Answered: Record the voltage for the Zn-Mg…

Science

Chemistry

Record the voltage for the Zn-Mg battery and compare this with the calculated voltage

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter13: Electrochemistry

Section: Chapter Questions

Problem 13.22PAE: Using values from the table of standard reduction potentials, calculate the cell potentials of the...

See similar textbooks

Related questions

Q: 0 cell Calculate the E

Q: In the voltaic cell shown in the following figure, the concentrations of Cu2+ and Cd2+ are 1.00 M.…

A: The standard reduction potential of Cu2+ is 0.34 V

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.250 M ZnCl2…

A: Given data,Concentration of ZnCl2=0.250MConcentration of Zn(NO3)2=1.65M

Q: 375.m2 Solution of Nace was electrolyzed for 3.10 min. if the PH the pH at the find Solution was…

Q: Calculate the potential developed by a voltaic cell using the following reaction if all dissolved…

A: Calculate the potential developed by a voltaic cell using the following reaction if all dissolved…

Q: c) d) Write the cell notation for the above cell. Determine the predicted standard state initial…

A: At anode oxidation occur and at cathode reduction occur

Q: Write equation that can be used to calculate the standard potential for a Redox couple from the…

Q: A concentration cell involving copper was set up with the following conditions:…

A: Interpretation - To tell about the measured cell potential when a concentration cell involving…

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.550 M ZnCl2…

A: In concentration cells the both half cells have same electrode but their concentration will be…

Q: A potential of - 0.788 V is applied to a cell with Nernst Potential of -0.734 V. The internal…

A: We need to find the overpotential.

Q: Using the values below I need to fill in the following table Reduction Potential Reduction Potential…

A: Formula to find experimental reduction potential is: EM2+/M = Ecell (measured) + (-0.79) V

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.300 M ZnCl2…

A: There are two solutions of Zn2+ ions given in the concentration cell. Out of these two solutions the…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 2.55 minutes for a current…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.02 minutes for a current…

Q: 1. Using data in Table 1 (see next page), calculate the standard emf for a cell that employs the…

A: We are given a complete cell reaction as follows: 2Al(s) + 3I2(s)--------->2Al3+(aq) + 6I-(aq).…

Q: Calculate the emf of the following concentration cell at 25°C: Cu(s) / Cu**(0.043 M) || Cu**(1.400…

A: EMF of the cell can be calculated by using the Nernst equation: Where, E= cell potential E0= cell…

Q: Zinc / Magnesium Cell Mg electrode Anode / Cathode Zn electrode Anode / Cathode Voltage measured for…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate the potential of the copper electrode immersed in a. 0.0440 M Cu(NO3)2 b. 0.0750 M in…

A: Hi! Since there are multiple questions posted. We are answering first question. If you need further…

Q: 1) Use a table of standard reduction to determine E cell 2) Calculate the cell voltage when [Ni^2+]=…

A: First we need to write a complete cell reaction using standard reduction potential values. Using…

Q: How many hours of will it take to deposit 664 g Al at a current of 32.6 amperes? Assume a solution…

A: time = 60.71 hours

Q: 3. Using the data in Table 1, ind anode and at the cathode. Combined Half- Anode reactions Cu vs Zn…

Q: c. Number of electrons involved in the redox reaction (n): d. Overall reaction for the voltaic cell:…

A: Given: The concentration of Cd2+ = 1.0 M The concentration of Cu2+ = 0.10 M a). The oxidation half…

Q: - Part A - Compute the cell potential at 25 °Cunder the following conditions: [Sn+] – 1.68×10-2 mol…

A: We are given E° cell and we habe to find the Ecell

Q: What is the initial cell potential? Express your answer using two decimal places. HA ? Ecell =…

A: We have to find the E cell of given reaction

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.39 minutes for a current…

A: According to the first law of Faraday, the mass of a metal deposited on the anode during…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.66 minutes for a current…

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.400 M ZnCl2…

A: Half-cell reactions are given below,

Q: c. Calculate the voltage of the cell using the standard values from reference tables. Ni/Ni² with…

A: Since the reference table has not been provided, thus standard values are taken on the own.

Q: Calculate the voltage, in V, of the following concentration cell at 25°C. Mg(s) | Mg2* (0.02 M) ||…

A: Determination of the Ecell of the given electrochemical cells;

Q: 405−mL solution of NaCl was electrolyzed for 5.80 min. If the pH of the final solution was 12.23,…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.12 minutes for a current…

A: Given: Time = 1.12 minutes = 1.12×60 sec Correct = 1.22 A Mass of the metal M = 0.0896 g

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.57 minutes for a current…

A: Using the formula for mass deposition to solve this.

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.300 M ZnCl2…

A: There are 2 solutions of Zn2+ ions in the given concentration cell. Out of these two solutions, one…

Q: Calculate the voltage of the following cell: Zn | Zn?* (0.10 M) || Cu²* (0.20 M)|Cu

A: Since you have posted multiple questions, we are entitled to answer first only.

