5.a. Which of the following tend to have the smallest splice loss? A. Connectors B. Mechanical splices C. All connectors have the same splice loss. D. Fusion splices 5.b. What's the best way to install cable in an existing duct? A. Push the cable into place. B. Blow the cable into place. C. Pull the cable into place. D. New cable can't be installed in existing ducts. 5.c. Which of the following SFF connectors is a simplex connector? A. MU B. Opti-Jack C. MT-RJ D. Dual-SC

Q: 1. Find VAR in the given network: 20 V 4 R1 25Q R3 402 Ry 150 R4 102

A: Given

Q: 9. What is the equivalent resistance between points A and B of the resistors in the circuit? R (а) 0...

A:

Q: Consider the foll ow,ng systen * - [d!]x+[?]uct) y = [I 2]X investigate The stability of the Sy stem

A: We need to check stability of the given system

Q: Consider the Following matrix A= 2 3 4 a) Find all the egenialues and eizenvectors

A:

Q: 3.6 Find V, and V, in the circuit in Fig. P3.6 using nodal analysis. 6 mA ww 4 k V 6 kf? V 3 kn 4 mA...

A: Hi, Hope you are doing well I can solve only first question as per guidelines Please submit second q...

Q: Which of the following d.c. motor would be suitablefor drives requiring high starting torque butonly...

A:

Q: 18. A real-valued signal r(t) is an odd signal if x(-t) = -x(t). Similarly, a real-valued signal x(t...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: What Boolean expression describes the output X of this arrangement? A B X- (A•B)+C X-A•(B+C) X=A+B+C...

A: The given circuit is,  

Q: Vipk R Vo Vị E -Vipk'

A:

Q: Consider a pure semiconductor material of silicon. At 300 K, the electron concentration in the condu...

A: Given that T1=300KT2=350Kne1=1016cm-3nh1=1017cm-3

Q: A transmission line has a characteristic impedance of ? = 21.05∠60.4 with propagation constant of 7....

A: Given  Characteristic impedance Z0=21.05∠60.4° ΩPropagation constant γ=7.561×10-3+j0.002863 Angular ...

Q: -3 Refer to the nonperiodic voltage triangular waveform v(1) shown below. (a) Using Table 3–2, write...

A:

Q: 720v R find R-2 5.

A: We have given the following problem

Q: A single-phase transformer is rated at 110/33 kV,50 MVA. It is to be protected by a differential rel...

A: GIVEN: Current ratio              input tabs 3.0, 4.0, 4.8, 5.0, 6.0 A FIND: CT ratio mismatch

Q: In the circuit of the figure below solve for the voltage ye by first finding the Thevenin equivalent...

A: The solution is given below 

Q: Design common-base configuration circuit. IE= 1.3 mA and Av= 250.

A: The Common Base Amplifier is a bipolar junction transistor (BJT) architecture with a common base ter...

Q: Estimate cell temperature, open-circuit voltage, and maximum power output for the KD230GX-LPB module...

A: As,  Tcell=Tamp+NOCT-200.8.5 Tcell=30+47-200.8.1Tcell=64°C PV module performance data, under stateme...

Q: Given an electrical circuit shown in Figure 1. 1 H v(t) 1 H vz(t) Figure 1 (a) Obtain the transfer f...

A: Transfer function is the laplace transform  of  output to input With zero initial conditions

Q: * find the voltage V 62 20 -15V 102 + V 3.366 O 5.264 O 5.555 O

A: In this question we will find voltage V using KVL... voltage law states that for a closed loop serie...

Q: In the circuit below, find the current that flows in the 52 resistor. 50V a 2.22 +) 1.50 100V 2.30 1...

A:

Q: Sketch the output waveform. Show your complete analysis.

A: In this question we need to draw a output waveform.

Q: Calculate the amount of charge represented by six million protons. Answer: +9.612 x 10-13 C.

A:

Q: 1. Enumerate the circuiting guidelines. 2. Enumerate good practices in círcuiting. 3. How to prevent...

