What is servo motor? And what is the operating principle of servo motor?

Q: Exercise 3 Let's consider the system with the open loop transfer function given by G(p)=- close loop…

A: given here a open loop transfer function and asked to find the closed loop transfer function.

Q: 1 The diodes in Figure 1 both have VON = 0.7 V. By using mesh analysis or otherwise, show that D, is…

A:

Q: Q2 A transmission line of 50 2 is terminated by a load impedance (10 + j40) 2. The distance between…

A: The given problem is from transmission lines.  The detailed solution is given in the next step

Q: A capacitor is initially charged to qo = 1 mC and placed in the circuit shown below. a) How many…

A:

Q: What are the sources of the noise in communication ?

A: Effect of Noise on communication Loss of Message content interference leads to changes in channel…

Q: Problem 4 Sinusoidal Steady State (SSS) via H(s) I. 125(5+400) 5(5²+2005 +10") Ig i(t) = 80 cos…

A:

Q: Given the admittances of the circuit as shown: Y1 = 0.2-j0.1 S Y2 = 0.125-j0.25 S Y3 = 0.2-j0.1 S Y4…

A:

Q: Give the network determine the input voltage Vs.

A:

Q: error ratio using masons gain

A: Given:  Required: Error ratio using Mason's gain formula.

Q: Obtain voin the circuit given below. Use R=1 k. 30 V 2 ΚΩ 20 V 5 ΚΩ The value of vo in the circuit…

A: Given: In this question, the given values are, The given resistance value is, R=1 kΩ. And the given…

Q: For the circuit shown. If I =20 20 A, R = 1492, Xc1 = -2j Q2, Xc2 = -5jQ2, XL1 = 7j92, and X₁2 = 1j…

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: A balanced wye-connected three-phase source has line-to-neutral of 220 Vrms. This source is applied…

A: It is given that: Vln=220 V=VphZ=20∥j15Z=20×j1520+j15Z=300∠90°25∠36.87°Z=12∠53.13° Ω

Q: What is the simple operational amplifier circuit for a constant current source? How does one set the…

A: An Ideal operational amplifier has a very high Common mode rejection ratio, Very high input…

Q: Question 5. digital system has Z transfer function G(z) nter a: nter k: nter 3: nter 1: = he input…

A:

Q: Find V1 when the magnetic flux density B= 0.3ta, is applied to a coil with a radius of 10 cm below.…

A: EMF Induced by the coil is calculated as E=d  (flux)dt=d  (B A)dt B= Magnetic flux density A= Area…

Q: Problem 02.016 - Kirchhoff 's Voltage Law Determine Vo in the given circuit. Assume A = 172 and B =…

A: We need to find out Voltage for the given circuit.

Q: You have four bulbs that are rated at 2V each with a resistance R. If a voltage greater than 2V is…

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in…

Q: 3. Using mason's gain formula find the overall transfer function for the signal flow graph shown…

A:

Q: 2. The rms value of the primary voltage, Vpri of a transformer with centre tapping in Figure 2 is…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one. 2. This is…

Q: Y = RV R₂ Vief We wish to have Vref = (4 ± 4%) V. We choose R₁ = (2210 ± 1%). 1. With the help of…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: 8. What is the Fourier transform of e-lt cos(t)? (A) 1 (B) (C) (D) 2 1+02² 1+02² 1 1+(2-1)²

A:

Q: In the circuit given below, R= 90 2. Calculate the mesh currents i and 12. R 10 92 40 V + % i₁ 310 Ω…

A:

Q: Example 4. The switch in Figure 16 is closed at t=0. Find i(t) and v(t) for all time. Note that…

A:

Q: A very short (1≤ 2/50) vertical electric dipole is mounted on a pole a height h above the ground…

A: Electric dipole An electric dipole is made up of two point charges that are equal and in opposition…

Q: 4-A rectangular loop of dimensions 1m by 2m lies in the z=0 plane in a uniform magnetic flux field B…

A:

Q: E "100 V T= 30 KO === 20 KO S vc (100ms) 10 ko Figure 18: What is the time constant value (TRC) What…

A: Time constant

Q: Exercise 6 Evaluate the density of charge carriers in intrinsic silicon at 300 K. We give Eg =…

A: According to the question,

Q: A capacitor, resistor of 10 , and an inductor of 70 mH are in series with an ac source marked 120 V,…

A: We are authorized to answer only one question at a time since you have not mentioned which question…

Q: unidirectional controllers and bidirectional controller. b) Define the synchronous tap changer. C)…

A:

Q: An LRC circuit is shown with an alternating source with a current given by i(t) = Icos(ot), with…

A: Given: In this question, the given details are, An LRC circuit is shown with an alternating source…

Q: 2) Give the applications for each type of the PCM waveform.

A: Modulation:- Modulation is the process by which one or more carrier signal waveform properties are…

Q: 23л 25 л ли 251 ли au 25л ли 25л Е 25л Z 25Л

A:

Q: Figure Q3 shows a full bridge rectifier circuit. The input line voltage is 120 Vrms and the line…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Problem 03.063 - Node and mesh analysis with supermesh Find vx and ix in the circuit given below.…

A:

Q: V₁ t = 0 +1 + R www UR i + L mooo UL The following circuit is underdamped. Find the frequency in…

A: The given problem is from circuits.  The detailed solution is given in the next step

Q: Q4. In Gauss's law, what can we conclude if we have two different Gaussian surfaces, as shown in…

A:

Q: [Miles-to-Kilometers Converter with Storage] Design a sequential circuit that (1) takes as input a…

A: According to the question, we need to design a sequential circuit for miles-to-kilometers converter.

Q: ▪ A 50 Q transmission line is connected to 75 22 load at 100 MHz. Given v = 0.8, find: I I I…

A:

Q: 3. Determine Vo using mesh analysis. 20V 45 V 1502 M Il 82 + F% + 14 1022 12 3222 M 13 2012 +48V

A:

Q: In the circuit in (Figure 1), the load absorbs 115 VA at a lagging power factor of 0.6. Figure + 1Ω…

A:

Q: A m 2K B. 2K www 1K 4K 2K 1K 2K 4K 4K

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 2y(7) + 4y (6) + 5y (5) + 7y(4) — 10y"" + 13y" + 12y' − 8y = x" + 3x² + 2x y (5) + 4y (4) + 3y +…

A:

Q: The MOSFET in the circuit to the right has W V₁=1V, -=1mA/V²,V L Determine the following: a) I₁ b)…

A:

Q: basic concepts of direct current and alternating current, and the main applications that each one…

A: Current The flow of electrons through a conductor is termed current (Electric current). Because this…

Q: USE A SERIES OF SOURCE TRANSFORMATIONS TO FIND THE VOLTAGE V IN THE CIRCUIT 201 120Y boy 255 (↑) 36A…

A:

Q: What is the total power of the circuit shown below? Enter a whole number, no decimal places, no…

A: In this question We need to determine the current in the each load.  We know  Power P= VI

Q: What is the cut-off wavelength (mm) of an air-filled 3.1 cm x 2 cm rectangular waveguide operating…

A:

Q: 13) Explain the nomenclature of additive white Gaussian noise (AWGN). What the PSD and…

A: Additive: It is a noise signals that gets added to the original signal in the channel. y(t)=  x(t)+…

Q: 2. The type of AC distribution system commonly used to supply both light and power is the a) Open…

A: Here given that ac distribution system that has both light and power  So here we need to find which…

Q: Derive the Gaussian distribution probability function

A:

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.