Find the value of ZL for maximum power transfer in the network and th maximum power that can be transferred to this load. 420°A -j127 Vx 12 j10 2Vx ell

Q: A single phase 1 KVA, 250/100 volt, 50 Hz transformer has: 0.C.T: 100 V,0.5 A, 30 W. S.C.T: 12 V, 4…

A:

Q: .) A load of 23 kVA, wit power factor lagging is connected to a 240 vol How much capacitive r power…

A:

Q: In power factor correction where a motor load is normally operating with 1000 inductive vars, a…

A: In this question,   We need to explain the why inductive VAR power is compensation by the capacitor?…

Q: 2.1.1

A:

Q: Please write a long explanation so that we can report back to you Ideal Non-inverting Operational…

A:

Q: Coulomb's law concern itself with; (A) The interaction between two static charges. B The creation…

A: We need to select correct option for coulombs law

Q: The analysis of the voltage, V for the circuit given in Figure Q4 can be expressed in the following…

A: Id =0.2247 V3 =200 Id =200×0.2247 =44.94 V

Q: 3After being closrd for a long fime, the sioitch in the circutt s pened ot t =O Tind kCt) for t70.…

A:

Q: 2 kn EDIFIC a) What is the required value of R for a 2.2 ka Vout voltage gain of 10 b) Determine…

A: We need to find out  value of resistance and output voltage for given circuit

Q: +15V 3K 2K 1K

A:

Q: Why is it that the induction motor operate less than the synchronous speed?

A: The synchronous speed of an Induction motor can be explained as the speed of rotating magnetic field…

Q: Draw the equivalent circuit if you are going to perform Short cuit Test(SCT)(at terminals a-b, with…

A:

Q: Complete the table. Solve the currents of the circuit using mesh analysis.Note: If there are no…

A: In this question,   We need to determine the loop currents as shown the circuit

Q: Find the z-transform of an–1.

A: In this question,   We need to Find the z-transform of an-1

Q: Find the current and voltage using superposition across the 4- kN resistor(I, and Vx, respectively).…

A:

Q: 2 kn What is the required value of R for a EDIFIC o Vout 2.2 kn voltage gain of 10 b) Determine Vout…

A: Here negative feedback is present so we can apply virtual gorund concept here  According to virtual…

Q: For the circuit shown in the figure below, the delays of NOR gates, plexers and inverters are 2…

A:

Q: Five inductors, each 10 mH, are connected in series across a sine wave ac source. Determine the…

A: Given data, Five inductors each of 10 mH are connected in series.

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

A: Insulation resistance: A material that separates the two conductors or conductors with other systems…

Q: 2. Consider the voltage divider circuit for biasing an n-channel E-MOSFET. Given the following…

A: We need to find out current and voltage for given circuit

Q: Every year the typical American household consumes an average of 10,896 kWh . If the cost per kWh is…

A: Energy is power multiplied by time. One unit of electrical energy is One KWh. Given that a typical…

Q: Find the z-transform of n an un.

A:

Q: -5 V Si O V Si 2.2 k2 6 -5 V Figure 2

A:

Q: OThe t and current is not too high. OThe p.f. is leading p.f. for any possible current.

A:

Q: A2-pole,50Hzinductionmotorsupplies15kWtoaloadataspeedof2900rpm.Calculate

A:

Q: A balance Y-connected load of (3 + j8 ) ohms per phase is supplied by a balanced three- phase, 60…

A: In this question,   We need to determine the voltage VAB  , VCA  and current IA       as per our…

Q: four pole 2-Hp, 220-volts, 60-Hz, 3-Phase motorhas a delta connected stator and a Wye connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Draw the Thevenin and Norton equivalent circuits and reconnect the load resistor R, 2i, + I, 5002 )…

A:

Q: Q4. Determine the value of collector current and collector-to- emitter voltage for the voltage…

A:

Q: e radiation pattern of an antenna is generally observed within: O The radiating near field region.…

A: The radiation pattern of the antenna is defined as the representation of electromagnetic field…

Q: ithin a satellite transponder, the implementation of a Low Noise Amplifier (LNA) is important to:…

A: Low noise amplifier is the starting circuit of the transponder. Ideally LNA should not add any noise…

Q: Solve the voltage across germanium diode of the given circuit below. 32 V lo2 AGe Si Vo 6.8 kohms 4…

A: Here two anti parallel Si and Ge diode  Ge diode is reverse bia  and si diode is forward bias cut in…

Q: The efficiency of the I.M of the same :rating as transformer is

A: Effeciency of Induction motor compared to transformer:

Q: Vhat would be the barrier potential of a silicon diode when the junction emperature is at 10°C?…

A:

Q: Slay Gauss's law of the electrostatics. O Gauss's law of magnetostatics. O Kepler's law where…

A: Satellite stays in the orbit because centripetal force is balanced by centrifugal force. In other…

Q: A 3-phase 50 Hz I.M. has a rated torque = 16.7 N.M and maximum torque = 40.5 N.M. If its rated speed…

A:

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.5z-53.13° ohms. Assume…

A:

Q: 200-kVA transformer has an iron loss of 1 kW and full load copper loss of 2 kW. Its load kVA…

A: The solution is given below

Q: elve for the mesh currents in the previous problem.

A:

Q: A single core cable has a conductor diameter of 1 cm and insulation thickness of 0.4 cm. If the…

A:

Q: 4-pole 3-phase IM manufactured by Engr. KC Trinidad which is rated at 60 Hp runs at a supply…

A: We need to find out torque for given motor

Q: In your own idea using various types of single-phase induction motors, give 2 impacts to the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 3. An automobile tire is inflated to 30 psig pressure at 50 deg. Fahrenheit, after being driven the…

A: Given: P1=20 psigT1=50°FT1=50°F-32×59+273.15T1=283.15 KT2=90°FT2=90°F-32×59+273.15T2=305.372K

Q: 1. A balance Y-connected load of ( 3 + j8 ) ohms per phase is supplied by a balanced three- phase,…

A:

Q: For The circuit shown below; find the currents of all Resistances using Kirchhoff's laws 28A 3 35 N…

A: In this question,   We need to determine the current in the each resistance using the KCL and KVL.…

Q: Determine the output impedance (Zo) for the given network with the following conditions: gfs =…

A: Impedance is calculated the opposite of current flow . it is represented by 'Z'. for direct current…

Q: Q4) Explain briefly the principle of critical angle required for total internal reflection.

A:

Q: Compose the mesh equations. 10 Q j10 O j10 O l i5 v sine 10 V [11] [12] :-10 O sine @mesh 1: Z111 +…

A:

Q: Do the following base conversion: To BCD the following decimal number X1= 2469.

A:

Q: EXAMPLE 1 Determine the magnitude of gm for a JFET with Ipss = 8 mA and Vp = -4 Vat the following de…

A: