9. Find the poles of the state space system; is this system stable? Explain. [₁] [2²³=12²dt X₂10. Find poles of the discrete time system; is it stable? Explain. [X₁ (+1)] = [0.¹[x₁(k+1)][*] + [2] »11][2₂] + [u(k)

As per Bartleby policy we can answer only one question at a time. As you have not mentioned any…

Answered: u 9. Find the poles of the state space…

Engineering

Electrical Engineering

u 9. Find the poles of the state space system; is this system stable? Explain. [2] = [2²³][2]+9₁ dt

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.22P

See similar textbooks

Related questions

Q: A balanced delta-connected load with impedance per phase of 30/30° is connected to an abc-sequence…

Q: jt 1 The Fourier transform of [e 2 x(t + =)] is +is

Q: 1. A single-phase induction motor is rated 5hp, 75% power factor and 220 volts. What is its full…

A: Single phase induction motor power = 5hp =5×746= 3730watts power factor =0.75 voltage =220 volt…

Q: 1- What will happen if the primary of a transformer is connected to d.c. supply? I ist four…

A: Note : According to the guidelines of the company we supposed to answer only first question please…

Q: e switch in Fig. 1 has been closed for a long time, and it opens at t = 0. Find v(t) for t≥ 0. I=(0)…

Q: - 2. Determine the line currents for the three-phase circuit shown below. Let Va = 11020°, V₁ =…

Q: QUESTION 5: Figure 13.7 shows reference circuit and gain stage of 741 op-amp. Given that ß- 197 and…

A: Given,For the circuit,β=197IREF=0.771 mAVBE=0.6 VQ13B =34Q12

Q: Q2/ Find the state-space representation of the electrical network shown in Figure 3.8. The output is…

A: The state space analysis of the given circuit can be obtained by assuming the state to the elements…

Q: e. The value of the inductor

Q: Determine the following in Combination network. Draw the ac euivalent circuit. Zin Zo Av Ai Vo

A: The dc analysis of the circuit will be Gate voltageVG=10k50k×16VG=3.2VVoltage at emitter terminal…

Q: Example 1: Find the Energy of the signal x(t) = e-tu(t) using the energy formula and proof that…

Q: A balanced delta-connected load with impedance per phase of 30/30° is connected to an abc-sequence…

Q: In a balance three-phase system, the source has an abc-phase sequence and is connected in delta. The…

Q: H. w: find (VS), Io= 2 mA in the circuit infig Kirchhoffs Law? 1 KM ли 2K₁10Ka Vs t быка VI.

Q: Find the transfer function, ?(?) = ?2(?)/?(?), for the translational mechanical network shown below.…

A: In this question we will find transfer function of given translational mechanical system....

Q: Find the z-transform of the signal x[n] = (-1)^u[n] + ( )¹u[−n − 1]. a. x[n] does not have a…

Q: A factory has an electrical load of 1600kW at a lagging power factor of 0.8. An additional variable…

Q: A B C D F G

Q: carrier is modulated by three audio tones. If the modulation indexes for the tones are 0.3, 0.4, and…

Q: (₂ X(s) For the given system, find: 1- Transfer function H(s). 2- Differential equation. -2t 3-The…

Q: √2 (s -√2)² + 2

Q: d) A radio antenna pointed in a direction of the sky has a noise temperature of Ts = 50 K. The…

A: Given Parameters of an amplifier and a pre amplifier. We need to determine the output noise power…

Q: The rotor of 220-V, 60 Hz, 4-pole induction motor has a power input of 80kW is observed that the…

A: To find the gross mechanical power developed If an induction motor takes power input of 80 kW and…

Q: Question: Find the range of (K). For the Stability of the system with characteristic. equation 3…

Q: A square-wave inverter has a dc source of 125 V, an output frequency of 60 Hz, and an RL series load…

A: ''Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 8: Optimize the following Boolean functions F together with the don’t-care conditions d: (a) F(A, B,…

Q: Determine Yeq for the circuit below

Q: Draw the circuit of a voltage supply comprised of a full-wave bridge rectifier, capacitor filter and…

A: Given We need to construct a circuit to provide an output of 12 V ,using a full-wace bridge…

Q: 9. As a coil in an AC generator rotates in a magnetic field, it reaches the position shown in the…

Q: A54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is…

A: In this question we will find total inductance of single phase line.....

Q: A three-phase source has a phase sequence of EAB - EBC - ECA and delivers the following delta load…

Q: Calculate V1 using node analysis for the following circuit. circuit sources are voltage the…

Q: Compute the value of R that results in maximum power transfer to the 15- resistor of the following…

Q: Given that the signal u(t) can be represented as 1 g(t) = (1 + sig(t)), where sig(t) is the signum…

Q: A balanced delta-connected load with impedance per phase of 30/30° is an abc-sequence balanced…

A: In this question we need to find a line current , load phase current and total complex power.

Q: Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and…

A: Power Triangle is the right angle triangle it represent the reactive active and apparent power .…

Q: If e = 100sin(wt+30°) - 50 cos 3wt + 25 sin(5wt+150°) in = 20 sin (wt+40°) + 10 sin (3wt + 30°) - 5…

Q: 12V 41 YA 3k -11L 24 To Yh m

Q: A Req ? 2 Ω 2 Ω M 4 Ω Μ 2 Ω 4 Ω Μ 1Ω M B 1.6 Ω ΣΩ 3 Ω

A: The given problem is from circuits. The calculation is shown in the next step

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: Phase sequence:- Three phase sequence have same magnitude and phase difference by each other by 120…

Q: . An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: This question is related to 3 phase circuut analysis

Q: b) The step response of a second order system is shown in Figure Q6. Magnitude 3₁ Result of…

Q: B: Find Fourier transform of the following signals: 1. y(t) = cos(2л(t+1)) jst 2. s(t) = ei³t…

Q: VIVA QUESTIONS: 1. What is rectifier? 2. What is filter? 3. Define Ripple factor? 4. How capacitor…

Q: 1 [.T[Sincrot] fourier transform

Q: For the system represented by the block diagram shown in the fig 1, determine C₁/R₁ and C₂/R₁. R₁ C₁…

A: Calculate transfer funtion first draw signal flow graph of the system apply mason's gain formula…

Q: 1) A A- A bank consisting of three 20-kVA, 2300/230-V transformers supplies 40 kVA. If one…

A: In this question open delta connection is given....We have to find out kVA load supplied by each…

Q: Basic Electrical Engineering Simulate the circuits shown using Multisim. Copy and paste the…

A: The required current value can be calculated by using the nodal analysis.

Q: T B-two transformers A and B are connected in parallel to a load ot (2+j1.5). Their impedances in…

Q: Solve for Vo 4/-90° V

Question

9. Find the poles of the state space system; is this system stable? Explain. [₁] [2²³
=12²
dt X₂
10. Find poles of the discrete time system; is it stable? Explain. [X₁ (+1)] = [0.¹
[x₁(k+1)]
[*] + [2] »
11][2₂] + [u(k)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. Should real time instruments like multi-meters be time invariant? a) Never b) Sometimes c) Yes d) They have no relation with time variance
Q1) 1-In your own words and no more than three lines, explain the main difference(s) between Gauss's law and other integral-differential equations. 2-In your own words and no more than two lines, explain the main difference(s) between Coulomb's law and other laws. (3.5
discret-time x[n]=(1/5)n.u[n+4] mark defined as calculate Total Energy ?? thank you:)
1. The following questions concern plotting of signals. (a) Find the equation: Note the signal keeps continuing to the right off the graph as it is right before t = 6. (b) Find the equation: Note: The curved part between 2 and 4 seconds is a form of a cosine function.
Problem1. Consider the following system * = [ y = [-2 3]x – 2u Is the system BIBO stable? Is the state equation marginally stable or asymptotically x + stable?
A 7775 4777 B 7025 47025 D 7025v 47O 25v E Capacitors A-E 2. Look at the picture above. Which capacitor do you think will hold the most charge? Why? 3. Describe simply how a capacitor works. What can a capacitor be compared to?
Photos - 265121502_2337735863035096_3568501418110557974_n.png 106% A See all photos + Add to * Edit & Create v IA Share Problem #2: Assume that the circuit has been connected for a very long time. (Note: x = 2 (a) As time approaches infinity, what will happen to the capacitor and inductor? (b) From your answer in (a), draw the equivalent circuit (label appropriately) (c) From your circuit in (b), determine the "steady-state" or “final" values of vc , ic , iL and v̟. 10 A 4 ΚΩ 5 ΚΩ lie + + x A( 3 μF 1 ΚΩ 2 ΚΩ Vc VL 4 nH Maximum size for new files: 10M of
c) Represent the following signal in Figure Q1(c) in terms of sum of singularity function and sketch its integration. x(t) 1 3 8. Figure Q1(c)
9.pdf - Adobe Acrobat Reader DC (64-bit) ndow Help FINAL EP QP_SEM . x Sign In 10 / 12 116% Search Combine PDF Export PDF A capacitor is charged with 50 mC in a time of 20 uS. If the energy stored in the capacitor is 5 J, Edit PDF find (i) voltage across the capacitor, (ii) current through the capacitor and (iii) value of capacitance. Create PDF EComment Combine Files E0 Organize Pag Delete, insert, extract and rotate pages. Try now Convert, edit and e-sign P
Consider the following circuit, select the correct statement(s) below.. D Λ D Q x3 Clock 0 Q The shortest clock duration is determined by TcQ_min +su +TOR- The shortest clock duration is determined by TCQ_max +tu+TOR The shortest clock duration is determined by TcQ_max +tu+TAND We don't need to worry about the hold time requirement th.
Classify the time invariancy property of the following system with graphical representation: (i) y(n) = nx(n-1). (ii) y(n) = x(2n-1). For graphical representation. let x(n) = (0,1,2,1,0).
Problem 5 Consider the signal y(t) in figure 2. a- Sketch y(t) using appropriate step and ramp functions with appropriate amplitudes, slopes and delays. b- Find y(t) 2. 3. 4 5. 6. Figure 2