The blocks are joined by an inextensible cable as shown. If the system is released from rest, what is the tension (in Newton) produced in the cable after block A has moved 2m? Assume the coefficient of kinetic friction between block A and the plane is 0.25 and the pulley is weightless and frictionless. The Mass of A is 200kg; the Mass of B is 300kg.

The blocks are joined by an inextensible cable as shown. If the system is released from rest, what is the tension (in Newton) produced in the cable after block A has moved 2m? Assume the coefficient of kinetic friction between block A and the plane is 0.25 and the pulley is weightless and frictionless. The Mass of A is 200kg; the Mass of B is 300kg.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.48P: Find the smallest distance d for which the hook will remain at rest when acted on by the force P....

See similar textbooks

Similar questions

The coefficient of rolling resistance between the 30-kg lawn roller and the ground is r=0.1. (a) Determine the force P required to pull the roller at a constant speed. (b) What force P would be needed to push the roller at a constant speed?
3. A 5-kg crate is released from rest at Point A of a 20-kg ramp which is inclined at 40 degrees as shown in the figure below. The lengths of the ramp is 2 m. The interface between the ramp and the ground can be assumed to be frictionless. Use Newton's 2nd Law and the definition of the center of mass to determine the horizontal distance that the ramp has moved when the crate reaches Point B. Neglect the size of the crate. Does your answer depend on the frictional force between the crate and the ramp? e S
In a porter governor the mass of the central load is 18 kgand the mass of each ball is 2kg. the top arms (254) mm while the bottom arms are (304) mm long. The friction of the sleeve is 20 N. If the top arms make 45 deg with the axis of rotation in the equilibrium position, find the range of the speed of the governor in that position
B
In a Porter governor, the mass of the central load is 18 kg and the mass of each ball is 2 kg. The toparms are 250 mm while the bottom arms are each 300 mm long. The friction of the sleeve is 14 N. Ifthe top arms make 45° with the axis of rotation in the equilibrium position, find the range of speed ofthe governor in that position.
1. A small object of mass m is located on the surface of the disk with radius R if the magnitude of the coefficient of static friction between the object and the disc is u and the disc rotates with a certain angular speed so that the object of mass m slides from the disc which is at a height h. Prove that the horizontal distance traveled by the object is x = JuR2h 2. A child of mass 80 kg sits on a spinning disc and begins to slide if the coefficient of friction is 0.5 and the angular velocity of the rotating disc is 10rad/s. calculate the maximum radius R provided that the child can still sit and remain on the spinning disc? Compare your answer with the manual solution and use Matlab A beautiful jumper with mass m jumps from a height of 10 m (a Calculate the initial velocity V at the time of the diver's collision with the water and the estimated time from the time of the dive to the collision. Assume that the buoyant force of the water is able to balance the magnitude of the…
The lower block of mass m2 = 3.2 kg is pulled on by a rope with a tension force of 28 N. The upper block has mass m1 = 1.8 kg. The coefficient of kinetic friction between the lower block and the surface is 0.32. The coefficient of kinetic friction between the lower block and the upper block is also 0.32. What is the acceleration of the 3.2 kg block?
3. A block of mass m = 2.00 kg rests on the left edge of a block of mass M= 8.00 kg. The coefficient of kinetic friction between the two blocks is 0.300, and the surface on which the 8.00 kg block rests is frictionless. A constant horizontal force of magnitude F= 10.0N is applied to the 2.00-kg block, setting it in motion as shown in Figure. The distance L that the leading edge of the smaller block travels on the larger block is 3.00 m. F - m M M (a) Draw a separate free-body diagram for each block. (b) In what time interval will the smaller block make it to the right side of the 8.00-kg block? as (Note: Both blocks are set into motion when the force is applied.) (c) How far does the 8.00-kg block move in the process?
3. A block of mass m = 2.00 kg rests on the left edge of a block of mass M = 8.00 kg. The coefficient of kinetic friction between the two blocks is 0.300, and the surface on which the 8.00 kg block rests is frictionless. A constant horizontal force of magnitude F = 10.0 N is applied to the 2.00-kg block, setting it in motion as shown in Figure. The distance L that the leading edge of the smaller block travels on the larger block is 3.00 m. m (a) Draw a separate free-body diagram for each block. (b) In what time interval will the smaller block make it to the right side of the 8.00-kg block? as (Note: Both blocks are set into motion when the force is applied.) (c) How far does the 8.00-kg block move in the process?
Block A (99-lb) is attached to block B (49-lb) through the interconnected pulleys C and D, as shown in the figure above. The coefficient kinetic friction between block A and the incline is 0.2. If block A has now a speed of 5(ft/s) down the incline, then while neglecting the mass of pulleys and ropes, Determine: 1. The Acceleration of block A 2. The distance (magnitude and direction) block B moves as block A slides to a stop.
Mary and her sister are playing with a cardboard box on the neighborhood hill. Mary climbs into the box, the total mass of the box with Mary in it is 115 kg. The box starts at rest at the beginning of the incline. The hill is at an incline of 28 degrees with respect to the horizontal.The static and kinectic friction between the box and hill is 0.4 and 0.2 respectively. Assume the box is sliding downhill. a. What is the magnitude of the acceleration of the box? (same as Problem 3b)b. If the hill is 5m tall, what is the Mary's speed when she reaches the bottom?c. At the bottom of the hill, the ground becomes level, but the coefficients offriction do not change. How far will Mary slide before she comes to a stop?
NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. The two blocks shown are originally at rest. Neglect the masses of the pulleys and the effect of friction in the pulleys and between the blocks and the incline. Consider WA = 212 lb and WB = 312 lb. Ma 20 Determine the tension in the cable.. The tension in the cable is 190 lb. me