V, A F - (1-a)A

Q: If block A of the pulley system is moving downward at 6 ft/s while block C is moving down at 18…

A: Given, vA=6 ft/svC= 18 ft/s

Q: Problem # 8: The five forces acting at the end of the boom satisfy the condition of equilibrium.…

A:

Q: If the 80kg cabinet is allowed to roll down the inclined plane, determine the acceleration of the…

A: m=80kg To find normal reaction at A and B

Q: 2. A closed tank mounted on a truck Sm long, 2.50m wide, and 2m high is transporting 5/6 full of 850…

A: Fluid mechanics manages the progression of liquids. Its review is essential to physicists, whose…

Q: A circular gate 2 m in diameter is inclined at an angle of 30 degrees from the horizontal. Fresh…

A: Given,

Q: 3 k/ft A В C 24 ft 9 ft BEAM 3

A:

Q: Situation 7: Considering the same figure as above, the towline exerts a force P =4 kN at the end of…

A:

Q: 30 KN 25 KN/m 10 kN/m 10KN/m 20 kN-m 5 kN-m 2 m 20 KN 2 m 2 m 2 m Ay in kN (if it is going upward…

A:

Q: w (kN/m) L (m) If L=12m and w-18 kN/m, calculate the vertical reaction at A, kN I Select] B, kN…

A:

Q: Water flows inside a pipe and exits to the atmosphere at an average velocity of 3 m/s as shown. The…

A: Given-  Average velocity Vavg=3m/s       Diameter of pipe (d)=0.1m       Inclination angle θ=10°

Q: When acted upon by the forces Fand F2, the 40-kg slider block moves to the right with a speed of 1.5…

A: Given: Mass of block= m= 40kg, Speed of box to the right = v1 = 15 m/s To find: Speed of box at t =…

Q: Q57. A jet of water of 30 mm diameter, moving with a velocity of 15 m/sec, strikes a hinged square…

A: We will solve this question by using the equilibrium equations. Vertical forces equations in the…

Q: The horizontal force P = 64 N is applied to the upper block with the system initially stationary.…

A: Given that,  P = 64 N mA = 18 kg mB = 7 kg μ1=0.29 μ2=0.5

Q: Consider water flow through a horizontal, short garden hose at a rate of 43 kg/min. The velocity at…

A: Given: m .= 43 kg/min, Vin = 1.1 m/s, Vout = 18m/s,  momentum flux correction factor, ϐ = 1.08

Q: B = 45°/ 30 D The extremities of a 4-ft rod weighing 50 lb can move freely and with no friction…

A:

Q: 3. For the system forces shown, solve the following: (the coordinates are distance in meters from…

A: Given  Forces F1 , F2 , F3 , F4 and their coordinates ..     Clockwise moments = negative…

Q: In the figure, suppose that 0 = 30°, V1 = 100 ft/s and the stream is a jet of water with an initial…

A: ρw = 62.427lb/ft3  V1 = 100ft/s V2 = 95ft/s Q = V1 x A = 100xπ/4x(2/12)2 = 2.18166ft3/s

Q: 3. Equal volume of two liquids of densities p1 and p2 are poured into two identical cuboidal…

A: Given:- The two liquids of equal volume are poured into two identical cuboidal beakers The density…

Q: Calculate the support reactions of the system given below a) Calculate the values of M1, N1 b)…

A: Draw FBD:

Q: End A of the 6kg uniform rod AB rests on the inclined surface, while end B is attached to collar of…

A: draw the Free body diagram of rod

Q: A vessel is filled with oil (ρoil = 900 kg/m^3) up to 1 m of its height. It is 3m wide, 2m high and…

A: Given Data: Density of oil is ρo=900 kg/m3. Height of oil in tank is h=1 m. Width of the tank is B=3…

Q: A vessel is filled with oil (ρoil = 900 kg/m3) up to 1 m of its height. It is 3m wide, 2m high and…

A: Density of oil = ρo= 900 kgm3   Height of oil in tank = h = 1m   Width of tank= B = 3m   Height of…

Q: A rectangular tank 6 m long, 3 m wide and 2m deep contains water to a depth of 1 m. It is…

