A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 2 .resistor to a 240 Vp-p 50 Hz sinusoidal supply A-Sketch the circuit diagram; B-Estimate the inductive reactance of the coil; C-Calculate the impedance of the circuit; D- Determine the effective current flows in the circuit; E-Obtain the circuit phase angle.

A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 2 .resistor to a 240 Vp-p 50 Hz sinusoidal supply A-Sketch the circuit diagram; B-Estimate the inductive reactance of the coil; C-Calculate the impedance of the circuit; D- Determine the effective current flows in the circuit; E-Obtain the circuit phase angle.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

A 230 V, 50 Hz a.c. supply is applied to a coil of 0.06 H inductance and 2.5 resistance connected in series with a 6.8 F capacitor. Calculate impedance and power consumption and power factor. Now ,In above a.c. circuit, A inductor of 0.2H is connected in parallel with the power supply, find new power factor and power consumption.
13. Susceptance and conductance add to form.A. Impedance.B. Inductance.C. Reactance.D. Admittance.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Complete solution inductance and impedance of the coil.
9. A noninductive load with a resistance of 30 Q2 is connected in series with a capacitor. The capacitor has a capacitive reactance of 25 Q and negligible resistance. The series circuit is energized from a 210 V, 60 Hz source. Determine: a. the impedance of the series circuit. b. the current, in amperes. c. the loss in volts across the noninductive resistance load. d. the loss in volts across the capacitor.
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of 1ohm and an inductance of 10mH, find the source voltage. 5A 2A ton toff output _current
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
PHASE RELATIONSHIP SINUSOIDAL( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
Two impedance coils A and B are connected in series to a 111-volt ac source. Coil A has a resistance of 12 ohms and an inductive resistance of 16 ohms. Coil B has a resistance of 24 ohms and an inductive reactance of 10 ohms. Calculate the voltage drop across each coil. Only in rectangular form
In capacitive AC circuit voltage is leading current O a. True O b. False
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.