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are...

Q: Find out Z transform of y (n) = a"u(n)

A: In this question , we will find z transform of given signal....

Q: In a line-of-sight radio system, losses are mainly due to free-space path loss (FSPL). FSPL is propo...

A:

Q: ix Device 11. A device is shown, with reference polarities for voltage and current, in Figure 1. A p...

A:

Q: Which of the following d.c. motor would be suitablefor drives requiring high starting torque butonly...

A: Compound d.c. motor    Shunt is suitable for constant speed .Series is suitable for high torque.  Co...

Q: Using mesh analysis, find the voltage across each resistor. 10kQ 8kQ 8k2 12V 6V

A: The solution is given below 

Q: I Consider the following syolam. as a transformahion , Frnd the using i- [' x new" syslam and check ...

A:

Q: Ri |),25 | 2 2.25 R 2.5 3 Rg 3.25 Ra i 3.5 Rio R i4.5 R1z 5 Rs Ri3 ,Riz Ri4 I R 15 Ris Rio 14 R13 Ri...

A:

Q: Consider the following system X =[o + [ ]uct) y = [I 2] X investigate the controllability and observ...

A:

Q: A 220-V d.c. shunt motor runs at 600 r.p.m. when the armature current is 50 A.Calculate the speed if...

A:

Q: The unbalanced four wire Y-connected load has balanced voltages of 415 V and the RYB-sequence. By ta...

A:

Q: single phase load is connected across line bc of a three phase supply of 3300 V . If the load is ass...

A: In this question , given single phase load across line  bc of 3 phase source....We have to find out ...

Q: A 250-V shunt motor runs at 1000 r.p.m. at no-load and takes 8A. The totalarmature and shunt field r...

A:

Q: For the circuit as shown in figure below, find the value of Vx such that the 5A current source suppl...

A: This question belongs to circuit theory . It is based on the concept of nodal analysis in the circui...

Q: A constant current source of 5A is flowing through a resistor for about 2 seconds. If 4.2 kJ of ener...

A: In this question, we will find power consumption across resistance R while energy consumption in res...

Q: What is the output waveform of the circuit? 5 V PT1 PT2 12V + 220 V/60 Hz/0 Deg 1k Ohm Select one: a...

A: Answer: e. none of the choices

Q: If the Fourier transform of x(t) is X(w), what is the Fourier transform of x(3(t- 2))? O 1/3 X(w/3)e...

A: In this answer we will find the Fourier transform as explained below.

Q: The following data was obtained from an investigation into the voltage /current characteristic of a ...

A: The given voltage and current for differnet scenarios are:

Q: Voltaget V) Current () 100 150 200 250 0.12 0.19 0.28 0.4

A: The given table is shown below:

Q: Q5 / Find the current in the 20 resistance of the network shown in fig.(5) 4V T š 12V lovi les 6V

A:

Q: If the Fourier transform of x(t) is X(w), what is the Fourier transform of x(-4t+2)?

A:

Q: Prove the following identities algebraically (a) (b) (A + B)(A + B) = 0 A + AB = A + B %3D %3D

A: a) Given: A+BA+B¯=0

Q: An antenna is transmitting 44 W of power. Express this power in the unit of dBm.

A:

Q: The expected value of the voltage across a resistor is 90 V. However, the measurement gives a value ...

A:

Q: 12. Six components, labeled A, B, C, D, E, and F, are connected as shown in the circuit diagram give...

A:

Q: circuit. this wave is the output of Vm -Vm filter O clamper O regulator O clipper

A: Filter allows some band of frequencies and blocks all other frequencies.  Clipper is a circuit that ...

Q: What is the output of the circuit? 100 uF 100 uF PT1 3V + 220 V/60 Hz/0 Deg 100 uF 100 uF TP2

A: The given circuit is a voltage quadrupler circuit with transformer . This circuit produces output vo...

Q: In a Transistor the Common-Base configuration provide a Voltage gain True O False

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.