single loop of wire has a radius of 0.9 meters and a resistance of 18 Ω. A magnetic field pointing out of the screen changes from 2.6T to 7.9T in 0.2s. Which current flows through the wire? answer in milliAmpere (mA), and keep three significant digits. positive will be a counterclockwise current and negative will be a clockwise curre

single loop of wire has a radius of 0.9 meters and a resistance of 18 Ω. A magnetic field pointing out of the screen changes from 2.6T to 7.9T in 0.2s. Which current flows through the wire? answer in milliAmpere (mA), and keep three significant digits. positive will be a counterclockwise current and negative will be a clockwise curre

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter24: Magnetic Fields

Section: Chapter Questions

Problem 11STP

See similar textbooks

Similar questions

A wire 2 m long has a mass of 342 g. The wire is connected to an emf. What is the minimum current in the wire that would allow it to levitate above the ground in a magnetic field of magnitude1.9 T? To continue, please enter the result in units of A. Round your answer to 2 decimal places. Per previous question, what direction must the current flow?
A current is running through a 1.80m wire. The resistance is 0.75 ohms and the voltage is 12.0V. If the force going through the wire is 125N, what is the magnetic field strength created by the wire?
Problem 3: A loop of wire with radius r = 0.015 m is in a magnetic field with magnitude B as shown in the figure. B changes from B1 = 0.45 T to B2 = 5.5 T in At = 9.5 s at a constant rate. The resistance of the wire is R = 9 Q. B a) Calculate the numerical value of the change in magnetic flux, AO, in T:m2. b) Calculate the numerical value of the average emf, ɛ, induced in the loop in volts. c) Calculate the numerical value of the current induced in the loop, I, in amperes.
What is the current in a long wire if the magnetic field strength 1.2 cm from the wire's axis is 57 μT ?
In the figure (Figure 1) the top wire is 1.1 −mm−mm -diameter copper wire and is suspended in air due to the two magnetic forces from the bottom two wires. The current flow through the two bottom wires is 75 AA in each. Calculate the required current flow in the suspended wire. Express your answer using two significant figures. ICu=____________A
Which of the following statements are correct about different unit combinations? There is more than one correct answer; points are deducted for wrong answers. Kinetic energy uses different units than other forms of energy. Magnetic field can be measured in Volts per meter, The units for force times distance ("Work") are the same as the units for momentum. Ohms are equivalent to Watts per {Ampere squared}. The units for thermal energy are the same as those for kinetic energy. The units for momentum times units for velocity some out the same as units for electrical energy. Momentum has the same untis as speed. Joules is the same as Coulombs times Volts. The force due to gravity is measured in different units than the electrostatic force.
Question: V Figure 1. A rectangular sample of semiconductor is in a magnetic field B, oriented approximately into the page, as shown. The sample is connected to an ammeter, voltmeter and a voltage source. The schematic shows a circuit involving a sample of semiconductor, whose cross-section is L by w. The sketch is not to scale and the electrodes attached to the sample are not shown. A uniform magnetic field B is applied in the direction indicated by the crosses (roughly, into the page). Each charge carrier has a charge q and the density of charge carriers, measured in ions per cubic metre, is n. Part 1) Use the definition of electric current to give an expression for the average speed of the charge carriers when the ammeter registers a current i. vd = Part 2) Give an expression for the magnitude of the magnetic force on a charge carrier. Your answer should be in terms of ¿, not v. F= Part 3) The magnetic force in part 2 produces a lateral displacement in the charge carriers, and the…
A solenoid used to produce magnetic fields for research purposes is 2.7 m long, with an inner radius of 68 cm and 3.4 x 104 turns of wire. When the current is 300 A, what is the magnitude of the magnetic field inside of the solenoid, in Tesla? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement.
If an electric wire is allowed to produce a magnetic field no larger than that of the Earth (0.50×10−4T×10−4T) at a distance of 28 cmcm from the wire, what is the maximum current the wire can carry? Express your answer to two significant figures and include the appropriate units. I= ?
The circuit in the figure below is located in a magnetic field whose magnitude varies with time according to the expression B = 1.00 x 10³ t, where B is in teslas and t is in seconds. Assume the resistance per length of the wire is 0.099 /m. Find the current in section PQ of length a = 60.0 cm. magnitude μA direction from Q to P a xxxxx * * * ** x Bin * * x X xx * * * xx x X xx 2a x x x x xx P xxxx xxxx **** * x x x x Q a
Suppose you wish to measure the current in a wire. You have a device that can measure the strength of the magnetic field produced by the wire, but the device does not directly measure the current. If the device is place 0.98m away from the wire, and the magnetic field strength is 1.72µT, what is the current running through the wire in Amps? Note: It is understood that the unit of your answer is in A, however do not explicitly include units in your answer. Enter only a number. If you do enter a unit, your answer will be counted wrong.
A 9.00-uC charge is moving with a speed of 7.50 x 10^6 m/s parallel to a long, straight wire. The wire carries a current of 77.0 A in the same direction as the moving charge, and is 5.00 x 10-2m away from the charge.Find the magnitude (in Newtons) on the charge. Use 4 decimal places