When and why did the professional engineer emerge? Be sure to define the term “professional engineer” in your answer

Q: Determine the weight W that balances the 10-lb load placed linkage shown. on the

A: To determine the weight w, such that it balances the 10 lbs load.

Q: please solve question 1, principles of Irrigation

A:

Q: X=? N58°50'24"E Yes 59°32'23"W

A: A traverse is given and it has been asked in the question to evaluate interior angle

Q: In a groundwater field test, a tracer took 8 hours to travel between two observation wells which are…

A: Given in a ground water test, A tracer took 8 hours to travel between two observation wells which…

Q: 5- Following data are given for a direct shear test conducted on dry sand: Specimendimensions:60mm x…

A: Given  Normal stress = 100 KN /m2  Shear force at failure= 200 N

Q: 5.3 in. 1.3 in. y Fig. P9.77 с प्र 1.0 in. 0.412 in. 0.5 in. -3.6 in. 2.25 in. 0.5 in. X

A:

Q: An extended layer of soil with homogeneous rounded grains has 10% of the material finer than 0.007…

A: We have to determine the permeability  Given data: D10 = 10 % of the material finer than 0.007 mm. C…

Q: The NSCP specification and A36 steel (fy ​=250MPa, E=200GPa). Solve the Maximum Allowable…

A: Given:- The yield strength of the steel (fy) = 250 MPa The modulus of elasticity (E) = 200 GPa The…

Q: 7. The tension in the cable AB is T. The moment of this tension about point O is: A. TXTOA B. TX TOB…

A: Given- Tension in cable AB = T, It is needed to find the moment of tension T about point O.

Q: Show a complete solution. Classify each of the structures as statically determinate or…

A: To classify the each structure-

Q: III. Differential Leveling 1. Complete the table below. STATION BM1 TP1 TP2 TP3 TP4 TP5 BM2 BS 2.11…

A:

Q: Problem 2. A sample of water is to be analyzed for solids content. Ten liters of water are passed…

A: Given: Sample size = 10 liters Weight of the filter = 15 g The filter plus residual weight after…

Q: PROBLEM 3 Solve all support reactions using the settled by 30mm. E 70GPa and I = 400(106)mm¹ = 75…

A:

Q: The asymmetric simple truss is loaded as shown. Determine the reactions at A and D. Neglect the…

A: Reference : Structure Analysis, Truss Analysis. Given : Forces acting at each points A, B, C and D…

Q: The path profile between two sites on a contour map that are 20-km apart shows variations in…

A: Distance between sites = 20km Elevation of first site = 200m above MSL Elevation of second site =…

Q: determine the maximum load P if the maximum capacity in tension of the bolts is AKN A = 7.8 and…

A: Given that Maximum tension capacity of the Bolt, A = 7.8 and F= 2.4 KN r =0.152 +0.152 = 0.212 mL1…

Q: The grade of -5% is followed by a grade of 1% the grades intersecting at the vertex (station…

A: Given,  G2 = 1 % G1 = -5% Change of grade = 0.4% in 20 m

Q: Question 3. A DNAPLS substance was generated and released in a tire fire accident. A consulting firm…

A: The given data is shown below: Aquifer depth=1300 mSoil porosity=34%Hydraulic conductivity=41…

Q: The beam is built in at both ends and loaded by a distributed load which has the constant intensity…

A: Solution: Convert the UDL and UVL to the point load:

Q: Problem 1 If roller support is added at point C, 20ft. from point A. Determine the following: (Use…

A: The given figure is shown below:

Q: For the beams and loading shown below. a) Draw the shear and moment diagrams b) Determine the…

A:

Q: Using the given data in the traverse shown: POINTS AB C D E F NORTHINGS 75 m. 425 m. 675 m. 675 m.…

A:

Q: 2 -, determine the total stress at A in kN/m

A:

Q: 2. Determine the horizontal and vertical at joint C using the Castiliagno’s 2nd Theorem.

A:

Q: what is differential leveling

A: Differential levelling

Q: How does plastic design differ with elastic design when it comes to the computation of moment load…

A: Simply Supported Beam: A beam that consists of two supports at each end of the beam and which is…

Q: 4) Wire is being drawn at a constant rate from a spool by applyin vertical force P to the wire as…

A:

Q: c) Determine the design discharge of a canal with the following data: Crop Sugarcane Overlap…

A:

Q: ur solution including units and the free body diagrams. 20 KN 3 m A 10 KN 4 m E 20 KN 4 m D C 10 kN

A: To find the force in each members-

Q: ends are Ly 18.16 Select the lightest standard-weight steel pipe section to sup- port an axial…

A: Given: Load, Pu = 100 kN Length, L = 5.5 m fy = 240 MPa The column is pinned at each end.

Q: The following offsets 8m apart, were measured from traverse line to an irregular boundary; 0.0,…

A: Distance between the two perpendicular offset = d = 8m Offsets -  d1 = 0d2 = 2.3md3 = 5.5md4 =…

Q: Problem 3 Use the approximate 'portal method' to find the reactions of this frame. What will be the…

A: To calculate- Reactions and moment at point c.

Q: Problem 3. Draw the shear and Bending Moment Diagram of the beam shown. Solve the problem using…

A:

Q: Q.28 If the stress induced due to direct tensile load on a body of volume 16000 mm³is 100 N/mm².…

A: Given data,  Volume = 16000 mm² Stress due to direct load = 100 N/mm² E = 2x10^5 N/mm²

Q: A timber beam 150 mm wide by 250 mm deep is to be reinforced at the top and bottom by steel plates…

A: Given : Width of beam = 150 mm Depth of beam = 250 mm Thickness of steel plate = 10 mm Moment = 40…

Q: IP ←4 m→4 A B m 4 m с D E P F -4 m- G H 4.5 m

A:

Q: An oil of specific gravity 0.9 contained in a vessel. At a point the height of oil is 40 m and for…

A: Given: Oil specific gravity = 0.9 Height of oil, h = 40 m Density of water = 1000 kg/m3

Q: 1. Find the maximum concentrated live load that is projected onto the free end of the box, bearing…

A: Given: d = 530 mm d' = 70 mm b = 270 mm fc = 20 MPa fy = 300 MPa rebar = 4#20 mm

Q: Question 2. A coal fired power station requires an ESP for dust removal from the flue gas. The…

A: Given:- The concentration of the dust particles in the influent flu gas = 5200 mg/m3  The flow rate…

Q: II. Determine the force in members BF and EF using: a) Method of Joints b). Method of sections. 3…

A:

Q: A and F. Determine the reactions at the supports b) Using the method of joints, determine the forces…

A:

Q: A secondary road in a developing country, 30 miles long, is to be improved by surface treating the…

A: Given length of road = 30 miles cost of improvement = $150,000/- per mile Total cost of improvement…

Q: Distance by Tachymetry 1. A stadia rod held at a distant point E is sighted by an instrument…

A:

Q: Q2 - The assembly shown below consists of three rods AB, CD and EF with the following properties: AB…

A:

Q: A structure as shown in the figure is hinged at A and rests on a roller at C. In using Castigliano's…

A:

Q: Draw the shear and bending moment diagrams of each of the given loaded beam. 1. 5 m 150 kN B 5 m 600…

A: Shear Force Diagram: The diagram which represents the shear force at every point on a given loaded…

Q: This bridge is:

A: given :   picture of truss  to find :  type of truss bridge

Q: The continuous beam shown below has an internal hinge at point C. The beam is loaded with two…

A: To determine:1) the vertical deflection at C2) the vertical deflection at F3) the rotation at A4)…

Q: Problem 3. Draw the shear and Bending Moment Diagram of the beam shown. Solve the problem using…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Problem 1. Draw the shear and Bending Moment Diagram of the beam shown. Use the Method of…

A: Given Data  Find the support reaction using superposition method and draw shear force and bending…

Classification of Legal Structure

The first step for the establishment of any company is to find a suitable legal structure. To determine the appropriate legal structure for a specific company or a venture, professional guidance is necessary for the deep understanding of various structure classifications, long-term targets, and certain choices. The categorization of different business legal structures comprises liability implications, income and taxation considerations for the company owners.