Will 260 milligrams of calcium carbonate raise the pH of 75.0 milliliters of stomach fluid from a low pH of 1.0 into the normal pH range of 1.5-3.5? The first step of this problem is to convert 260.0mg of calcium carbonate to grams of calcium carbonate. Submit a reply that that tells how you decic approach the problem and shows the work that results in an answer. Use correct units and significant figures. In addition, reply to another student's:

Will 260 milligrams of calcium carbonate raise the pH of 75.0 milliliters of stomach fluid from a low pH of 1.0 into the normal pH range of 1.5-3.5? The first step of this problem is to convert 260.0mg of calcium carbonate to grams of calcium carbonate. Submit a reply that that tells how you decic approach the problem and shows the work that results in an answer. Use correct units and significant figures. In addition, reply to another student's:

Chemistry for Today: General, Organic, and Biochemistry

9th Edition

ISBN:9781305960060

Author:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Publisher:Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen

Chapter1: Matter, Measurements, And Calculations

Section: Chapter Questions

Problem 1.114E

See similar textbooks

Similar questions

You wish to prepare 1 L of a 0.02-M potassium iodate solution. You require that the final concentration be within 1% of 0.02 M and that the concentration must be known accurately to the fourth decimal place. How would you prepare this solution? Specify the glassware you would use, the accuracy needed for the balance, and the ranges of acceptable masses of KIO3 that can be used.
180 mL of a NaOH solution of unknown concentration is titrated against a 1.86 M solution of HCI. It takes 8.09 mL of the acid to reach the endpoint. What is the concentration of the NaOH solution? (Hint: You will need to write out the equation and balance it first.) Be sure to report your answer to the correct number of significant figures. Do not report the units (M) in your answer.
What is the pH of (3.21x10^-1) M C5H5NHBR? Enter your answer in scientific notation with 3 sig figs. Do not include any units in your answer. Do not round any intermediate calculations. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: х10 Answer
Chemistry An analytical chemist weighs out 0.410g of an unknown triprotic acid into a 250mL volumetric flask and dilutes to the mark with distilled water. She then titrates this solution with 0.0700M NaOH solution. When the titration reaches the equivalence point, the chemist finds she has added 91.5mL of NaOH solution. Calculate the molar mass of the unknown acid. Round your answer to 3 significant digits.
(record your final answer rounded to the correct significant digits and the proper units.) 1. A neutralization reaction occurs when phosphoric acid reacts with sodium hydroxide solution. Calculate the concentration (in mol/L) of a phosphoric acid solution if 37.9 mL of H3PO4(aq) requires 0.377 mol of NaOH(aq), for complete neutralization. 2.Calculate the mass of precipitate (in g) produced when 50 mL of 4.00 mol/L sodium hydroxide solution is reacted with excess aluminium nitrate solution.
Calculate the volume in milliliters of a 1.26M silver perchlorate solution that contains 25.0 g of silver perchlorate (AgClO,). Round your answer to 3 significant digits. | ml ?
2. In the standardization of an acid and base solution, sodium hydroxide (99.5% by mass) was used. A sample weighing 0.12 gram was dissolved and titrated to the endpoint with the acid solution. The initial buret reading is 5.5 mL. The final buret reading is 28 mL. Calculate the normality of the acid solution.
a) If 42.1 mL of 1.02 M sodium hydroxide, measured using a graduated cylinder, is placed in a beaker filled with 300 mL of DI water, what is the concentration of the diluted NaOH solution?b) Why does this calculation only provide an estimate of the NaOH concentration? In other words, why do we have to standardize the NaOH in this experiment to find its exact concentration?(Hint: think about the glassware used and refer back to the worksheet on glassware at the beginning of the semester.)
There are a flask, and burette containing an acid, and a base, respectively The first, a flask contains a solution of 10 mL of an unknown acid and 0.15 mL of PhenolphthaleinThe second, a burette containing 52 mL of 10.0 M NaOH. The flask now contains a total of 10.15mL solution of an unknown acid, and 0.01 mL of NaOH is dropped by a burette.The flask turned from colorless to pink when the solution is 12.210 after receiving drops from the burette which means a total of 2.06mL of NaOH is needed to turn the inknown acid into pink. What is the concentration of the acid (Please use three significant figures for your answer in M)
Objective KTIO A chemistry student weighs out 0.0434 g of sulfurous acid (H,SO,), a diprotic acid, into a 250. mL volumetric flask and dilutes to the mark with distilled water. He plans to titrate the acid with 0.1800M NAOH solution. Calculate the volume of NaOH solution the student will need to add to reach the final equivalence point. Round your answer to 3 significant digits. mt. I Don't Know Submit 2022 McGraw Hill LLC. All Rights Reserved. Terms of Use Privacy Center Accessibility Launcher Lenovo
Given a solution of ammonia that is 14.8 M, how many milliliters of this solution should dilute to make 100.0 mL of 0.250M ammonia? Provide an answer correct to 2 significant figures. For example, if you calculate that the correct answer is 12 milliliters, simply type 12 in the box. Do not answer this question using scientific notation. Do not include units in your answer. (hint: this is a dilution question. How do you know? What equation do you use to calculate dilutions? It has four variables. If you're given 3 of the 4, can you find the 4th?)
Find the number of millimoles of solute in 456.7 mL of 2.900 M KOH (56.1g/mol). Answer should be in millimole, with 2 decimal places and unit should not be written in the box.