Solve for the latent heat of water at Tw = 28C (and. λw = 2435 kJ/kg)
Q: What is the significance of Burger's equation? Elaborate briefly.
A: The degree and direction of the lattice deformation associated with a dislocation in a crystal…
Q: A boiler uses 2100 kg/hr of coal. The temperature of the air supplied is 310 K, and the average…
A: Given Datacoal consumption=2100kg/hrTair=310KTavg=660KH=34mhf=20mm
Q: For the draining liquid fi lm of Fig. , what are theappropriate boundary conditions ( a ) at the…
A:
Q: HW5 Find the tored vibvation Hoponse under zero Inctiad Conditions ( X =0, U=0) 30 10 /火) 345
A: Solution: Given: Initial conditions (X0=0, V0=0) to find: Forced vibration response
Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…
A: Given details: h1=3212 kj/kgV1=237 km/hrh2=2556 kj/kgA1=0.22 m2sp.volume=0.32 m3/kg
Q: Q.1. Air flows in a constant-area duct of diameter 1.5 cm with a velocity of 100 m/s, static…
A:
Q: What is the friction loss in cm of water in a 2.44m diameter chimney 61m high up which gas is…
A: Givend=2.44ml=61mV=9.14m/secρ=0.6776kg/m3
Q: A gasoline engine is at a location where the temperature is measured to be 14.8 °C and produces 300…
A: Gasoline engine: The internal combustion engine that runs on gasoline has the combustion chamber…
Q: A reciprocating air compressor serves an air operated sinking pump operating at 760 kPag and 6.20…
A: For solution refer below images.
Q: Imagine a plate 1 m long by 1 m wide at a temperature of 80 °C. Water is passed over its surface at…
A: Length of the plate, L=1 mWidth of the plate, W=1 mTemperature of the plate, Ts=80oCSpeed of water,…
Q: Imagine a plate 0.1 m long by 0.1 m wide at a temperature of 80 °C. Water is passed over its…
A: Given data: Ts=80°CT∞=40°CV=0.1 m/sL=0.1 mw=0.1 m Need to determine the heat dissipated by the…
Q: i. Find the Mach no. of an aircraft flies with the same Mach no. at elevations of 8000m (T=-42 C°)…
A:
Q: Find the boiler chimney diameter if the boiler has a capacity of 320 kW with a combustion efficiency…
A: Given data: The boiler capacity, W˙ = 320 kW. The combustion efficiency, ƞ = 75%. The calorific…
Q: An end-burning rocket motor has a chamber diameter of 10cm and a nozzle exit diameter of 8cm. The…
A:
Q: A gasoline engine is at a location where the temperature is measured to be 14.2 °C and produces 347…
A: Gasoline engine: The gasoline engine is an internal combustion engine in which the air-fuel…
Q: turbine agitator with six flat blades and a disk has a diameter of 0.303m. It is used in a ank with…
A:
Q: If air flows in a 20 mm diameter constant area duct at a velocity of 125 m/s with a static…
A: Given Data: Diameter of duct d=20mm The velocity of airflow V=125 m/sec Static temperature T=300K…
Q: The actual velocity of a gas entering in a chimney is 8 m/sec the gas temperature is 25 C and…
A: Given The actual velocity of gas entering a chimney, v = 8 m/sec…
Q: Ageothermal power plant was installed at the rear side diff of Mayon Terrain that generates thermal…
A:
Q: The actual velocity of gas entering in a chimney is 5 m/s. The gas temperature is 25°C and pressure…
A:
Q: Engine oil enters a circular tube D=10-cm in diameter and L=23-m in length. If the flow rate and…
A:
Q: At the end of the compressor in a jet engine, a diffuser receives air through its 0.6m2 inlet at…
A:
Q: A cylindrical pressure vessel of outer diameter 30 cm and thickness 15 mm is used for storing…
A: Write the given data:
Q: A dry gas well equipped 30 MMcfd with 85psig tubing pressure must be compressed to 300 psig for…
A: Saturation Pressure: The pressure exerted by the vapour on the liquid when both liquid and vapour…
Q: Example 2: The local atmospheric pressure in Denver, Colorado (elevation 1610 m), is 83.4 kPa. Air…
A:
Q: A pipe takes water from a reservoir where the temperature is 12 °C to a hydro- electric plant 600 m…
A: The Answer is below
Q: 8. A coal fired steam boiler uses 3000 kg of coal per hour. Air required for combustion is 15.5 kg…
A: Dear student, According to the expert guidelines I am allowed to answer only…
Q: A 1.5-m long, copper rod is removed from a heat- treatment oven at 550°C and immersed in a 55°C…
A: Given data Length of copper rod = 1.5 mTemperature of the surface of copper rod = 550 °CTemperature…
Q: Water (5.2 L'min) is flowing in a tube "D-3 cm, L-5 m" and is to be heated from 15°C to 59.9°C by…
A: Given:Volume Flow rate,Q=5.2Lmin=5.2×10-360m3secDiameter,D=3cm=0.03mLength of tube,L=5mInitial…
Q: Someone claims that in the fully developed laminar flow region, the velocity profile change in the…
A: No. I do not agree as the velocity in fully developed laminar region remains unchanged.
