The efficiency of the I.M of the same:rating as transformer is.Higher than that of transformerO.Equal to that of transformerOLess than that of transformer O

Effeciency of Induction motor compared to transformer:

Answered: The efficiency of the I.M of the same…

Engineering

Electrical Engineering

The efficiency of the I.M of the same :rating as transformer is

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter4: Symbols

Section: Chapter Questions

Problem 7SQ: The symbol shown is a(n) a. iron core transformer. b. auto transformer. c. current transformer. d....

See similar textbooks

Related questions

Q: Coulomb's law concern itself with; (A) The interaction between two static charges. B The creation…

A: We need to select correct option for coulombs law

Q: (B)-Indicate whether the following statements are true or false and correct the false statements 1-…

Q: 3.) A voltage v = 120 sin (275t + %3D Tt/2) is applied to a capacitor rated 68 µF. Find the r.m.s.…

A: To find the RMS value of current through capacitor

Q: Five inductors, each 10 mH, are connected in series across a sine wave ac source. Determine the…

A: Given data, Five inductors each of 10 mH are connected in series.

Q: combinational logical circuit to the following equation, using only NAND gates: Y = ABC + AB + BC.

A: We need to design the given Boolean function by using of nand gate

Q: Q. Use Table below to explain why the circuit of Figure below will not work as it is. How can the…

A: Integrated circuit are known as microelectronic circuit . This integrated circuit are used in…

Q: A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158…

Q: 1. The following circuit shows a discrete common source MOSFET amplilier The MOSFTE is n-channel…

Q: 38 +16 V Si Si ´ Si oVo 4.7 k2 -4 V Figure 3 Determine the voltage output Vo and the current I of…

Q: 23. When the circuit breaker is always tripping, most likely There is an overloading c. The supply…

A: In this question, We need to choose the correct options What is the circuit breaker is always…

Q: A 50 ohms load resistance is connected across a half wave rectifier. The input supply voltage is…

A: In this question we need to find a DC output voltage

Q: 14.) Find the value of power dissipated if a voltage v = 240 sin (30t + Tt/4) is applied to a…

Q: A Factory takes 200-kW at 1100-volts from a trhee-phase supply and the power factor and the power…

A: Active power is given as, P=VI*(Cos∅) Reactive power is given by, Q=VI*(Sin∅)=P(tan∅)

Q: Adding resistance to the rotor circuit of :induction motor will Reduced the starting current and…

Q: What is the per unit impedance of a 50 MVA, 13.8 kV, 1% impedance transformer if the base is change…

Q: OThe t and current is not too high. OThe p.f. is leading p.f. for any possible current.

Q: The figure shows the excitation curve (including residual voltage) of a 170 kW, 250 V DC shunt…

A: In this solution the concept of DC shunt motor & its field control is discussed. In field…

Q: Transform the circuit such that the 3 kQ resistor is left unchanged and the final circuit contain…

A: We need to find current and power for given circuit

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

Q: 4/0° V -j4 Q 6Ω j5 Q all 0/0° V -j2 2 3/0° 14 13

Q: The analysis of the voltage, V for the circuit given in The below circuit can be expressed in the…

A: Note: value of id is not given. We assume id =0.5882

Q: et a[n]. What is the sampling rate F,? -3 0.5 10-2 O a. 25 Hz O b. 250 Hz Ю с. 300 Hz O d. 30 Hz О…

A: In a given 10ms signal duration, there are 6 samples. Time duration between two samples is given by…

Q: Space wave propagation occurs in radio wave communication within a frequency range of O 3 MHz 300…

A: Space waves are a class of radio waves which basically has a frequency range of approximately 30MHz…

Q: Every year the typical American household consumes an average of 10,896 kWh . If the cost per kWh is…

A: Energy is power multiplied by time. One unit of electrical energy is One KWh. Given that a typical…

Q: An. A/D converter uses 14-bit numbers linear sign magnitude PCM and has a voltage range of -6V to…

A: The solution is given below

Q: A 240 V source is connected in series with two components, one of which has an impedance of 80?60°…

Q: Deter mine the node ages 502 P. Me 9. 2A (T +) iov 402 10

A: We need to find out node voltage for given circuit

Q: Given a switching function f(A, B,C, D) = A'BD + AC'D. a) Find its minterm and maxterm expansions.…

A: Given data FA,B,C,D=A,BD+AC,D

Q: E = K,ONvolts-where NIS Example 8.8. Afour-pole generator, having wa ve-wound armature winding has…

A: The solution is given below

Q: 20. For the system shown in the given figure draw the free body diagram and solve the transfer…

Q: 6. The used in computers (positive numbers in true form; negative numbers in complement form). (a)…

Q: 24.) The figure below series-parallel circuit Compute for the tota power consumed by Express in four…

Q: Question 16 A transmitter is located at a distance 52 km from a receiving base station. What is the…

A: We need to find out free space loss

Q: At a certain time, the maximum usable frequency (MUF) for transmission at an angle of incidence of…

Q: Consider the circuit shown in the figure below. Given that R2/R1 = 2, the current passing through…

A: In this question we need to find a time constant of the given circuit

Q: Find the final value of y(t), where Y(s)=6(s+4)/(s³+s2+2s)

Q: In power factor correction where a motor load is normally operating with 1000 inductive vars, a…

A: In this question, We need to explain the why inductive VAR power is compensation by the capacitor?…

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

Q: Find the z-transform of n an un.

