The velocity of a flow is given as V=-x² i+ (x + 2y) j. where V is in ft/s and X and y are in ft. • What is the volumetric strain rate at X = 0, y = 0? What is the vorticity at X = 0, y = 0? Air at 80° C and standard atmospheric pressure flows through a round pipe 40 cm in diameter at a speed of 9 m/s. • What is the mass flow rate of this air flow?

The velocity of a flow is given as V=-x² i+ (x + 2y) j. where V is in ft/s and X and y are in ft. • What is the volumetric strain rate at X = 0, y = 0? What is the vorticity at X = 0, y = 0? Air at 80° C and standard atmospheric pressure flows through a round pipe 40 cm in diameter at a speed of 9 m/s. • What is the mass flow rate of this air flow?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Assume the following standard values if not provided with the problem statement • Air o p = 1.2 kg/m³ μ = 1.8 x 10-5 kg/(m s) • Water o p = 1000 kg/m³ o μ = 0.001 kg/(m s)
The velocity distribution in a 0.02 m diameter horizontal pipe conveying carbon tetrachloride (specific gravity = 1.59, absolute viscosity = 9.6 x 10-6 Pa sec) is given by the parabolic equation: v(r)=0.01(0.12- r?), where v(r) is the velocity in (m/s) at a distance r in (m) from the pipe center. What is discharge? O a. 3.13 x-8 m3/s O b. None of the mentioned O c. 1.047 x 108 m3/sec O d. 4.97 x 109 m3/sec
An incompressible fluid (kinematic viscosity, 7.4 x10-7 m²/s, specific gravity, 0.88) is held between two parallel plates. If the top plate is moved with a velocity of 0.5 m/s while the bottom one is held stationary, the fluid attains a linear velocity profile in the gap of 0.5 mm between these plates; the shear stress in Pascals on the surface of top plate is rt of this book may be repro
Oil flows through a smooth pipe of diameter D = 4 cm between points (1) and (2) that are 4 m apart at a flow rate Q = 40x 10° m/s. The pressure at the lower end is 400 kPa and the pipe is inclined at 0 = 30 degrees. Consider dynamic viscosity u = 0.40 kg/(m s) and density p= 900 kg/m for the oil. 1 Calculate the pressure P in Pascals when the flow is upwards 2. Calculate the pressure P in Pascals when the flow is downwards D.
Q.2 An incompressible fluid (kinematic viscosity, 7.4x10-7 m2, 7.4×10 m/sec, specific gravity, 0.44) is held between two parallel plates. If the top plate is moved with a velocity of 0.5 m/s while the bottom one is held stationary, then fluid attains a linear velocity profile in the gap of 0.5 mm between these plates. The shear stress (in Pascals) on the surface of bottom plate is 2 0.3256 N/m A 0.4256 N/m C 0.5256 N/m2 2 D 0.6256 N/m
338 B/s O 1: 56% E 3:01 Question: Gasoline is flowing through this 180° pipe bend. The pipe cross-sectional area is 18 in?. Take the pipe weight as 5 Kg. Flow rate is 0.5 liters/s. Pressure at section-1 6 psia, pressure at section-2 is 4 psia. Calculate the anchoring force required to hold this pipe and also show its direction, referenced to proper 2-dimensional a cartesian coordinate system. (2 1
At a point in a pipe that lay flat ノ water in the pipe flows at a speed of 9.0 mls and has 6-40x 104 Pa a gaoge pressure is Find the gauge pressure at point 2 of pipe that lower than the first point 8.0 m and the cvoss - se ctional| area of the pipe is double of first point . Answer [1.52x105 Pa]
m. A piston having a diameter 0.15 m and a length of 0.25 m as shown in figure (1.2) slides downward with a velocity (V) through a vertical pipe. The downward motion is resisted by an oil film between the piston and the pipe wall. The film thickness is 5*10° m, and the cylinder weighs 2.22 N. Estimate V if the oil viscosity is 0.016 N.s/m². Assume the velocity distribution in the gap is linear. 2. Figure (1.1) W D Figure (1.2) Scanned with CamScanner
An incompressible fluid (kinematic viscosity, 7.4 x10-7 m²/s, specific gravity, 0.88) is held between two parallel plates. If the top plate is moved with a velocity of 0.5 m/s while the bottom one is held stationary, the fluid attains a linear velocity profile in the gap of 0.5 mm between these plates; the shear stress in Pascals on the surface of top plate is (a) 0.651 x 10-3 (c) 6.51 (b) 0.651 (d) 0.651 x 103
QA An incompressible fluid (kinematic viscosity, 7.4 x10-7 m2/s, specific gravity, 0.88) is held between two parallel plates. If the top plate is moved with a velocity of 0.5 m/s while the bottom one is held stationary, the fluid attains a linear velocity profile in the gap of 0.5 mm between these plates; the shear stress in Pascals on the surface of top plate is (a) 0.651 x 10-3 (c) 6.51 (b) 0.651 (d) 0.651 x 103
A wind tunnel has an incompressible flow of air, flowing horizontally from an inlet section, 7 times the test section. A u-tube is connected, having mercury inside. The mercury's specific weight is 1.33x10^5 N/m^3. Air condition at the inlet section is 1 atm and 280K respectively. Solve for the change in height inside the mercury if the velocity at the throat is 70m/s.
A constant-thickness film of viscous liquid (SG = 0.8, μ = 0.5 Pa-s) flows down an inclined plate an angle of 10⁰ as shown in the figure The velocity profile is given by the equation, u(y) = Cy(2h — y). If the value of his 5 cm, what is the value of the maximum velocity in m/s? NOTE: The pressure does not vary along the flow direction. u(y) Answer: