Time left 0:22:28 Air enters a compressor with h₁ = 378.7 kJ/kg and exists with h₂ = 7134 k/kg Steam enters a turbine with the shown conditions and exis's the turbine with quality x = 15%. If 13.4% of the turbine power is used to drive the compressor and the rest of the turbine power is used to drive an electrical generator that needs 1.35 MW, what is the mass flow rate of the air (kg/s)? Note: Enter your answer. I MPa 10.0MP 700°C Answer: > < Air compressor 08 LP

Time left 0:22:28 Air enters a compressor with h₁ = 378.7 kJ/kg and exists with h₂ = 7134 k/kg Steam enters a turbine with the shown conditions and exis's the turbine with quality x = 15%. If 13.4% of the turbine power is used to drive the compressor and the rest of the turbine power is used to drive an electrical generator that needs 1.35 MW, what is the mass flow rate of the air (kg/s)? Note: Enter your answer. I MPa 10.0MP 700°C Answer: > < Air compressor 08 LP

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Similar questions

You have invented a hydrogen‐fueled turbine engine that operates between a combustion temperature of 2500. K and an exhaust manifold temperature of 500. K. How much work does it produce per kilojoule of fuel energy if it operates at 75% of maximum theoretical efficiency?
Q1 / A: Derive the steaay flow energy equation and reduce it for: a. A turbine ( Reversible Process) b. A pump ( Reversible Process) c. A nozzle ( Reversible Process) d. A throttling ( Irreversible Process) Assume that the working fluid is an ideal gas and the entrance and exit are at the same level. B- For a reversible adiabatic process prove the equation pvr = constant can apply for the relation between pressure and specific volume for a perfect gas. %3D
Carnot engine absorbs 300 J of heat from a reservoir at the temperature 373.15 K and rejects heat to a reservoir at the temperature of the triple point of water ( T2 = 273.16 K ) Find the heat rejected, the work done by the engine and the thermal efficiency.
Q1: A heat engine used a steam as working fluid has 3 kg/s and initial the steam undergoes to expansion process is 8 bar, dryness fraction (32) percent, and the expansion follows the law (PVL-C), down to a pressure of 0.3 bar. Calculate the change of entropy of steam during the process. . ,.¢
5. A single row impulse turbine receives 3 kg / sec steam with a friction etc amount to 15 KW, determine the blading efficiency and the blade velocity coefficient. The nozzle angle is 16° and the blade exist angle is 17°
Ans. 3908 m/min. 14.5 Find the cylinder dimensions of a single-cylinder, double-acting compressor handling 28.32 e/revolution of air from 99.975 kPaa to 723.954 kPaa. Compression and reexpansion are in accordance with PV135 = C. Use the conventional volumetric efficiency; c = 5% and L/D = 1. %3D %3D
(17 blanks) Calculate the efficiency of the Carnot Engine for ideal gas. Consider the figure below for a complete cycle of Carnot engine, where the cycle goes from ad->ab->bc->cd Carnot cycle Он TH Tc - V 02016 Pearson Education, Inc. processes: processes and segment ab & cd are the Where segments ad & bc are the and the volumes involved are Va, Vb, Vc, Vd, and the two temperatures TC and
A stationary diesel engine with a thermal efficiency of 40% produces 200 horsepower. The exhaust gas, which we suppose is air, has a velocity of 1400 R, whereas the intake has a velocity of 520 R. What is the mass flow rate if it accounts for half of the Q ?
Steam engine with incomplete expansion receives saturated steam at 1.04 Mpa,expands it to 0.105 Mpa where release occurs. Exhaust is to a condenser at 40C.The actual engine uses 6070 kg/h of steam; it has a brake engine efficiency of 60%and a mechanical efficiency of 85%. The electric generator which it drives has anefficiency of 925. (a) For the ideal engine, find the thermal efficiency and the mep.For the actual engine, determine (b) the brake work in kW and the brake thermalefficiency, (c) the indicated work in kW, indicated thermal efficiency and indicatedsteam rate, (d) the combined thermal efficiency and the combined steam rate
.The thermal efficiency of a heat engine is 30%, the heat rejected from the engine is 30kJ, evaluate the heat input to the engine.
1. An engine from a quarry vehicle used in the Build a Beach program of DEMR has a power requirement of 560 kW. Per hour of its operation, it ejects 234 MJ into its surroundings at 50 °C. If it behaves like a Carnot engine, answer the questions below. A. How much work (MJ) is done by the engine per hour of operation? B. What is the efficiency (%) of the engine?C. What is the temperature (°C) of the hot reservoir? 2. Determine the entropy change (kJ/K) associated to the conversion of 10 kg of ice at -11 °C to steam at 121 °C. 3. Anna and Beth are using another rare metal, the nth metal (c = 0.600 J/g-℃), to build the 5-kg cuirass of their design. Initially, the metal is at 2250 K. It is then submerged to 10 kg of water at 15 °C. If the remaining liquid water after submerging the metal is 8.5 kg, solve for the net entropy change (kJ/K) of the system.
ft3 min 5. A two-stage compressor receives air at 100 at 10psia and the discharge pressure is 200 psia. If the temperature of the air received is 50F, find the intercooler pressure, total compressor work and total heat rejected at the intercoolers. 44.72psia; 16.31 hp; 345.80 Bu min