Q: How much is 1 line of flux in Webers?

Q: Problem 1 [5+5] Find the phase difference between these two. Also mention which one is leading. I =…

Q: A resistor R and an impedance coil Z are connected in series. The combination is supplied by a…

Q: For the voltage-divider bias configuration. Determine the level of output impedance or Zo with the…

Q: A non- inductive resistor of 10 ohms requires a current of 8A and is to be feed from 1 200V 50Hz…

Q: Q4) Explain briefly the principle of critical angle required for total internal reflection.

A: We need to explain the concept of critical angle .

Q: Compose the mesh equations. 10 Q j10 O j10 2 ll ell 10 V [11] [12] :-10 2 sine sine

Q: 1. How does the AC version of Thevenin's Theorem compare with the DC version? 2. Would the Thevenin…

A: This question is related to Ac thevenin equivalent circuits

Q: The causation of the a in the waveform of the full controlled full wave rectifier is OThe resistive…

Q: 115 volts 60 cycle source is connected to series CKT, consisting of a fixed resistor and an…

A: In this question, We need to determine the resistance and inductance of the impedance coil. We…

Q: The following circuit shows a discrete common source M The MOSFTE is n-channel MOSFET. The…

A: d) & e)

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

The efficiency of the I.M of the same
:rating as transformer is
.Higher than that of transformerO
.Equal to that of transformerO
Less than that of transformer O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In developing per-unit circuits of systems such as the one shown in Figure 3.10. when moving across a transformer, the voltage base is changed in proportion to the transformer voltage ratings. (a) True (b) False
With the American Standard notation, in either a Y-or-Y transformer, positive- sequen quantities on the high-voltage side shall lead their corresponding quantities on the low-voltage side by 30. (a) True (b) False
The ideal transformer windings are eliminated from the per-unit equivalent circuit of a transformer. (a) True (b) False
A bank of three single-phase transformers, each rated 30MVA,38.1/3.81kV, are connected in Y- with a balanced load of three 1, Y-connected resistors. Choosing a base of 90MVA,66kV for the high-voltage side of the three-phase transformer. spify the base for the low-voltage side. Compute the per-unit resistance of the load on the base for the low-voltage side. Also, determine the load resistance in ohms referred to the high-voltage side and the per-unit value on the chosen base.
An ideal transformer has no real or reactive power loss. (a) True (b) False
In per-unit equivalent circuits of practical three-phase transformers, under balanced thr-phase operation, in which of the following connect ions would a phase-shifting transformer come up? (a) Y-Y (b) Y- (c) -
Rework Problem 3.14 if the transformer is delivering rated load at rated secondary voltage and at (a) unity power factor, (b) 0.8 power factor leading. Compare the results with those of Problem 3.14. -
For an ideal 2-winding transformer, the ampere-turns of the primary winding, N1I1 is equal to the ampere-turns of the secondary winding, N2I2 (a) True (b) False
For an ideal transformer, the efficiency is (a) 0 (b) 100 (c) 50
For developing per-unit equivalent circuits of single-phase three-winding transformer, a common Sbase is selected for all three windings and voltage bases are selected in proportion to the rated voltage of the windings (a) True (b) False
The ratings of a three-phase, three-winding transformer are Primary: Y connected, 66kV,15MVA Secondary: Y connected, 13.2kV,10MVA Tertiary: connected, 2.3kV,5MVA Neglecting resistances and exciting current, the leakage reactances are: XPS=0.09 per unit on a 15-MVA,66-kV base XPT=0.08 per unit on a 15-MVA,66-kV base XST=0.05 per unit on a 10-MVA,13.2-kV base Determine the per-unit reactances of the per-phase equivalent circuit using a base of 15 MVA and 66 kV for the primary.
A single-phase l0-kVA,2300/230-volt,60-Hz two-winding distribution transformer is connected as an autotransformer to step up the voltage from 2300 to 2530 volts (a) Draw a schematic diagram of this arrangement, showing all voltages and currents when delivering full load at rated voltage. (b) Find the permissible kVA rating of the autotransformer if the winding currents and voltages are not to exceed the rated values as a two-winding transformer. How much of this kVA rating is transformed by magnetic induction? (C) The following data are obtained from tests carried out on the transformer when it is connected as a two-winding transformer: Open-circuit test with the low-voltage terminals excited: Applied voltage =230V, input current =0.45A, input power =70W. Short-circuit test with the high-voltage terminals excited: Applied voltage =120, input current =4.5A, input power =240W. Based on the data, compute the efficiency of the autotransformer corresponding to full load, rated voltage, and 0.8 power factor lagging. Comment on why the efficiency is higher as an autotransformer than as a two-winding transformer.