Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 11.5, Problem 1aT
The minima that occur in the case of a single slit are called diffraction minima. On the photograph and on the graph,identify the locations of the diffraction minima.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Consider the interference pattern in the diagram. (The crests are represented by thick lines and the troughs by thin lines.) If the distance from S1 to point A is 49.5 cm and the distance from S2 to point A is 60.5 cm, then what is the wavelength?
Consider the sodium doublet vapor lines, which have wavelengths of 589 nm (line a) and 589.6 nm (line b).
(a) Find the angle (in degrees) between the first minima for the two sodium vapor lines, when they fall upon a single slit with a width of 1.8 μm.
(b) What is the distance in mm between these minima if the diffraction pattern falls on a screen 1.05 m from the slit?
In the above figure, which shows the pattern of interference fringes for light of wavelength 485 nm passing through two narrow slits, projected onto a screen a distance of 1.81 m away. The distance on the screen between the centers of two adjacent bright fringes is 1.66 cm. What is the distance between the two slits?
Chapter 11 Solutions
Tutorials in Introductory Physics
Ch. 11.1 - Prob. 1TCh. 11.1 - Prob. 2aTCh. 11.1 - Prob. 2bTCh. 11.1 - Prob. 2cTCh. 11.1 - The representation that we have been using...Ch. 11.1 - Prob. 2eTCh. 11.1 - Prob. 2gTCh. 11.1 - Each of the photographs at right shows a part of a...Ch. 11.1 - Obtain a piece of paper and a transparency with...Ch. 11.2 - Obtain a pan of water and form a barrier in it...
Ch. 11.2 - Prob. 2aTCh. 11.2 - Obtain an enlargement of the diagram at right that...Ch. 11.2 - Suppose that the width of one of the slits were...Ch. 11.2 - Red light from a distant point source is incident...Ch. 11.2 - Compare the situation in part II (in which a...Ch. 11.2 - For each of the lettered points, determine D (in...Ch. 11.2 - Suppose that one of the slits were covered. At...Ch. 11.2 - The pattern produced by red light passing through...Ch. 11.2 - Consider point B, the first maximum to the left of...Ch. 11.3 - Red light from a distant point source is incident...Ch. 11.3 - In a previous homework, you found an expression...Ch. 11.3 - Suppose that the screen were semicircular, as...Ch. 11.3 - Consider a point M on the distant screen where...Ch. 11.3 - Consider a point N on the screen where there is a...Ch. 11.3 - Obtain a set of transparencies of sinusoidal...Ch. 11.3 - Suppose that coherent red light were incident on a...Ch. 11.3 - Generalize your results from the 2-slit, 3-slit,...Ch. 11.3 - Coherent red light is incident on a mask with two...Ch. 11.3 - Prob. 3dTCh. 11.4 - Red light from a distant point source is incident...Ch. 11.4 - Suppose that point X marks the location of the...Ch. 11.4 - Suppose that only slit 1 is uncovered, and all...Ch. 11.4 - Show how you could group all ten slits into five...Ch. 11.4 - Suppose that the number of slits is doubled and...Ch. 11.4 - If we continued to add slits in this way (i.e.,...Ch. 11.4 - How is this pattern different from what you would...Ch. 11.4 - Consider the following dialogue: Student 1: "l...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - Describe what you would see on the screen if the...Ch. 11.4 - If a diffraction pattern has several minima (like...Ch. 11.4 - In part A, you drew a diagram that showed how find...Ch. 11.4 - Use the model that we have developed to write an...Ch. 11.5 - The minima that occur in the case of a single slit...Ch. 11.5 - Consider the following dispute between two physics...Ch. 11.5 - A second slit, identical in size to the first, is...Ch. 11.5 - Both slits are now uncovered. For what angles will...Ch. 11.5 - Suppose that the width of both slit, a, were...Ch. 11.5 - Suppose instead that the distance between the...Ch. 11.5 - The four graphs from part C that show relative...Ch. 11.5 - Consider the relative intensity graph shown at...Ch. 11.5 - Consider the following comment made by a student:...Ch. 11.5 - You may have already noticed that the maxima are...Ch. 11.6 - Prob. 1TCh. 11.6 - Prob. 2aTCh. 11.6 - When comparing two materials of different indices...Ch. 11.6 - Consider light incident on a thin soap film, as...Ch. 11.6 - Light of frequency f=7.51014Hz is incident on the...Ch. 11.6 - Suppose that an observer were located on the left...Ch. 11.6 - Observer A is looking at the part of the film that...Ch. 11.6 - Observer B is looking at the part of the film that...Ch. 11.6 - Observer C is looking at the thinnest part of the...Ch. 11.6 - Describe the appearance of the film as a whole.Ch. 11.6 - What are the three smallest film thickness for...Ch. 11.6 - The thickness of the film is 1650 nm at the bottom...Ch. 11.7 - Look at the room lights through one of the...Ch. 11.7 - Hold a second polarizing filter in front of the...Ch. 11.7 - Do the room lights produce polarized light?...Ch. 11.7 - Suppose that you had two marked polarizers (i.e.,...Ch. 11.7 - Suppose that you had a polarizer with its...Ch. 11.7 - Prob. 2dTCh. 11.7 - An observer is looking at a light source through...Ch. 11.7 - Consider a beam of unpolarized light that is...
