Answered: 4. Given the following circuit, solve…

4. Given the following circuit, solve for the energy stored by the Capacitor and Inductor. 4 ΚΩ 2H 12 k 4 mA (+1) 24V (+ 20nF H 6 kn 16 mA

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 25RQ: List the five capacitor replacement rules.

See similar textbooks

Related questions

Q: 6-37 Find a single equivalent element for each circuit in SS Figure P6-37. 1.0 uF 6.8 μF 75 ΜΗ -m 25…

Q: Calculate the electric flux density 1 mm outside a 4 pC point charge. Express your answer to two…

Q: The rectangular form of the complex number 20+ (162-50°) (5+j12) is

A: The question is about polar coordinates to rectangular coordinates.

Q: Find the magnitude of the phasor current I(jw) that passes through the voltage source. Find the…

A: The magnitude of current passing through the voltage source and angle of the current passing through…

Q: P 5.2-8 The circuit shown in Figure P 5.2-8 contains an unspecified resistance R. (a) Determine the…

Q: Consider the following system: R(s) K G(s) G(s) where the open-loop transfer function (OLTF) is…

Q: What value of w will cause the forced response vo in the given figure to be zero, where L = 13 mH?…

Q: Q1. Find the output (t) for the system represented by transfer function shown in figure (2-10)…

A: Given: The given details are, To find the output y(t) for the system represented by transfer…

Q: 3. For the given circuit, the lamp will be off when both switches are close. Based on this…

Q: A three phase 410 volt (line voltage) distribution system feeds power to a household load. Each…

A: Line voltage=410volts Load impedance=7+j ohm Line impedance=0.5+j0.5 ohm Given load is in delta…

Q: 19. Determine Vo -5 V OV Si Si 2.2 ΚΩ -5 V o Vo FIG. 2.165 Problem 19. of Fig.

Q: YOUT "It Determine Vout for the following circuit if VIN-12VRMs. the applied frequency of the…

A: Circuit diagram is given as, Input voltage Vin=12 V. Frequency f=122 Hz. Resistance R=780 Ω.…

Q: 17. Compute all the currents labeled in the circuit of Fig. 1.39 assuming the following values: V₁ =…

Q: Q2. For the ideal transformer circuit shown below where Vs=110 V, R₁-692, R2=1792, Xc-1202, n=20.…

A: In this question we need to find the following a) find the source current Find the output voltage…

Q: find the current, i(t) using laplace transform 30. R 100, L = 0.5 H, v = if t > 2 R = 2001 V if 0 <…

A: The circuit diagram, The resistance,R=20 Ω The inductor, L=0.5 H The input voltage, V=200 t

Q: Consider the SEPIC converter operating in ccm with the following parameters: D=0.52, R = 12 22, L₁…

A: SEPIC converter Duty cycle D=0.52 input voltage Vin =112 V switching frequency, f =110 kHz load R=…

Q: $$ 6-49 The OP AMP circuit shown in Figure P6-49 is a band reject filter that will be studied later.…

A: The circuit diagram,

Q: *8. Determine V, and Ip for the networks of Fig. 2.158. +20 V FIG. 2.158 6.8 ΚΩ Vo (b) ID Si -o-20 V

A: In this question, We need to determine the voltage Vo and current ID as shown the circuit. Assume…

Q: Differentiate between Narrow Band and Wide Band Frequency Modulation schemes.

A: FM is a technique for encoding information onto a carrier pulse by changing the frequency.…

Q: What does Thiele-small parameters for a woofer mean?

A: Solution: Thiele-Small parameters are a set of electromechanical parameters that are used to…

Q: if the energy demand is 93.5 kWhr and battery storage capacity is 124.5 kWhr, then the depth of…

A: In this question, We need to choose the correct option. We need to determine the depth of…

Q: Que. Differentiate between Narrow Band and Wide Band Frequency Modulation schemes.

Q: For a 400 kV line the number of :discs is about 18-19 20-22 22-23

A: Line voltage = 400 KV. For the 400 KV line we generally used insulator disc of breaking capacity of…

Q: D The transformer in Figure Q3 has a nominal rating of 75kVA. i) Calculate the transformer impedance…

A: The problem has been solved by referring the impedance to primary side

Q: A resistance R is connected in series with a parallel combination of two resistances 70 and 9 Q.…

A: In this question, We need to determine the resistance R. Power P= V2 /R

Q: Thank you! Can you please also solve parts 4 and 5?

Q: *11. Determine V, and I for the networks of Fig. 2.161. Si 1 V imk 1kQ B GaAs -o V₂

A: In this question, We need to determine the current I and voltage Vo as shown the circuit. Here two…

Q: The switch in the circuit in Fig. P13.11 has been in position a for a long time. At t = 0, the…

Q: An AC generator produces. cycle(s) per revolution for each pair of poles.

A: it is asked to find the cycle(s) per revolution for each pair of poles in An AC generator

Q: 1+ R1 M R2 ✪.

