What type of filter is shown in the Figure?

Q: Transform the 1st circuit into its wye-equivalent circuit. If A=1 kohms; B=3 kohms; C-3 kohms, what…

A:

Q: FOR THE CIRCUIT IN THE IMAGE Write down the Circuit equations using a) NODE-Voltage METHOD b) MESH…

A: For the given circuit we have to find the nodal and mesh equation and then by using it the voltage…

Q: A dc compound motor is rated at 10 hp, 1200 rpm, 200 V. If the motor draws a full-load current of…

A: Output power Po=10 hp=10×746=7460 W. Line voltage VL=200 V. Line current IL=50 A.

Q: ic (t) E(t) M R C + Vc (t)

A:

Q: 2. For the unity feedback system of Figure 2, where K G(s) = s(s+5)(s+8) plot the root locus and…

A: The root locus can be drawn based on the location of poles and zero in the given system. The locus…

Q: Question 1 In a 8-poles synchronous generator, the number of poles for the Sth-harmonic air gap MMF…

A: Number of poles P=8.Frequency f=50 Hz.

Q: e R L Give the answers to one decimal place. Do not write numbers in the complex number form!…

A:

Q: If the input voltage v₁ = 5 V, the output voltage vo is: 10 ΚΩ ww 25 KQ 10

A: Input voltage- Vi = 5 V, To Find- The value of the output voltage Vo.

Q: Q.10 A 3- 400 KV transmission line has Z = $' 400 Q. If the line is compensated with series…

A: 3-phase, 400 kV transmission line- Line voltage V=400 kV, Initial Zs=400 ohm, To Find- The new…

Q: A step-up chopper is fed with 200 V. The conduction time of the thyristor is 200 us and the required…

A: Step-up chopper- Input voltage Vin=200 V, Conduction time of the thyristor =200 μs. Required output…

Q: Convert the computed TEC into NEC. THEVENIN'S EQUIVALENT CIRCUIT (TEC) RTH VTH R3 (Load) NORTON'S…

A: Norton's equivalent circuit is converge of Thevenin's equivalent circuit. To convert TEC into NEC,…

Q: DELTA-TO-WYE TRANSFORMATION VS VS A E Do not include the unit. The answer must be in 2 decimal…

A:

Q: What is the formula to convert 7psi to mA? 4-20mA = 3-15psi

A:

Q: SR₁ R3 R₂ Vs Original circuit Th RTH wwa Thévenin equivalent circuit IN(1) RN Norton equivalent…

A:

Q: 1. Please consider the circuit below. Compute the average real power absorbed by the circuit and…

A: Need to compute the average real power supplied by the voltage source and the average real power…

Q: Data at a bit rate R, must be transmitted using either binary NRZ polar signaling or 8-ary PAM NRZ…

A: According to the question, data at a bit rate Rb must be transmitted using either binary NRZ polar…

Q: Discuss in detail about the role of SVC in improving the stability limit and enhancing the power…

A: Discuss in detail about the role of SVC in improving the stability limit and enhancing the power…

Q: 1) State and discuss the various types of DC generators. (2) Choose a renewable source of energy to…

A: We need to discuss the various types of DC generators.we need  explain the process of converting…

Q: What is the frequency of a sine wave of voltage which has a 45V peak and which continuously…

A: In this question we need to find the frequency of a given sine wave voltage.

Q: The battery of a car has been discharged and removed. The car is started using an external battery…

A:

Q: Construct the Bode diagram for the system GH(s) 5 (s + 4) (s + 1)(s + 0.5)

A: In this question We need to construct the bode plot diagram for the given system.  Bode plot have…

Q: (vp + Un)Ri Ro A(Up-Un) io. +98

A: An Op-Amp model with, Inverting terminal voltage vn=90 μV Output voltage v0=5 V Open loop gain…

Q: Q/1/A single-phase, half-wave, controlled has a source 220V at 50 HZ and is feeding a load R-2002…

A: To solve this problem, we need to use the following equations: Average load voltage = Vmπ × (1 +…

Q: Calculate the value of R₁ (in Ohms) which will make the total conductance between the terminals A…

A: In this question We need to determine the value of resistance R1 as shown the circuit if equivalent…

Q: A. If Va = Vb = 5 V and Vc = 0 V. What is Rps.on of Q2? Note that VTH = 1 V and k = 2 mA/V2. B. What…

A: Va=5V,Vb=5V,Vc=0V,Vth=1V,k=2mAV2. Now, we need to calculate the RDSon for transistors Q1 and Q2.…

Q: [Pl.1c] Find Hm, @m, Bw, and w₁,2. Use the correct units.