Q: B) Calculate standard cell potential (E°). C) Calculate the voltage for this cell. V Porous Barrier…

A: At anode: Al ---> Al3+ + 3e- : E° = -1.66 V At cathode: Sn2+ + 2e- ---> 3Sn E° = -0.14 V…

Q: If the cell is a standard one, write the spontaneous overall reaction and calculate the voltage that…

A: Since standard reduction potential of Ni+2 is more as compared to Cd+2 so Ni electrode act as…

Q: A UPDATES AVAILABLE Do you want to install the updates now? Table 2 Half-Reaction Standard Reduction…

Q: Suppose that an alkaline battery was manufactured using cadmium metal rather than zinc. What effect…

A: The standard reduction potential for the cadmium (Cd) and zinc (Zn) are;

Q: Calculate the emf of the following concentration cell at 25oC: Cu(s)|Cu2+(0.10 M)||Cu2+(2.0…

A: The cell given is Cu(s)|Cu2+(0.10 M)||Cu2+(2.0 M)|Cu(s) Hence in the above cell, the anode chamber…

Q: Calculate the voltage of the following cell: Zn / Zn2+ (0.10 M) // Cu2+ (0.20 M) / Cu

A: Lets find Eo 1stfrom data table:Eo(Zn2+/Zn(s)) = -0.7618 VEo(Cu2+/Cu(s)) = 0.337 V As per given…

Q: Construct two electrochemical with EMF greater than +0.513 V. The two cells are Zn-Fe cell and…

A: The EMF of a cell is given by the Nernst equation: Ecell = E°cell - 2.303RTnFlogQQ = reaction…

Q: Use the observed potential for the Zn(s) | Zn²*(0.1 M)|| Cu²^(0.1 M) | Cu(s) cell as the E" in the…

A: For the given cell, Zn (s) | Zn2+ (aq) || Cu2+ (aq) | Cu (s)

Q: 6. If the cell potential in the previous problem (5) is 0.485 V, what is the [CI] in the cathode…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.99 minutes for a current…

A: We have to calculate the molar mass of metal .

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.96 minutes for a current…

A: Metal is deposited as M3++3e-= 3M . We can infer that 3moles of electrons=3Faraday=3×96485 = 289455…

Q: ELECTROCHEMISTRY: Determine the molar mass (amu) of Metal (M) if it took 1.24 minutes for a current…

Q: Calculate AE° cell

Q: A concentration cell is set up using two zinc wires and two solution, one containing 0.450 M ZnCl2…

A: The oxidation half reaction takes place at anode and cathode are noted as follows, Here, electrode…

Question

Record the voltage for the Zn-Mg battery
and compare this with the calculated voltage

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Based on the cell potential measured for the cells Co(s)|Co2+(aq) Cu 2+( aq)|Cu( s)E=0.614VFe(s)|Fe2+(aq) Cu 2+( aq)|Cu( s)E=0.777V what potential should you expect to find for the following cell? Fe(s)|Fe2+(aq)Co2+(aq)|Co(s)
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Zn|Zn2+(0.50M)Cd2+(0.020M)|Cd (b) Cu|Cu2+(0.0010M)H+(0.010M)|H2(1.00atm)|Pt
Calculate the voltages of the following cells at 25°C and under the following conditions: (a) Cu|Cu+(0.80M)Hg22+(0.10M)|Hg|Pt (b) Cr|Cr3+(0.615M)Ni2+(0.228M)|Ni
Consider the reduction of nitrate ion in acidic solution to nitrogen oxide (Ered=0.964V) by sulfur dioxide that is oxidized to sulfate ion (Ered=0.155V) . Calculate the voltage of a cell involving this reaction in which all the gases have pressures of 1.00 atm, all the ionic species (except H+) are at 0.100 M, and the pH is 4.30.
Using values from the table of standard reduction potentials, calculate the cell potentials of the following cells. (a) Fe(s)|Fe2+(aq)Hg2+(aq)|Hg(l) (b) Pt(s)|Fe2+(aq),Fe3+(aq)MnO4(aq),H+(aq),Mn2+(aq)|Pt(s) (c) Pt(s)|Cl2(g)|Cl-(aq)Au+(aq)|Au(s)
Determine the overall reaction and its standard cell potential at 25 C for this reaction. Is the reaction spontaneous at standard conditions? Cu(s)|Cu2+(aq)Au3+(aq)|Au(s)
A galvanic cell is constructed in which the overall reactionis Cr2O72(aq)+14H2O+(aq)+6I(aq)2Cr3+(aq)+3I2(s)+21H2O(l) Calculate E for this cell. At pH 0, with [Cr2O72]=1.5M and [I]=0.40M, the cell potential is found to equal 0.87 V. Calculatethe concentration of Cr3+(aq) in the cell.
Determine the overall reaction and its standard cell potential at 25 C for the reaction involving the galvanic cell in which cadmium metal is oxidized to 1 M cadmium(II) ion and a half—cell consisting of an aluminum electrode in 1 M aluminum nitrate solution. 15 the reaction spontaneous at standard conditions?
Calculate the equilibrium constant for the following reactions using data from the standard reduction potential tables. (a) Cl2(g)+2Br-(aq)Br2(g)+2Cl-(aq) (b) Ni(s)+2Ag+(aq)2Ag(s)+Ni2+(aq) (c) I2(s)+Sn2+(aq)2I(aq)+Sn4+(aq)
Determine the standard cell potential and the cell potential under the stated conditions for the electrochemical reactions described here. State whether each is spontaneous or nonspontaueous under each set of conditions at 293.15 K. (a) Hg(l)+S2(aq,0.10M)+2Ag+(aq,0.25M)2Ag(s)+HgS(s) (b) The galvanic cell made from a half-cell consisting of an aluminum electrode in 0.015 M aluminum nitrate solution and a half—cell consisting of a nickel electrode in 025 M nickel(l) nitrate solution. (c) The cell made of a half-cell in which 1.0 M aqueous bromide is oxidized to 0.11 M bromine ion and a half-cell in which aluminum ion at 0.023 M is reduced to aluminum metal. Assume the standard reduction potential for Br2(l) is the same as that of Br2(aq).
Consider the following galvanic cell at 25C: Pt|Cr2+(0.30M),Cr3+(2.0M)||Co2+(0.20M)|Co The overall reaction and equilibrium constant value are 2Cr2+(aq)+Co2+(aq)2Cr3+(aq)+Co(s)K=2.79107 Calculate the cell potential, for this galvanic cell and G for the cell reaction at these conditions.