Q: FIND VTH (THEVENINS VOLTAGE AND EXPRESS IT IN POLAR FORM) HANDWRITTEN ANSWER NEEED

A: Given: A network, To find: Thevenin equivalent voltage VTh.

Q: the part where it says REACTIVE POWER = 150 KW × SIN(ARCCOS(0.6) =90 KVAR in the calculator I have…

Q: What is the formula used to find the peak voltage of 100 volts effective A. Peak voltage = .707 x…

A: Effective voltage= 100 volts To find the peak voltage:

Q: 15.31 Design a unity-gain parallel bandreject filter with a center frequency of 250 rad/s and a…

Q: Q4) Give the output signal (s(t)) of ASK, FSK and PSK.

A: We need to draw the output waveforms of ASK, PSK and FSK modulated signals.

Q: Question -7: (a) Making use of repeated source transformations, reduce the circuit of Figure-7 such…

A: In this question, We need to a circuit which contains a voltage source, 17ohm resistance and other…

Q: (a) The waveform shown in the figure above represents the voltage across a 0.2 H inductor for t > 0.…

A: The initial current through the inductor is given and the total current through the inductor needs…

Q: Repeat the previous problem if the power factor at the power input, instead of being unity, turns…

A: Step 1: FIRSTLY WE NEED TO FIND THE APPRENT POWER, REAL POWER AND REACTIVE POWER OF EACH LOAD FOR…

Q: The circuit shown in the given figure is used in a television receiver. What is the total impedance…

A: The question is about finding equivalent impedance in the network.

Q: Luneeee R₁ 50 mH 10 V mms of 1 R₂ :20 µF Y Y Part A In the figure, what is the current supplied by…

A: The circuit diagram, The values of resistors, R1=100 ΩR2=40 Ω

Q: Analyze this circuit to determine the voltages at all nodes and the currents through all Illustrate…

Q: *13. Determine Vo and Ip for the network of Fig. 2.163. +10 Vo Ip Si GaAs FIG. 2.163 Problems 13 2…

Q: Find I, and I, in the circuit in Fig. 19.10.

A: It is given that:

Q: . Practice Problem Consider an RLC circuit and spring-mass-damper shown below. Find T.F.? v(t) i(t)…

A: The ratio of a system's output to its input, as a function of the input frequency, is how the…

Q: A generator produces 80 cycles in 2 seconds, its frequency is ?

A: it is asked to determine the frequency of given generator

Q: The first two rows of Routh's tabulation of a third order equation are as follows. S³ 2 2 s²4 4 This…

A: Given- The first two rows of Routh's tabulation of a third-order equation, s3 2 2 s2 4 4…

Q: 5.7 A plant has the following second-order transfer function. Y(s) 9 X(s) s² + 12s + 9 G(s) a.…

A: The second-order transfer function, Y(s)X(s)=9s2+12s+9

Q: (3) 7.30 8 37-j20 2750 a) if the capacitor is 10uf what is w? b) find the power burned in each…

Q: An alternative to using a Gaussian function for h(t) in the computation of the STFT, it is K cos²…

Q: Consider the resonant circuit shown in Figure 5. Assume that the values of R and L are known and…

A: source voltage is vs(t) considering that below parameter values are known that are Resistance - R…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

4. Given the following circuit, solve for the energy
stored by the Capacitor and Inductor.
4 ΚΩ
2Η
12 ΚΩ
4 mA
24V (+
20nF
6 ΚΩ
16 ΜΑ

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given circuit and what we need to Find

VIEW

Step 2: Status of inductor and capacitor for DC source

VIEW

Step 3: Finding Vc

VIEW

Step 4: Finding Ec and EL

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
List the five capacitor replacement rules.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
For the circuit at right: a. Immediately after the switch is closed, what is the current in the inductor? 12V b. A long time later, what is the current through the inductor? c. What is the energy stored in the inductor in part (b)? d. A long time later, the switch is opened. Immediately after, what is the voltage across the inductor?
QUESTION 5 E-05, PC-01. Capacitor can store energy in form of? Current. Electrical charge. Power. QUESTION 6 E-06, PC-03. An Inductor's time constant is given by? LR. O L/R. L2 /R.
When the switch is in position 1, the circuit will charge the capacitor. Find the Thevenin Equivalent Circuit for the charge phase and determine the time constant (Rh*C) for the charge phase.
Please draw the problem and answer, thank you. A capacitor is made of 2 rectangular metal plates with side length of 3 cm x 6 cm separated by a distance of 2.36 cm with water in between the plates. The capacitor has a voltage of 110 v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate?
The shown circuit is connected for a very long time with all capacitors were initially unchargod. The final charge on C and C2 are Q1 nd 02. respectively. You are given that C 2C2. Ey E and Ey- 17 E. Find the ratio QQ1. R Es
. Find the value of R, if the energized inductor L spends 20 % of its energy in 10 msec after the switch is turned ON. to ImH R=?
The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW