How much acetaminophen and caffeine are in a tablet that weight about 525mg and contains 250mg of acetaminophen and 60mg of caffeine. If ground up and diluted to a volume of 250ml of dilute with diluent of 30% methanol, 60 water and 10% acetonitrile. Determine the amount of acetaminophen and caffeine in the tablet and the concentration. caffeine: 194.19 g/mol acetaminophen: 151.163 g/mol

Q: Ten pints of a 5% solution are diluted with 30 pints of diluent, what is the percentage strength of…

A: Initial amount = 10 pints  Diluted by 30 pints.  So, final amount = 10+30 = 40 pints.  So, dilution…

Q: The standard addition method is used to analyze a sample of a river water for mercury. Solution A is…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Measure the mass of 0.400g of Co(NO3)2 + 6H2O and dissolve it in 15mL of distilled or deionized…

A: Limiting reagent is that reacts completely in the reaction.     Number of moles of…

Q: The standard addition method is used to analyze a sample of a river water for mercury. Solution A is…

A: Given, Percent transmittance value of solution A = 56 % Percent transmittance value of solution B =…

Q: A solution is prepared by mixing 50.0 mL of 0.50 M Cu(NO3)2 with 50.0 mL of 0.50 M CO(NO3)2- Solid…

A:

Q: The standard addition method is used to analyze a sample of a river water for mercury. Solution A is…

A: A question based on tools in analytical chemistry that is to be accomplished.

Q: Scientist 1 analyzed the compounds first then gave it to scientist 2 for the next test. Scientist 2…

A: A question based on concentration terms that is to be accomplished.

Q: Arrange the following steps in the correct order. I. Prepare the separatory funnel. II. Mix and…

A: I. Prepare the separatory funnel.                             V III. Add the solution to be…

Q: 5- A chemist is given a nonelectrolyte white powder for analysis. 38.7 g of this substance is…

A: Given  weight of white powder=38.7 gm weight of solvent(water)=100g=100×10-3=0.1 kg freezing of the…

Q: The thiourea in a 1.455 g sample of organic material was extracted into a dilute sulfuric acid…

A: Generally, qualitative analysis refers to the presence or absence of different chemical (number of)…

Q: dissolve then add 1.0 g MgCl26H2O crystals. Mix to  dissolve the crystals. NOTE: The dissolution of…

A: The procedure for preparation of first two solutions is written sufficiently, in the image itself.…

Q: One solution states it contained a saturated 0.25302% dye by mass in ethanol solvent. By measuring…

A: % by mass refers to mass of solute present in 100 g of solution. Molarity is the moles of solute per…

Q: When mixing sodium chlorate solution (volume 1.0L, density 1.1614 g/ml, mass fraction 22%)  with…

A: A balanced reaction is one that contains equal number of atoms of each element in reactants and…

Q: A community in a mountainous area of Bohol uses water collected from a nearby natural spring. A…

A: To describe the preparation of the following reagents: 100 mL of 1.0M stock EDTA solution.  0 L of…

Q: How many ml of 0.241 M Ba(OH)2 will react with 25.00 mL of 0.115 М НCI?

A: This is an example of acid-base reaction. Ba(OH)2 + HCl -------> BaCl2 + H2O

Q: (Concentration) You are tasked to prepare 300.000 ppb of a sodium carbonate standard for a…

A: Parts per billion (ppb) concentration is defined as: mass of solute (in grams)volume of solution (in…

Q: The standard addition method is used to analyze a sample of a river water for mercury. Solution A is…

A: Given, Percent transmittance of solution A = 56 % Percent transmittance of solution B = 33 % Percent…

Q: An impure sample containing 2.00 g of sodium carbonate and bicarbonate was taken. It was dissolved…

A: The question is based on the concept of mix indicator titration. At phenolphthalein end point, Only…

Q: The standard addition method is used to analyze a sample of a river water for mercury. Solution A is…

A: Cold vapour atomic absorption spectroscopy or CVAAS is one of the primary techniques for mercury…

Q: 1. At the end of a reaction, I ended up with a 200 mL aqueous solution containing 20 g of…

A: To solve these problems, we will be using the following equations: KD=XorgVorgXaqVaq .. (1) Here, KD…

Q: Approximately 6.0mL of concentrated perchloric acid (70%) was transferred to a bottle and diluted…

A: 251.5 mg of primary standard Na2B4O7. 10 H2O requires 27.41 mL of HClO4 solution to reach the end…

Q: 30.0 mL of 0.400 M Zn²⁺ is mixed with 100.0 mL of 0.200 M F⁻ (Ksp ZnF₂ = 0.030). In the mixture you…

A: In the given question we have to observe the reaction upon mixing of Zn2+ and F- .  First of all, we…

Q: A solution contains a mixture of Na2CO3 and NaOH. Using phenolphthalein indicator 25 mL of mixture…

A:

Q: In a solution containing 25ml (NH4)2S2O8 with a total volume = 100 ml =0.1 liters , the solution…

A: 1a)The given titration deals with Iodine clock reaction. The two types of reaction that takes place…

Q: Express the concentration of a 0.0160 M aqueous solution of fluoride, F−, in mass percentage and in…

