Before installing a gauge on the high-pressure side of a system, you should do which of the following?
A. Turn on the system.
B. Turn off the system.
C. Adjust the system to a neutral position.
D. Have a cylinder approved by the DOT nearby.
The work should be done before installing a gauge on the high-pressure side of a system.
Answer to Problem 1RQ
The work should be done before installing a gauge on the high-pressure side of a system is turn off the system.
Explanation of Solution
The pressure gauge is an instrument used to measure the gauge pressure of the flow of fluid. It displays high and low pressure side of the system when it is put in operation. This used to convert the pressure of the system different refrigerant requirements.
The technician should be skilled to attach the manifold gauge. Attaching the gauge to the manifold should be done very carefully. Wearing goggles and gloves are necessary while attaching the gauge otherwise the high-pressurised refrigerant can injure to eyes and skin of technician.
This type of dangerous condition can be prevented by letting the pressure of high-pressure side refrigerant down to lower pressure. To reduce the pressure to lower pressure, the system should be turned off.
Conclusion:
Hence, the work should be done before installing a gauge on the high-pressure side of a system is turn off the system.
Want to see more full solutions like this?
Chapter 41 Solutions
Refrigeration and Air Conditioning Technology (MindTap Course List)
- When servicing an oil burner, a service technician must have a ______gauge and a _____ gauge.arrow_forwardGive an example of Reducing the Air Pressure Setting.arrow_forwardFor a hydraulic power unit, this part indicates the amount of oil in the reservoir. Usually, it also indicates the temperature. a. liquid level gauge b. filler/breather c. pressure gauge d. suction strainerarrow_forward
- 2. How does fluid flow to the reservoir when the directional control valve is in the center position? dings between Gauge 2 and Gauge 3arrow_forwardWhy does the high-pressure gauge on a regulator not always indicate the amount of gas in the cylinder?arrow_forwardWhich of the following is called vaccum pressure? a. Pressure below the absolute pressure b. Pressure equal to atmospheric pressure c. Pressure above the atmospheric pressure d. Pressure below the gauge pressurearrow_forward
- 4.a. You can usually check for a leak in a vacuum system by looking at or feelingA. at the vacuum gauge at the vacuum pump.B. for signs of dirt on the piping.C. at the exhaust of the vacuum pump. 4.b. When a pneumatic solenoid fails, the failure is normally due to aB. weak pilot.C. bad spool.D. ripped seal.arrow_forwardQ#5: Distinguish between gauge pressure and vacuum pressure.arrow_forwardWhat is the advantage of using large gauge lines for evacuation?arrow_forward
- For every pound of pressure put on engine coolant, the boiling point of the coolant is raised about. 2°F(1.1°C) 3°F(1.6°C) 4°F (2.2°C) 5°F(2.7°C)arrow_forwardWhat is the use of pressure gauge?arrow_forwardA fixed rating pressure switch is adjusted inside the pressure control and display console to record the pressure. True or falsearrow_forward
- Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage LearningWelding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage LearningAutomotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning