+ V1 30 V R1 10 Q ww R2 R3 302 1+ V2 18 V ww R4 ww R5 202

Q: 13. If you used 600 W of power for 60 h, you have used A. 36 kWh B. 3.6 kWh C. 10 kWh D. 1 kWh

A: Given data, Power P = 600 W. Time t = 60 h

Q: Consider an LTI system with impulse response h₁ [n] = {(a)", 0≤n≤N otherwise with 1 < a <∞. Which of…

A: According to the question, Then, we need to choose the correct option

Q: B/A 3 phase, 460v, star connected, 1740 rpm, 60Hz, 4-pole, SRIM. Have the following parameters per…

A: A 3-phase induction motor is an electromechanical energy converter that transforms electrical power…

Q: A sine wave has a positive going zero crossing at 0° and an rms value of 20 V. What is its…

A: We need to find out the value of sine wave at given angle , first we will find out peak value then…

Q: An electric heater consumes 3.6 MJ when connected to a 250V supply for 40 minutes. Find the power…

A:

Q: A single wattmeter is connected to measure reactive power of a three-phase, three-wire balanced…

A: given: IL = 17AVL = 440voltWattmeter Reading = 4488 VAR Find: Power factor of Load = ?

Q: A wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A.…

A: DC current IDC = 20 A AC current IAC = 20 A We have to find the rms value of the resultant current…

Q: Solve the following using the Laplace definition only, do not use shortcuts/given properties 1.…

A: By Laplace's definition we have: Lft=Fs=∫0∞e-st ftdt where f(t) is the given function in terms of…

Q: a R1 b. E R2 n the circuit depicted above; the switch was initially at position (b) for long time.…

A: The circuit diagram is, R1=1.8 kΩ, R2=1.5 kΩC=4.8×102 μFE=6 V

Q: Consider an air-gaped parallel-plate capacitor (you can use fo=8.85 x 10-12 c²/(N-m²)). The…

A: Given: A parallel plate capacitor with air gap between plates has, Permittivity of the air,…

Q: 9. Find the value of VA in the circuit using: a. Mesh Analysis b. Nodal Analysis 10 V + 2 ΚΩ m VA 5…

A:

Q: a. What is the value of Egap (in eV)? b. Is the material a direct or indirect band-gap…

A: Given:

Q: Resistance of 220 V, 100 W lamp will be (α) 4.84 Ω (b) 48.4 Ω (c) 484 Ω (d) 4840 Ω

A: Given, Power rating of lamp, P=100 W. Supply voltage, V=220 V.

Q: A coil has an inductance of 40 mH and negligible resistance. You must determine its inductive…

A:

Q: 3. Solve the equivalent resistance across: arand b band 60 30 m m 30 30 40 w m 30 20 60 m m 60 T 20…

A: A single resistance is referred to as the equivalent resistance if it can replace a group of…

Q: Obtain A) RT = B) I₁ = C) PT=

A: Given- Voltage source = 12 V  [Let it be VS] Resistances= 1ohm, 1ohm, 2 ohm, 2ohm, 4ohm, 4ohm, 3ohm,…

Q: A center-tapped 120/240 V secondary coil has the two parts of the coil inside the tank arranged in…

A: Given: A center-tapped 120/240 V secondary coil

Q: Determine Vo in the given circuit. Assume A = 20 22 and B = 16 0. B www 10 V(+ A The voltage Vo= Vo…

A: Given circuit,

Q: The digital output of a DAQ board is 0 V for false, 5 V for true. If the maximum current that the…

A:

Q: 2. Define ionizing power and penetrating power.

A:

Q: Example 15.17 A small 3-4 induction motor has a short-circuit current equal to 4 times the full-load…

A: Given- Small 3-ϕ induction motor, Short circuit current=4 times of full load current, full load slip…

Q: sinusoidal current has peak value of 12 A. What is its average value?

A: We need to find out the average of sinusoidal current .

Q: 7V ΤΩ 2 Ω 3Ω +7 A 20 2 Ω Σ1Ω

A: The mesh analysis is done as following.

Q: The Norton resistance for the circuit is Α) 500 Ω Β) 1.0 ΚΩ C) 1.5 kΩ D) 2.0 ΚΩ 101 R Μ 10120 1010…

A: Given data, Circuit diagram is given as,

Q: 2- A toroid of rectangular cross section as shown in Fig, 1 has d₁ = 12 cm, d₂ = 10 cm, t = 2 cm,…

A:

Q: 6.22 (Section 6.5). The current in a branch of a circuit is given by i(t) = ce-0.05t sin (0.4t+…

A: Given: it=ce-0.05tsin0.4t+0.5

Q: A real time signal's Fourier transform has magnitude and phase O Yes O No

A: Fourier transform is a tool to  define any time domain signal into frequency domain. Fourier…

Q: 2. The following values are to be stored in a single byte of computer memory. Provide the byte value…

A: This is a basic problem of digital logic. Here a single byte represents 8 bit data In signed…

Q: The phase angle of the current with respect to the voltage in the circuit shown in Figure 38 is A…

A: Given data, Circuit diagram is given by,

Q: The voltage source Vpc is skpplying 9.21 V in the circuit shown in the Figure below. The switch…

A:

Q: The voltage Vout in the circuit shown is 10Ω

A: Given data, Circuit diagram is given by,

Q: 2. Find the required items based on the given circuit using KCL.

A: Given- Current values- i1 = 10 A i3 = 3 A Resistance equivalent = 20 ohm To find- Node equation =?…

Q: The input signal Vin shown in the figure is a 1 KHz square wave voltage that alternates between +7V…

A: Given- 1KHZ square wave voltage, 50% duty cycle, To Find- The efficiency of the circuit.

Q: Consider the circuit system that can charge and discharge the capacitor. What is the steady-state…

A: We need to find out the voltage for given circuit

Q: 9. If the peak of a sine wave is 13 V, the peak-to-peak value is A. 6.5 V B. 13 V C. 26 V D. none of…

A: Given data, Peak voltage Vp=13 V.

Q: QA three phase, 440V, 4-pole, 50Hz, IM, has a star connected winding requires 19.68A- at full load…

A: Given: I=19.68A, s=0.03, pf=0.8, PNL=1200W, INL=6A, PF+W=300W,R1=0.8Ω perPhase.

Q: Section Attempt all objective questions of this section 1. For active mode of BJT, which one of the…

A: Given for active mode of BJT which one of the combination of biasing is correct. Electronics…

Q: A sawtooth voltage wave increases linearly from 0 to 200 V in the interval from 0 to 2 seconds. At…

A:

Q: If Timer 0 is placed in Counter mode as well as in 8 bit Auto reload mode. Timer 1 is placed in…

A: Give that Timer 0: Counter Mode, 8 it Auto reload mode mean’s Mode 2 programming Timer 1: Timer mode…

Q: A 250V series motor in which the total armature and field resistance is 0.150 is working with…

A:

Q: For the circuit in the given figure, use KCL to find the branch currents to 14. Assume A = 5 A, B =…

A:

Q: An RC circuit has an emf of 100 volts, a resistance of 5 ohms, a capacitance of 0.02 farad, and an…

A:

Q: At rated load, a shunt motor draws an armature current of 100 A from a 240 V source while running at…

A: Given: At rated load, Ia1 =100 A, N1=1000 rpm, E1=228 V.At no load, Ia2=5A, E2=235 V, N2=?

Q: ABCDX 0000 0001 001 0||0 0011 10 0100 0101 хо-ooo-oo 0 0 1 1 10 1 0 1 1 1 0 0 1 0

A: The question is about k map.

Q: A charged particle moves with a uniform velocity 4i m/s in a region where E = 20j V/m and magnetic…

A: Given a charged particle moves with, Uniform velocity, v=4i^ ms. At constant velocity, the…

Q: Current amplifier CATHR Source R₂ Load 1. Apply the current divider formula twice to derive an…

A:

Q: UJT, it turns off when the voltage at the emitter reaches a. turn off voltage, b valley voltage, c.…

A: PART-2 Answer  Valley Voltage EXPLANATION  When the voltage across…

Q: 4. Given the following Truth Table expression of the logic function F: W 0 0 0 0 0 0 0 0 1 1 1 1 1 1…

A: This is a problem of Boolean algebra. The detailed solution is given in the next step

Q: why is a single transistor AM circuit is not practical

A: 2) The question is about analog circuits with multiple transistors.

Q: Find the current flow of 10^22 electron in 1hour

A:

Current Division Method

The generalized current divider formula is given by the following relation below,