Q: a steel pipe has an inside diameter of 25 mm, is 20 m long, and carries 10 deg Celcius water at a…
A: Given data: f=0.0259Q=4.5 m3/h=1.25×10-3 m3/sL=20 md=25 mm=0.025 mPi=70 kPa Need to determine the…
Q: The water vapor is throttled by an insulated valve from 6 MPa pressure and 400oC temperature to 2…
A:
Q: e vessel
A: GIVEN:diameter d=10mheight h=6.75ms.g=0.68
Q: A 1.5-m long, copper rod is removed Irom a heat- treatment oven at 550°C and immersed in a 55°C…
A: Given dataLength of copper rod = 1.5 mTemperature of surface of copper rod = Ts = 550°CTemperature…
Q: Consider a stream of R-134a
A: 111.3KJ/s
Q: 1. when ( a) M 1 (c) M =1 - , the flow is accelerates if the cross sectional area is increases 2. If…
A: 1. When M>1, the flow becomes supersonic flow and velocity increases when area increases. 2.…
Q: When the site is chosen, it is proposed that three-blade type wind turbines are installed, which can…
A: Given data: Velocity range : 3 m/s to 12 m/sTurbine blade length = 75 mPower coefficient = 0.54Air…
Q: What is the Continuity Equation for steady flow processes?
A: Continuity Equation for steady flow processes It states that, in a steady state process the rate of…
Q: Process water flows at a velocity of 6 m/s through a 10 cm ID 90° elbow. Pressure was measured to be…
A:
Q: Determine the difference on thermal shock resistance of Pyrex and zirconia. The values for E, of,…
A: INTRODUCTION: We have two distinct materials in this challenge, one is pyrex and the other is…
Q: An air curtain is produced by blowing air through a long rectangular nozzle at high air velocities…
A:
Q: Subject: Thermodynamics The actual velocity of gas entering in a chimney is 8m/sec. The gas…
A: Given data: m˙=50000 kg/hv=8 m/sT=25°C=298 KP=98 kPa Need to determine the chimney diameter if mass…
Q: ir is flowing in a duct with velocity of 7.62 m/s and static pressure of 2.7 cmWG. The duct diameter…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Solve for the latent heat of water at Tw = 28C
(and. λw = 2435 kJ/kg)
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- Assume that T0 = 1800 K is the temperature of fluid iron(which is roughly its melting point). From this temperature, the iron will becooled in a water reservoir at temperature T∞ = 300 K. After 20 minutesthe temperature has dropped to 1050 K. Find(a) the cooling rate h and(b) the explicit solution T(t) of the IVP (1)What is the equation for the sum of energies in a fluid and show how we get Bernoullis equation from it?1. The flash point of an engine oil is 3630F. What is the absolute flash-point temperature in K and R is
- A spherical research balloon is filled with 420 m3 of atmospheric air at atemperature of 10 oC. If the air inside the balloon is heated to 80 oC accordingto PVn =C, where n = 0. What will be the final diameter of the balloon?Conduction 1. A thermodynamic analysis of a proposed Brayton cycle gas turbine yields P= 5 MW of net power production. The compressor, at an average temperature of T. = 400°C, is driven by the turbine at an average temperature of T₁ = 1000°C by way of an L = 1m-long, d= 70mm - diameter shaft of thermal conductivity k = 40 W/m K. Compressor min T Combustion chamber Shaft L Turbine Th out (a) Compare the steady-state conduction rate through the shaft connecting the hot turbine to the warm compressor to the net power predicted by the thermodynamics- based analysis. (b) A research team proposes to scale down the gas turbine of part (a), keeping all dimensions in the same proportions. The team assumes that the same hot and cold temperatures exist as in part (a) and that the net power output of the gas turbine is proportional to the overall volume of the device. Plot the ratio of the conduction through the shaft to the net power output of the turbine over the range 0.005 m s Ls 1 m. Is a…For a gas of volumes Vi = 9.50 10-4 m3 and Vf = 1.40 10-4 m3 and pressures Pi = 2.00 106 Pa and Pf = 2.05 107 Pa, answer the following.For an isobaric process at Pi, find the internal energy change of the gas during this process.For an isovolumetric process at Vi, find the internal energy change of the gas during this process.