A: For the given parallel RLC circuit we have to calculate the admittance, resonance frequency,…

Q: Note - Express all voltages & currents as phasors written in "polar" form (Le-100/45° or 100e) and…

A:

Q: Explain the main differences between the analysis methods of analog and digital control systems in…

A: Analog and digital control systems are two different methods of implementing control systems to…

Q: 5. The three-port device with an s-matrix of s= 1 0 a. Directional coupler b. Wilkinson power…

A: "Since you have posted multiple questions, we will provide the solution only to the first question…

Q: For the circuit shown below, the input pole is expressed by VDO Select one: 4FM₂ Vout O a Wpin =…

A:

Q: (d) Find I and I2 in the circuit in figure 5 404 6Ω της Μ 8Ω 20Ω 5Ω Μ Figure 5.

A:

Q: Sketch the forward and reverse characteristics of a silicon p-n junction diode

A: In this question we need to Sketch the forward and reverse characteristics of a silicon p-n junction…

Q: 41. Describe the output waveform of each circuit in Figure 2-105. Assume the RC time constant is…

A: For the given clamper circuit the output waveform needs to be obtained. Based on the bartleby…

Q: 1.Draw an example Turn-on Snubber circuit and explain its working principle and what it is used for.…

A: (1) It is asked to draw a turn-on snubber circuit and also asked to explain its working principle.…

Q: Calculate the Norton equivalent current source (IN) between the terminals A and B as shown on the…

A:

Q: A system is represented by the transfer function given below. Determine the gain and phase shift of…

A:

Q: for the circuit shown, the switch goes from closed to open at t=0. What is the natural oscillation…

A:

Q: Compute the Fourier transform of the sequence, x(n) given below. Sketch phase and amplitude plots…

A:

Q: Based on the computed NEC (Norton Equivalent Circuit), What is the Norton resistance value (RN), in…

A: In this question,  We need to determine the value of Norton resistance RN   We are solving this…

Q: Consider a GaAs LED with a refractive index of 3.66. The LED's surface is coated with a dielectric…

A:

Q: Find the Thévienin voltage VT and impedance Zth for the circuit shown in figure 8. 1/30°V 652 M j8n;…

A:

Q: series circuit having a resistor R = 25Ω and an inductor ( L ) = 0.15H connected in series to a 120V…

A:

Q: (a) Using nodal analysis, find Io in the circuit below. V₁ + ww 1Ω 12 τον 2/6° A 1Ω I 1Ω V₂ -j1Ω====…

A: In this question we need to find the current Io using nodal analysis.

Q: Use the following circuit and calculate. What is It = About 32 milli amps About 3.333 milli amps…

A:

Q: Based on the computed TEC (Thevenins Equivalent Circuit), What is the voltage across the load R3, in…

A: In this question,  We need to determine the voltage across the resistance R3  in Volt.  We are…

Q: R₁ 4Ω VS1 28V R₂ C 202 R₁ (Load) 10 7V = VS2 THEVENIN'S EQUIVALENT CIRCUIT (TEC) RTH VTH R3 (Load)

A:

Q: The NMOS in the circuit below has k = 1.2 mA/V² and VTH = 2.4 V. Vi = 5 V. V₁ ww 1 ΚΩ IDS 12 V 2.2…

A:

Q: Consider the system described by 0.8 1 0 0.9 y(k)=[10]x(k) Under the similarity transformation x(k)…

A: The state-space mode of a discrete-time system is given as xk+1=0.8100.9xk+01uk,yk=10xk   ...1.…

Q: The circuit after source transformation will be as follows: R4 V where R= Oa. 31.5 Ob. 15.75 Oc.…

A: In this question we need to find the value of R , V and Vx of the given equivalent circuit. For the…

Q: For R1=6, R2=10, R3=6, 12=5 A, 11=7 A & V1=11 V in the shown circuit, Find the Norton equivalents at…

A:

Filter

A filter is a device or process which removes some of the unwanted features or components like frequencies from a signal in signal processing. The feature of filters is the complete or partial suppression of some part of the signal, and filtering is a class of signal processing. This most often means removing some frequency bands or some frequencies. In the frequency domain, the filters do not exclusively act, especially in the image processing field many other targets for filtering exist. Without having to act in the frequency domain, the correlations can be removed for certain frequency components and not for others. The filters are widely used in electronics and telecommunication, in television, radio, radar, audio recording, music synthesis, control systems, computer graphics, and image processing.