e. 235.87 What is the hydrostatic force (kN) that acts on the Gate A-B? Given that the specific gravity of liquid S=3.9. I m Depth of Gate A-B is 6 m 4 m Liquid 30
Q: . Find the depth in furlong of the ocean (s.g. = 1.03) if the pressure at the sea bed is 2,032.56…
A:
Q: A long, solid cylinder of radius 2 ft hinged at point A is used as an automatic gate. When the water…
A: Hydrostatic force and its direction to be calculated
Q: A circular plate 1.2 m diameter is placed vertically in water so that centre of the plate is 2m…
A: A circular plate with a diameter of 1.2 m is positioned vertically in water, 2 metres below the free…
Q: A circular wooden log is floating in water. It has a diameter of 1.41m, length of 6.5m, and…
A:
Q: 1045 kg/m³), A rectangular block float in sea water (psea water it's size 5 m long, 3 m wide and 1.4…
A:
Q: A cube A is 30cm along each edge and weighs 1450N. It is attached to the square prism B which 15cm x…
A:
Q: A square gate (4 m by 4 m) is located on 45° face of a dam. The top edge of the gate lies 8 m below…
A:
Q: al metacentric height, and (b) the f sea water is 10. 045 N/m3
A:
Q: A vat holding paint (s.g. =0.80) is 7 m long (L) and 8 m deep (D) and has a trapezoidal cross…
A: Given datas.g=0.8 (s.g=specific Gravity)L=7 m (L=Length)D=8 m (D=Depth)A=6 m (A=Bottom…
Q: A swimming pool has a width of 4m and a side profile as shown. Determine the a. horizontal…
A:
Q: 1200 m A.
A:
Q: The figure above shows a uniform rectangular lamina OQRS, where OQ = 4a and QR a. A sector OPS of…
A: Given that, The centroid of the rectangle and sector can be given as, The sector of the quarter…
Q: ne area of 5,700m2, with its longitudinal centre mine the new draughts forward and aft if a wei, d…
A: according to questiond2 ∂2udx2=∂2∂t2,0<x<L,t>0since the string is of limited length and it…
Q: Prob-7 Find the height of mercury (y=?) below manometer. PA=10 psi OI 3 ft Oil (s.g.= 0.90) -Mercury…
A: GIVEN DATA- A manometer device given we have to find height of limb y =? Pressure at A =10 psi =…
Q: A trough is full of liquid of weight density 9,000 N/m³. The ends of the trough are equilateral…
A: To set up: The integral for the force on one end of the trough. Given: The weight density of liquid…
Q: Ship weighing 4000 tons and having an area of 465 m² at water line submerging to depth of 4.5 m in…
A:
Q: The sluice gate shown is a circular arc of radius 6m and angle B=50o. The water level behind the…
A: given; radius(r)=6mB=500length(l)=5mdensity of water(ρ)=1000kg/m3
Q: 1. A closed cylindrical horizontal cylindrical tank of radius 1 m contains oil weighing 12 kN/m³.…
A: Given; The radius of cylindrical tank, r = 1 m The oil weight, y = 12 kN/m3 The oil height, h = 1.5…
Q: A loaded truck is transmitting 10 kN pressure on each wheel. The centre of gravity of the loaded…
A: The reaction by ground on Each wheel due to it load is always in upward direction. When the wheel…
Q: A triangular-shaped gate is hinged at point A, as shown. Knowing that the weight of the gate is 100…
A:
Q: In two communicating tubes that contain mercury, a height "h" of water is made by one of them first…
A: To find : The density of liquid . Given: The density of oil is ρoil=0.91 gcm3. The density of water…
Q: The sluice gate shown is a circular arc of radius 6m and angle B=50o. The water level behind the…
A: Radius of the circular arc, R= 6 m Angle, β= 50∘ Length of the gate, L= 5 m To find: Vertical…
Q: 30 60° 8 ft 4 ft y cos 60° c.p. YIRVIAYIK a) Determine the total hydrostatic force of an inclined…
A: Pressure is defined as the intensity of force acting over a unit area. The pressure exerted by the…
Q: The can in Fig. fl oats in the position shown. Whatis its weight in N?
A: Given Submerged height = 8 cm Floated height = 3 cm Specific weight of water = 9790 N/m3 Diameter of…
Q: Plate 30m V, Rx= Given z Rx = 890 Y %3D water
A: Given that, Rx=890 N,head of water, h=30 m,θ=90°ηt=90 % v=2ghv=2×9.81×30v=24.261 m/sec The…
Q: The Mayflower ship having a displacement of 27000 metric tons and a draft of 10.4 m in ocean (sp.…
A:
Q: [Ans. F, = 19.62 kN, F,= unity. 22. Find the magnitude and direction of the resultant water pressure…
A: Deae student as per the policy i can solve only one question for you , request you to please post…
Q: A dam having a triangular section has a vertical face 30m high and base 15m wide. Use SG= 2.4.…
A: Hydrostatic pressure is calculated by multiplying specific weight to depth of water. So depth is the…
Q: g15m Delamine fresine at depth inside liquid Jn suumming feool
A:
Q: Derive a formula for capillary rise (h) between two concentric glass tubes of radiuses RI and R2.…
A: Given Data: Surface tension of glass tube σ=0.072 Nm Glass tube inner radius…
Q: Difference between these two formula of capillary rise h= (2σcosθ)/(rγ) and h= (4σcosθ)/(rγ)
A:
Q: 24. The end gates ABC of a lock are 8m high and when closed make an angle of 120 deg. The width of…
A:
Q: A rectangular scow 9 m wide, 15 m long, and 3.6 m high has a draft in sea water of 2.4 m. its center…
A:
Q: A cylinder (diameter 4 m) of weight 50 kN is placed on the bottom of the tank as shown and oil and…
A: Given data Diameter of cylinder = 4 m Weight = 50 kNAssuming length of cylinder = 1 mWe have to find…
Q: : diameter and 6 m lor riction. [Take density
A:
Q: The 3 x 4-m side AB of a tank is hingrd at its hottom A and is beld in place by a thin rod BC. The…
A:
Q: A homogeneous wooden cylinder of circular section floats in oil of density 900 kg/m^3 with 1.0 inch…
A:
Q: Q= 2m3/S A= 3 m² determine Slau welocity
A: Given data : The value of discharge=Q The value of area=A To find : Flow velocity
Q: Calculate the value of the hydrostatic pressure force acting on the septal septum shown in the…
A:
Q: B 30° 3 m 2 m - 10 m
A:
Q: A circular plate 1.2 m diameter is placed vertically in water such that the centre of the plate is…
A: Answer: (a) The total pressure on the plate is 27.74 kN. (b) The depth of centre of pressure is…
Q: End D of a 2.5 long uniformly plain wooden rod( s.g=0.7) is held 0.3m below the surface of still…
A: S=0.7 mL=length of Uniformly Plain Wooden Rod=2.5 mb=Distance below the surface of still water=0.3…
Q: Hydraulic balance. An m = 60.0 [kg] crate was placed on top of a 2.75 [m²] "massless" platform.…
A:
Q: A conical vessel has a height of 24cm and a base diameter of 12 cm. It holds water to a depth of 18…
A:
Q: 2.154 A very deep 18-cm-diameter can has 12 cm of water, overlaid with 10 cm of SAE 30 oil. It is…
A:
Q: A cylindrical platform of diameter of 2.82 m and height 4.1 m floats in saline water (density = 1026…
A: Given Calculated e) as 17293.23kg and f) as 675.65kg/m3 Need help with g), h) and i)
Q: Find the center of gravity for the plane object shown on the fig. Consider that a is a positive…
A:
Q: The tank shown has one curved surface restraining a body of static fluid, with the following…
A: Find the value of depth of centre of gravity of curved surface from free surface(X-bar) Given data:-…
Q: 3a) The water in a 25-m-deep reservoir is kent inside by a 150-m-wide wall whose cross section is an…
A: Data given- h = 25 m Patm = 100 × 103 Pa
Q: Problem 1 The side of a tank presents a protrusion having the shape of a half sphere having radius…
A:
Step by step