A: Given data : Length (L)=6 mWidth (W)=3 mDepth of tank=2 mWater depth =1 mAcceleration (a)=2.5…

Q: 2. The propulsive force drives the jet in the a) Backward direction b) Forward direction c)…

A: Propulsive force is the force generated due to the change in momentum of a fluid flowing through a…

Q: Determine the mass of the beam in pound per foot (lb/ft), given the following reaction at point D.…

A: Given,  It is A beam which is Extended into a wall support.  It is Given as moment at D = 148kips-ft…

Q: A two-dimensional diverging duct is being designed to diffuse the high-speed air exiting a wind…

A: Given:-  Axial wind speed u at section 1 (u1) = 300 m/s  Axial wind speed u at section 2 (u2) = 100…

Q: Determine the reaction at the smooth wall. The top of the 15-kg ladder is leaning against a very…

A:

Q: Problem 2 Given: 0.75 m 10.4 m Mass of car: 1400 kg ism- D B C -2 m- Mass of trailer: 800 kg 2 m-…

A: Fig 1..

Q: With reference to the figure below, the total force (F) of the liquid on the plane surface and the…

A:

Q: Problem (1) The desk has a weight of 75 lb and a center of gravity af G. Determine the initial…

A: Solution: Force required to start desk moving; ∑Fx=0F Cos…

Q: Body A has a mass of 25 kg and body B has a mass of 50 kg. The coefficient of friction for all…

A:

Q: When the angle θ = 90 °, the BE hydraulic cylinder applies a vertical force (F = 3330 N) Newtons to…

A: Solution: Draw the free body diagram at angle θ The accleration in n-t coordinate is…

Q: RESULTANT F1 = 10 KN F2 = 20 KN F2 1 m AND F1 1 m MOMENT F3 F3 = 30 KN F4 = 50 KN F5 = 50 KN PROBLEM…

A:

Q: The vertical side of an oil tank is 3.6 m wide and the depth of the tank is 2.4 m. Calculate the…

A:

Q: The extremities of a 4-ft rod weighing 125 lbf can move freely and with no friction along two…

A: Based on the kinematics of the constrained motion, express the accelerations of A, B, and G in terms…

Q: 2. In Fig. P-226 assuming counterclockwise moments as positive, compute the moment of force F = 200…

A: Given data,  F = 200 kg P = 165 kg   To find out the moment of force about point A, B, C, D.

Q: く.S A 3m 50

A:

Q: 3..A2.44m diameter cylinder weighs 227.3 kgf and rest on the bottom of a tank that is 0.91m long.…

A:

Q: Determine the magnitude (N) of the horizontal component of the reaction at point A if, F=492N,…

A:

Q: A cantilever beam 5 m in length is to support a downward concentrated load of 100N. Calculate the…

A:

Q: A tank containing water moving horizontally with a constant linear acceleration (3.5m/sec2), and…

A: Given Above data we have to find force at the bottom of the tank

Q: PROBLEM No. 2 Two steel pipe columns (E = 200,000 MPa, A1 = 1800 mm², A2 = 2000 mm²) support a rigid…

A:

Q: A semi-cylindrical concrete structure having a radius of 3 m and length of 5 m is rested on ground.…

A:

Q: B = 45° 30° D The extremities of a 4-ft rod weighing 50 lb can move freely and with no friction…

A:

Q: With reference to the figure below, the total force (F) of the liquid on the plane surface and the…

A:

Q: - Problem 2 OA holds a cylindrical weight of 10-lb at B. OA rotates at 1.5 rad/sec as shown.…

A: calculation of r: r=4cosθ=4cos30o=4.619 ftdifferentiate function of r with respect to…

Q: Two blocks (A and B) are colliding as shown below. Block A is 15kg and Block B is 10kg. Given that…

A:

Q: A closed cylindrical drum is 30cm in diameter and 50cm high as shown, contains a liquid (SG liquid =…

A:

Q: w (kN/m) A L (m) If L=12m and w=18 kN/m, calculate the vertical reaction at A, kN [Select] B, kN […

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.