Specify whether the calculated mass percent of water would be too high, too low, or unchanged as a result of each of the following experimental conditions. Justify your answers. a. The heating was insufficient to remove all of the water from the hydrated salt. b. Some of the sample spattered out of the crucible onto the laboratory bench during the heating.

Specify whether the calculated mass percent of water would be too high, too low, or unchanged as a result of each of the following experimental conditions. Justify your answers. a. The heating was insufficient to remove all of the water from the hydrated salt. b. Some of the sample spattered out of the crucible onto the laboratory bench during the heating.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.4QAP

See similar textbooks

Similar questions

Which law of physics states "For a given reaction, all components of the reactants can be accounted for in the products"? A. Law of mass conservation B. Law of capillaries C. Law of chemical balance D. Law of reaction equlirium
Mass of KI tablet 0.425 g Mass of thoroughly dried filter paper 1.462 g Mass of filter paper + precipitate after first drying 1.775 g Mass of filter paper + precipitate after second drying 1.699 g Mass of filter paper + precipitate after third drying 1.698 g A student is given the task of determining the I content of tablets that contain Kl and an inert, water-soluble sugar as a filler. A tablet is dissolved in 50.0 mL of distilled water, and an excess of 0.20 MPb(NO3)2(aq) is added to the solution. A yellow precipitate forms, which is then filtered, washed, and dried. The data from the experiment are shown in the table above.
19. Calculate the number of moles oh hydrogen atoms in 17.4 g of (NH4)2SO4.A. 2.13 mol H atomsB. 1.05 mol H atomsC. 1.23 mol H atoms D. 1.50 mol H atoms with complete solution
16. Calculate the number of aluminum atoms in a can containing 25.0 g of aluminum.A. 7.57 x 1023 atoms AlB. 6.57 x 1023 atoms AlC. 5.57 x 1023 atoms AlD. 4.57 x 1023 atoms Al *with complete solution
1. Which best describes a chemical reaction with accompanying absorption of heat? C a. catalytic b. exothermic c. endothermic d. reactive 2. If a student calculates the maximum amount of product that can be obtained in a chemical reaction, they are determining the: B? a. percentage yield b. theoretical yield c. mole ratio d. actual yield 4. To balance a chemical equation, one must adjust the - A a. coefficients of chemical formulae b. subscripts of chemical formulae c. formulae of the products d. either the subscripts or the coefficients of chemical formulae
Gravimetric analysis of chloride salts. This experiment illustrates the concept of stoichiometry. Define what is stoichiometry? How can you relate stoichiometry to this experiment?
30. What weight of impure ferrous ammonium sulfate sample in milligrams must be taken for analysis so that the number of centigrams of BaSO4 will represent five times the % S in the sample? a. 230 mg b. 345 mg c. 460 mg d. 690 mg 31. If 100 mL of a dichromate solution (10 grams K2Cr2O7 per liter), 5 mL of 6 N H₂SO₁ and 75 mL of a ferrous solution (80 grams of FeSO4-7 H₂O per liter) are mixed, and resulting solution titrated with 0.2121 N KMnO4, what volume of is required KMnO4? a. 5.60 mL b. 5.80 mL c. 6.00 mL d. 6.20 mL
A student weighs out 4.16 g of magnesium chloride and adds enough water to make 125.0 mL of solution. The student then weighs out 8.82 g of sodium phosphate and adds enough water to make 250.0 mL of solution. 25.0 mL of the magnesium chloride solution is combined with 25.0 mL of the sodium phosphate solution. a. Write a balanced equation for the reaction that occurs (remember to include phases). b. If a precipitate forms, write the name of the precipitate and calculate the theoretical yield for the precipitate. If no precipitate forms, calculate the limiting reactant. c. If the temperature of the solution decreases, is this reaction exothermic or endothermic?
The industrial production of ammonia is based on the Haber process in which atmospheric nitrogen (N2) is made to react with hydrogen gas. a. Write a balance equation for the reaction described above. b. How many kilograms of N2 are needed to produce 50.0kg of ammonia. Write your complete and step-by-step solution below
Explain how each one of these activities would affect your calculated percent yield of zinc phosphate. a. You mixed the solutions in a wet beaker versus a dry one.b. The final precipitate was not fully dry when you recorded the final weight.
21. What materials contain a precisely known concentration of a substance typically used in quantitative analysis? A. ACS grade MaterialsB. Chemical Standard MaterialsC. IUPAC Standard MaterialsD. PIPAC Standard Materials
A student makes a standard solution of potassium hydroxide by adding 14.555g to 500.0mL of water. Answer the following questions, being sure to include units and remember sig figs. Show work. a. What is the concentration of this standard solution? b. If the student pours out a 15.6mL sample of this solution, how many moles of sodium hydroxide does the student have in the sample?