Three cable tensions AB, AC and AD act at the top of the flagpole. It the resultant for the three tensions is R= - 400 kN; a) Betermine the magnitude of the cable tension AB in kN. b) Determine the magnitude of the cable tension AC in kN. c) Determine the magnitude of the cable tension AD in kN. A 12m 4m X. C lom

Three cable tensions AB, AC and AD act at the top of the flagpole. It the resultant for the three tensions is R= - 400 kN; a) Betermine the magnitude of the cable tension AB in kN. b) Determine the magnitude of the cable tension AC in kN. c) Determine the magnitude of the cable tension AD in kN. A 12m 4m X. C lom

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.31P: Resolve the 360-lb force into components along the cables AB and AC. Use =60 and =40.

See similar textbooks

Similar questions

Find the internal force systems acting on sections 1 and 2.
1.) Find the sum of the vertical forces in pounds if F1 = 30 lb at 60 deg N of W and 50 lb at 40 deg S of E. 2.) Find the resultant force if F1 = 20 N south and F2 = 30 N west.
= 500N 35 F, = 600N --> F, = 200N b) Find the magnitude R of resultant force R. c) Find Rx ad Ry components of the resultant force R. F,
600 N 800 N to 1 m 1m 2 m Ax- 5. 3 900 N. m FBC A, iv) Examine the solution from the calculation if this magnitude is obtained based on the above FBD (Answers are more than one). Ах -3.13 kN = O a. The direction of magnitude Ax is to the right. b. The 3.13 kN of force at point A is exerted at the y component. U c. The direction of magnitude Ax should be to the left. O d. The 3.13 kN of force at point A is exerted at the x component.
Answer the following. 1.) Determine the resultant force if F1 = 120 lb at 60 deg N of W, F2 = 100 lb southeast. 2.) Find the magnitude of the resultant force if F1 = 50 lb at 35 deg S of W and F2 = 40 lb at 25 deg N of W.
Question 2: The right angle pipe OAB is shown below. Cable BC carries a tension of 750 N. a) Write this tension as a force T acting on point B in terms of the unit vector i, jand k. b) Replace the 750 N which the cable exerts on point B with a force-couple system at point O. 1.2 m- 1.6 m 0.7 m 30° 0.8 m
p 0::V * Asiacell liı. Homework#1... Homework: Four forces act on bolt A as shown. Resolve each force into rectangular components F = 80 N 20이 F = 150 N 30° A 15° F 100 N x VF = 110 N
o STATIC MONT... Find the resultant force of the following? B, 2 m F = 600 N 3.5 m 0.5 m F- 450 N 1.5 m 1m 1.5 m 0.5 m y
Q2: Two cables which have known forces are attached to the top of the transmission tower at 20 A. Determine the required tension T in the guy 5 kN cable AB such that the net effect of the three 4 m 10 kN cable tensions is a downward force at point A. Determine the magnitude of the resultant. 3m (20 Degree)
Q3: The vertical force R is the resultant of the three forces acting on the bent bar. Determine P, P2, and R. C_2 m D 30° 1.5 m P2 1.5 m 2 m 2 m B 100 kN
The weight of the car is 5 KN, if the area of piston A is 3 cm“, the area of piston B is 60 cm", Find the force applied on piston A. Select one: O a. 0.25 KN O b. 250 KN O c. 2.5 KN O d. 25 KN
b) The steel Cable AB and AC are attached to the top of the transmission tower. The tension force in cable 40 m AC is 8 kN. Determine the required tension force in Cable AB, such that net effect of the two cable tensions is downwards force at Point A as shown in 20m the figure. Then determine the magnitude force R of these downwards forces? 00 m