. What is the total inductance? 5 mH. 45mH. Without knowing the coupling factor the total inductance cannot be found. QUESTION 10 E-06, PC-05. An inductor is said to be saturated when? The current through it is zero. The current is at a maximum. It will no longer accept lines of flux.
Please show your detailed solution Number 14 The current in a series inductive circuit is 7.5 A at 25 Hz. The circuit takes 425 W, and the power factor is 0.47. The resistance of the circuit is A. 7.32 ohms C. 7.98 ohms B. 7.86 ohms D. 7.56 ohms
Calibri (Body) -11 by AaBbCcDx AaBbCcD AaBbC AaBbCc AaB AaBbCc. mat Painter BIU 1Normal 1No Spaci. Heading 1 Heading 2 Title Subtitle Chang Styles d Font Paragraph Styles IMPEDANCE QUIZ # 2 1. What capacitance when connected in series with a 500Q resistor will limit the current drawn from a 48-mV 465-kHz source to 20µA? * a. 144pF b. 145pF c. 146pF d. 147pF MY ANSWER: c.146pF 2. What is the total impedance at 20kHz of a series circuit consisting of a 1.5mH inductance, a 100Q resistance, and a 0.08uF capacitance? * a. 1340 41.7 b. 1930 L-37.2" C. 920 290 d. 530 2-12.6°
By convention, the sign of reactive power to an inductance is and the sign of reactive power to a capacitance is
Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH cele rele Figure Q4 rele celer L3 6.6 mH L4 2.8 mH reler L5 7 mH
4. Using superposition, determine the current through the inductance X₁ for each network in Figures below? 1₂ Xc150 03 A2 60° 801 E = 10Y Z OF
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. How many degrees out of phase are the current and voltage?
Capacitance is ___ proportional with A and ___ proportional with d. directly, indirectly directly, directly indirectly, indirectly indirectly, directly
Q4. Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If L5 is replaced with a capacitor of 0.5 mF, how would it affect the branch current? The alternating Voltage source has an amplitude of 20 Vm. Vm Sine 50 Hz L1 5 mH L2 3 mH Figure Q4 reee L3 6.6 mH L4 2.8 mH rele L5 7 mH