A: The molarity of the fluoride ion is = 0.0160 M The density of the solution is = 1.00 g/mL The molar…

Q: SOLVE FOR ITS WEIGHT/VOLUME REQUIRED TO MAKE 30 ML. SHOW COMPLETE SOLUTION. I NEED IT ASAP AND…

A: PROCEDURE- 1.  Triturate acacia gum with the water in a mortar to form mucilage. 2.  Add cod liver…

Q: Dissolution 0.01 M HCI Distilled H20 Concentration (mg/ml) Total amount Concentration (mg/ml) Time A…

A: Dissolution is the process where a solute in gaseous, liquid, or solid phase dissolves in a solvent…

Q: CaCl2 and diluting to 150.0 mL. a. Calculate moles of Na", Ca2* and Cl- in the solution b. Using…

A:

Q: If the solubility of a compound A in ether is 30g/100 ml, and the solubility of A in water is 15 g…

A: distribution ratio(ξ)=concentration of A in etherconcentration of A in water…

Q: An unknown 36% v/v monohydroxide reagent has a density of 1.8 g/mL. Zeus wanted to determine the…

A: Suppose, concentration of the unknown base in 36% v/v solution is S M The required formula is: V1×S1…

Q: What is the minimum distribution ratio (Dc) if 98% of the solute in a 25.0-mL sample in an aqueous…

A:

Q: “Oh man, our supply person didn’t put in our order for 70% alcohol. All we have are liters of 100%…

A: Given that, alcohol with concentration of 100% and 90%. we have to make different concentration of…

Q: Which statement about the determination of the percentage purity of benzoic acid is correct? *…

A: We have given statements , we have to choose correct statement

Q: How do you prepare 250 ml 0.05 M CuCl2 solution from 0.1 M CuCl, stock solution? Lütfen birini…

A: The 250 mL of from 0.1 M can be prepared by using the formula given below as;…

Q: y pipet, 5.00 mLmL  of a 0.823 MM stock solution of potassium permanganate (KMnO4) was transferred…

A:

Q: One litre of aqueous sample containing the organic pollutant, polychlorinated biphenyl (PCB), was…

A: Distribution ratio /partition coefficient is the ratio of concentration of solute in organic layer…

Q: A weight of 0.50 g was taken impure container containing sodium carbonate and bicarbonate. Dissolved…

A: In the carbonate composition analysis, the mixture containing unknown amounts of sodium carbonate…

Q: ▪ A pharmaceutical analyst needs to do quality control of a sodium furosemide solution. The max for…

A: Absorbance = Absorptivity coefficient × Concentration × Path length Path length = 1 cm Absorptivity…

Q: are given a container with Na3PO3 that is reportedly contaminated. You are asked by your supervisor…

A: Since, first three parts of the questions are experimentally based, out of QA scope. Therefore, we…

Q: Preparation of 100 ml 1.0 molar (1.0M) H2SO4 solution (specific gravity, 1.8 g/ml and purity, 98%).…

A: Molarity is defined as the number of moles of solute dissolved per liter of the solution. Molarity,…

Q: Example / What volume of 0.40 M Ba(OH)2 must be added to 50 mL of 0.30 M NAOH to give a solution…

A: 1 mmol of Ba(OH)2 = 2 mmol of OH 1 mmol of NaOH = 1 mmol of OH Number of mmols = molarity x volume…

Q: Cg 162 liters of a liquid chemical with a dimension less Henry's volatility constant of KG° Caq…

A:

Q: 17 g of unknown organic sample was dissolve in 564 mL of Dicloromethane (DCM). The boiling point of…

A: NOTE: It will be benzene only and not DCM as the data is given for benzene and there is a typo error…

Q: How do you prepare 250 ml 0.05 M CuCl2 solution from 0.1 M CuCl2 stock solution? Lütfen birini…

A: Given that: volume of CuCl2 V1 = 250 mL molarity of CuCl2 M1 = 0.05 M molarity of CuCl2 stock…

Q: You want to determine the concentration of NaCl in a water. In preliminary analysis, it appears to…

A: In order to determine the concentration of NaCl in water we first write down the given data:…

Q: of methylene chloride  BA + NaOH --> sodium benzoate + H2O BA = 0.0205 M NaOH = 0.0189 M NaOH…

A: In the above we have to calculate the distribution coefficient K

Q: concentration of the total suspended solid. In the laboratory, 5 mL of the water sample was…

A: Initial weight of glass fiber filter = 0.2431 g = 243.1 mg  and Glass fiber filter + suspended solid…

Q: The first goal is to make the oxalic acid standard solution.  You measure 1.5232 g of oxalic acid on…

A: Since, Number of moles of a substance is the ratio of mass of the substance to its molecular mass.…

Q: : A stock solution of 70% v/v ethanol was diluted with distilled water to prepare 1L of 21% v/v…

A: Solution- inital volume=V1Initial concrntrationS1=70%(v/v)Final volumke V2=1Lfinal concentration…

Q: solution was prepared by dissolving 413 mg of  K3Fe(CN)6 (329.2 g/mol) in sufficient water to give…

A: The solution of the given question is