QUESTION 7 An old divided 6-lane (3 lanes each direction) highway has 11 ft lanes and obstructions leaving no more than 2 ft of clearance on each side of the roadway. There are no driveways or intersections on the segment of interest. Given a posted speed limit of 50 mph, estimate the FFS (mph) for the 3 northbound lanes? Provide the answer to the nearest tenths.
Q: 2. A compound curve connects the first, middle, and last tangents with azimuths 172°, 190⁰, 202°…
A: Data given Find: (a) Station of PCC (b) Total length of compound curve (c) Station PT
Q: The assembly consists of two 10-mm diameter red brass C83400 copper rods AB and CD, a 15- mm…
A: Given data : To Find :
Q: 6-69. Determine the reactions at supports A and B. Prob. 6-69 A 500 lb/ft C 700 lb/ft D 9 ft B 6 ft…
A:
Q: 1.56 2.56 y -26 -26 26 b -36 26
A:
Q: Given the loaded arch shown below, assume A, B, and C are pin connections, determine the ollowing:…
A:
Q: The lower ends of the three bars in Fig. are at the same level before the uniform rigid block…
A: Given : Weight of rigid block = 40 kips Length of steel bar = 3ft area = 1 in.2 ( Steel) E = 29 X…
Q: not
A:
Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…
A: Given Discharge = 0.15 cumec Efficiency = 80% Height difference = 197.3- 50 = 147.3 m To calculate…
Q: 4. Determine the force in each member of the loaded truss shown using methods of joints. B 3 m 4 m F…
A:
Q: A 300 N force P is applied at point A of the bell crank shown. c) What force F can counteract the…
A: Given data in question Force 300 N Angle 30°,40° & 48° Dimensions 200 and 120 mm To find out…
Q: What's the influencing factors should be considered when we want to decide the wind pressure…
A: Solution: Wind Pressure distribution is one of the factors to be considered during the design of the…
Q: Pick a simple movement you perform everyday such as, sitting in a chair, drinking from a glass, etc.…
A: When you sit in a chair, the gluteus muscles in your buttocks contract, which extends your hips, and…
Q: Problem-soil. A concentrated load of 2000kN is applied at the ground surface. What is the vertical…
A: Given data: A concentrated load, Q = 2000 kN The point directly below the load, z = 6 m
Q: Determine all the forces that reacted in the beam. Draw the shear, moment, elastic curve, and axle…
A:
Q: Make a brief introduction of the process of along-wind analysis in the frequency domain.
A: One of the strong gusts that damage transmission towers is known as a downburst. Currently, the…
Q: - he center of the 200-lb wheel with kg = 4 in. is released from st at the position shown. Find the…
A: According to the conservation of energy, the total energy of an isolated system remains constant…
Q: 2-A grass-lined trapezoidal channel has bottom width of 12.2m with 4H:1V Side slopes. The channel…
A: Given data:- The given grass lined trapezoidal channel has a width is, 12.2 m The given side slope…
Q: Given the data below about the Axial Strain (%) vs Deviator Stress: Axial Strain (%), X Deviator…
A: Axial strain vs deviator stress curve data set is given. Lagrange interpolation is used to get any…
Q: Homework: Determine the forces in all members for the truss shown below. 5 KN A 10 KN 3m B E 20 KN…
A:
Q: If the allowable bending stresses for a beam in one application is 6 kip/in2 in tension. The…
A: Given data in question Bending stress 6 kip/in2 Cross section stem 1 in by 8 in Cross section base…
Q: Given the Bank of Level A of arbitrary elevation 18.52 m, it is required to determine the elevation…
A: Answer We know that Height of Instrument is given by HI = Elevation of known point + Backsight to…
Q: Describe the Standard Model of Consolidation
A: The Standard Model of Consolidation is a geotechnical engineering model that was developed to…
Q: What is the time between the departure of a vehicle and the arrival of the next vehicle, as measured…
A:
Q: 4-Astreet gutter has aside slope of 201 a longitudinal slope of 0.02 and a Manning "n" value of…
A: Given data: n=0.017s=0.02
Q: SOLVING SPACE TRUSSES BY USING METHOD 2 - Equilibrium of Moments in Space
A:
Q: Problem The rigid platform in Fig. P-239 has negligible mass and rests on two steel bars, each…
A: Given : Length of two steel bars = 250 mm length of aluminum bar = 240.90 mm P = 400 kN area = 1200…
Q: In an as-built survey, the XY coordinates in meters of three points on the centerline of a highway…
A:
Q: 1.9 m 8 m A B V 4.6 m 3.9 m 2.9 m
A:
Q: The assembly shown in the figure is made up of a disk, a bar, and a sphere. Disk A is pinned at O…
A: Given Weight of disk = 18 lb Weight of bar = 2.7 lb Weight of sphere= 11.5 lb
Q: When the flow of water through a horizontal 300mm x 150mm venturi meter (C=0.95) is 0.111m^3/s, find…
A:
Q: The structure shown supports three loads as given. Determine the reactions at A and B. II 0.3 m 0.6…
A: Given data in question Load 5 ,10 and 12 kN Angle 45° Span member length 2.2 m To find out Reaction…
Q: Precipitation The area between the isohytes 0.45 m and 0.55 m is 100 Sq.km and between 0.55 m and…
A: Given- Areas- A1=100 km2A2=150 km2 Precipitation- P1=0.45 m,P2=0.55 m,P3=0.65 m.
Q: A researcher was observing traffic along one lane of a rural highway. During a 1 minute time…
A: Given time interval= 1 min = 60 sec Number of vehicles,n = 10 vehicles
Q: 30° slope has a height of 10 m as shown in the figure below. The soil in the slope has the following…
A:
Q: The truss is loaded as shown below. a. Determine the support reactions of the truss. b. Determine…
A:
Q: A floor has to carry a load of 12 kN/m². The floor is supported on rectangular joists each 100 mm…
A: Given data- Load w=12 kN/m2, Rectangular joists 100 mm wide, 300 mm deep and 4 m long, Maximum…
Q: 3. Calculate the moment of inertia of the shaded area about the x and y axes. 100 100 50 50 75…
A:
Q: A four-story office building has interior columns spaced 30 ft apart in two perpendicular…
A: Solution:- Given data:- The number of stories of the office building = 4 The spacing between the…
Q: Find the maximum live load (P₁) applied on the beam shown below if f = 25 MPa and = 400 MPa. fy 1.5…
A: Given: fc = 25 MPa fy = 400 MPa b = 300 mm h = 500 mm stirrups = 10 mm Main bars = 2-#16 mm and…
Q: A- ال 13 الحل Determine the pressure head, elevation head, and total head at A, B, and C for the…
A: Total head = Pressure head + elevation head Take ponit B Elevation head = 1.4 - . 5 = 0.9 m…
Q: In a theoretical flow net, the seepage velocities along any two adjacent flow lines are always the…
A: Properties of Flow net. Each flow line and equipotential line must connect at an angle of 90 degree…
Q: 2. Calculate the moment of inertia of the shaded area about the x-axis as shown. 80 mm 80 mm 60 mm
A:
Q: Based on a Greenshields' model with a jam density of 120 vpmpl and a free flow speed of 60 mph,…
A:
Q: What would be the change in effective stress at point A if the water table rises to ground level?…
A:
Q: Problem 1. The truss is loaded as shown below. a. Determine the support reactions of the truss. b.…
A: Objective: To answer the given questions for the given statically determinate truss. Following is…
Q: A proposed 5°13' circular curve is to connect Dahlia Avenue to a newly constructed road which starts…
A: A proposed 5°13' circular curve is to connect Dahlia Avenue to a newly constructed road which starts…
Q: Q-In a groundwater field test, a tracer took 8 hours to travel between two observation wells which…
A: Given- Time t=8 hrs, Distance d=56 m, Head difference h=0.70 m, porosity n=30%=0.30, It is needed to…
Q: QUESTION 3 # How many crossing conflicts are present at a 4-leg intersection where each leg is a…
A:
Q: On the bending moment, between A and B...what is that? 2 raised to an exponent?
A: Given data: Bending moment diagram
Q: 3.A proposed 5°13' circular curve is to connect Dahlia Avenue to a newly constructed road which…
A:
Step by step
Solved in 3 steps
- An old 6-lane (3 lanes each direction) rural freeway segment has 11 ft lanes and frequent roadside obstructions located 10 ft from the right edge of the pavement. What is the estimated FFS (mph) for the 3 northbound lanes? Provide the answer to the nearest tenths.QUESTION 6 An old 6-lane (3 lanes each direction) rural freeway segment has 11 ft lanes and frequent roadside obstructions located 10 ft from the right edge of the pavement. What is the estimated FFS (mph) for the 3 northbound lanes? Provide the answer to the nearest tenths.Traffic volume is 2578 veh/hr with 687 vehicles arriving in peak 15 minutes.There are tow lanes, 12 percent trucks(30/70 split for SUT/TT), the length of the road is 1.8 miles long with a 3.5 percent grade. calculate the analysis flow rate?
- The details of a 12-hour volume study for a 4- leg road junction are tabulated below. The N-S major road has two through lanes on each approach while the E-W minor road has one through lane on each approach. Examine the fulfilment of traffic signal Warrants 1 (Condition B) using the MUTCD 2009 standards. Minor Rd. (Higher Major Rd. (Total of approaches) Hour Start approach) Hr 1 Hr 2 Hr 3 734 98 880 122 850 120 Hr 4 955 100 Hr 5 941 105 Hr 6 915 95 Hr 7 1040 140 Hr 8 1010 150 Hr 9 790 156 а. W1B is not met b. W1B is metA six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 1 ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service? (Write the letter only)Q3c. At a three leg (T) intersection, the two-way peak hour volume on the minor road is 500 veh/hr and that on the major road is 600 veh/hr. As a Traffic Engineer, what type of intersection control will you propose? What is the basis of your proposal?
- A six-lane freeway (three lanes in each direction in mountainous terrain has 10-ft lanes and obstructions 1ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuter with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?QUESTION 7 The 4 northbound lanes of a rural freeway segment have 13 ft lane widths. There is no lateral clearance afforded on either side of the road. There are no ramps within the area of influence. What is the estimated FFS (mph)? Provide your answer to the nearest tenths.The 4 northbound lanes of a rural freeway segment have 13 ft lane widths. There is no lateral clearance afforded on either side of the road. There are no ramps within the area of influence. What is the estimated FFS (mph)? Provide your answer to the nearest tenths.
- An undivided multilane highway segment has the following characteristics: • Six lanes (three lanes in each direction); Lane width of 11 ft; • Speed limit of 45 mph; Right shoulders is 4 ft wide; • There are approximately 25 access points over a 2-mile section of this roadway, in each direction. Calculate the FFS at this highway section and then determine the level of service (LOS) when the flow rate is 1100 pc/h/In. (Write the answer for the LOS in the box below).A six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 5 ft from the right edge. There are zero ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?A developer has applied for a construction permit to build a supermarket at the southeast cornerof an intersection that is formed by a four-lane divided highway in the east-west direction and atwo-lane road in the north-south direction. Traffic on the two-lane road is controlled by a stop signat the intersection. The speed limit on the four-lane highway is 88 km/h. using the sight trianglerequirements at the intersection (Case B1), determine whether permission should be given for theconstruction if the following conditions exist. Provide a diagram for your solution.Major road lane width = 3.6 mMinor road lane width = 3.3 mMedian lane = 2.8 mDesign vehicle is a passenger carApproach grade = 2%Maximum feasible distance building from the center of the nearest lane of four-lane road = 5.4 mMaximum feasible distance building from the center of the nearest lane of two-lane road = 16.5 m