Solved in 2 steps with 2 images
- Answer the following. A: When the pressure of liquid is increased from 3.5 MN/m² to 6.5 MN/m² its volume is found to decrease by (0.08) percent. What is the bulk modulus of elasticity of the liquid? B: An open cylindrical tank (1.2m) in diameter and (1.8m) deep is filled with water and rotated about its central axis at (60 r.p.m). How much liquid is spill and how deep of the water at the central axis.EX 4: Derive an expression for the capillary- height change h, as shown, for a fluid of surface tension Y and contact angle e be- tween two parallel plates W apart. Evaluate h for water at 20°C if W = 0.5 mm. Width b into рарer Fig. P1.70A cylind er with density, p. height, h, radius, r is partially submerging at 6tatic, with depth, u in a fluid with density, Po, os shown Ratio o f a Circ Um ference to its diameter is T1. Determine all the forces acting on the cglinder at y-direction
- 1. A metal plate determined by y = x2 submerged in water as show. Find the total hydrostatic force on 16 the plate. You may leave the density of water as p and gravity as g. Give exact answer. (20,25) Gusten Lo woter level metal plate 16Round off at the final answer only! As illustrated, the semicircular gate AB is utilized to store kerosene. In meters, how far is the center of pressure from A? Kerosene SG= 0.82 5 m 3 m A B -P Gate: Side viewFluid mechanics В FB 1.8 m Water Gate A Hinge A 5.5-m-long (in directen normal to this page) quarter circular gate of radius l-8m is hinged at A as shown Frg ure · Neglecting the weight of the gate and the hinged, determine a) The magnitude and direction of the resultant force to the water. the "gate due on The horizontal force Fe that must be apphed în place to hold the gate the density of water to be 1000 kg/m³ and the gravita fronal constant to be - 9:9.81 m/s² Take
- In the water, a square plate with (side= a) is lying vertically, with its upper horizontal edge touching the water's surface. The positions of the centre of pressure (h*) on the planar surface and the total pressure force (P) will be determined by: [Where, p is the density of water (a) P=pga/2, h=2/3.a (b) P=pga¹/2, h=2/5.a (c) P pga/4, h-2/5.a (d) P=pga/3, h=2/3.a (e) P=pga¹/5, h=2/7.a1. Hydrostatic Force on Plane Surface. An open rectangular tank is 7 m high and has a square base 5 m on a side. If the tank is half-filled with fresh water (density is 1000 kg/m'), determine (a) the total hydrostatic force on a vertical side, in kN and (b) the location of the center of pressure as measured from the liquid surface, in cm. Draw the side view of tank showing the hydrostatic force F and the distance, yp. Is I + Ad a. Magnitude: F = yh,A b.Direction: Perpendicular to the Area c. Location: y, === S.Q3) Find the horizantal and vertical pressure force exerted on the gate (AB) of the tank. I [Tank length = 3.5 m). P=15kq Water r=2m
- H.W2: The tank in Fig. is 40cm wide. Determine the hydrostatic forces on horizontal plan BC and AD? Fluid Mechanics I MSC. Enaš Hashim Abed Lecturer: 55 cm- 40cm - -10cm 35c Solvent, sg 0.84 Water 25cThe surface tesnion of waterr in contact with air at 20deg C is given at 0.0716 N/m. The pressure inside a droplet of water is to be 0.0147 N/cm^2 greater than the outside pressure, calculate the diameter in mm of the droplet of water. a.2.43 b.4.62 c.3.60 d.1.94A closed vessel 1 m in diameter is completely filled with water. If the vessel is rotated at 1200 rpm, what increase in pressure will occur at the top of the tank at the circumference? Ans. 1970 kPa