Additional Science Textbook Solutions
Find more solutions based on key concepts
52. You are target shooting using a toy gun that fires a small ball at a speed of 15 m/s. When the gun is fire...
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Estimate the average temperature of the air inside a hot-air balloon (see Figure 1.1). Assume that the total ma...
An Introduction to Thermal Physics
Archimedes' principle can be used to calculate the density of a fluid as well as that of a solid. Suppose a chu...
University Physics Volume 1
9. A spaceship moves in outer space. What happens to its motion if there are no external forces exerted on it? ...
College Physics
If the rms speed of oxygen molecules inside a refrigerator of volume 22.0 ft.3 is 465 m/s, what is the partial ...
University Physics Volume 2
Figure 2 shows the extrasolar planet and star from the side or as seen edge-on. At the instant shown, which dir...
Lecture- Tutorials for Introductory Astronomy
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- In a double-slit experiment, the distance between slits is 0.5.0 mm and the slits are 2.0 m from the screen. Two interference patterns can be seen on the screen: one due to light of wavelength 480 nm, and the other due to light of wavelength 600 nm. What is the separation on the screen between the second -order (m = 3) bright fringes of the two interference patterns?(show the ray diagrams)arrow_forwardTwo slits spaced 0.450mm apart are placed 75.0cm from a screen. What is the distance between the second and third dark lines of the interference pattern on the screen when the slits are illuminated with coherent light with wavelength of 500nm? Use a diagram to support your answerarrow_forwardThe figure shows the light intensity on a screen behind a single slit. The wavelength of the light is 510 nm and the screen is 1.3 m behind the slit. What is the width (in mm ) of the slit?Express your answer in millimeters to two significant figures.arrow_forward
- In the figure are shown graphs of the intensity pattern of light as a function of position on a screen produced by 4 sets of double slits labeled P, Q, R, and S. To produce the graphs, the laser beam and screen are held fixed while the slits are simply interchanged with one another. The graphs are plotted on the same scales for distance (horizontal axis) and intensity (vertical axis).Rank the relative widths of the slits d and the separation of the slits a by selecting both the correct order and the correct ranking symbols (greater than or equal to). Note that if two or more of the scenarios are equal, you must list them from left to right in alphabetical order (P,Q,R,S) with the equal signs in-between. For example, P=R>S>Q would be correct but R=P>S>Q would not. Ranking of slit widths: ---Select--- P Q R S ---Select--- = > ---Select--- P Q R S ---Select--- = > ---Select--- P Q R S ---Select--- = > ---Select--- P Q R SRanking of slit separations:…arrow_forwardIn the figure are shown graphs of the intensity pattern of light as a function of position on a screen produced by 4 sets of double slits labeled P, Q, R, and S. To produce the graphs, the laser beam and screen are held fixed while the slits are simply interchanged with one another. The graphs are plotted on the same scales for distance (horizontal axis) and intensity (vertical axis).Rank the relative widths of the slits d and the separation of the slits a by selecting both the correct order and the correct ranking symbols (greater than or equal to). Note that if two or more of the scenarios are equal, you must list them from left to right in alphabetical order (P,Q,R,S) with the equal signs in-between. For example, P=R>S>Q would be correct but R=P>S>Q would not.Ranking of slit widths:Ranking of slit separations:arrow_forwardWhen the width of the slit is made double, how would this effect the size and intensity of the central diffraction band? Justify your answer with the help of diagram.arrow_forward
- The diffraction pattern below arises from a single slit. If we would like to sharpen the pattern (i.e., make the central bright spot narrower), what should we do to the slit width? a) widen the slit b) enlarge the screen c) close off the slit d) None of the other responses are correct.arrow_forwardSketch and explain the pattern that would have been on the screen of a single-slit setup if light were only to behave as particles. Attached is an image that shows how waves and particles would differ on passing through a slit. Please see this as a reference.arrow_forwardA double-slit interference pattern is observed on a screen with the intensity graph. Points A, B, C, D, and E are bright fringes. Points F, G, H, I, J, and K are dark fringes. The wavelength of the green light is 500 nm. What is the path-length difference from the two slits to point K? E?arrow_forward
- Consider the single-slit diffraction pattern created by each slit. How do these single slit patterns affect the overall interference pattern?arrow_forwardSolve the two double-slit equations above for λ in terms of the measurable quantities d, y, m, and L. You may use the small angle approximation: sin θ ≈ tan θ.arrow_forwardCalculate the width the interference fringe in the middle of the screen between two slits given the wavelength of the incident light is 587 nm and the distance between the slits is 0.017 mm. Take the distance between the slits and the screed D=1 m. Provide your answer in millimetres (mm).arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
Spectra Interference: Crash Course Physics #40; Author: CrashCourse;https://www.youtube.com/watch?v=-ob7foUzXaY;License: Standard YouTube License, CC-BY