I want the solution in 30 min. In an electrometer, the movable plate is 11 cm in diameter. When 12 kv is applied between the movable plate and the fixed plate, The force is 0.006N. what is The change in capacitance for 1.5 mm movement if the movable plate Ans=0.125*10^-12 F

I want the solution in 30 min. In an electrometer, the movable plate is 11 cm in diameter. When 12 kv is applied between the movable plate and the fixed plate, The force is 0.006N. what is The change in capacitance for 1.5 mm movement if the movable plate Ans=0.125*10^-12 F

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: (General material - counts as Post Test 2 material) True/False: circle the correct answer T/F As an…

A: a) Ans: False Reason: e- neither lose or gain the charge b) Ans: False Reason: Vab=Va-Vb =10 ;…

Q: Find the voltages across each of the capacitors in the circuit shown below. Hint: Ground Node B and…

A: apply KCL at two nodes and than find VC and VD. according KCL sum of the charge entering the node =…

Q: plates is 4d, the area of the parallel plates is A / 2 and the energy stored in the system is 2W,…

Q: B. Measurment of the Electric Field Table (1.2) V(volt) d(cm) 0.6 0.9 1.1 11 1.4 13.5 1.6 15.5 1.9…

Q: Total charge entering a terminal is given as q=5tsin40t mC. Calculate the current at t=0.5 s.

A: Given; q=5tsin40t mCt=0.5 s

Q: The following data refers to a moving coil voltmeter: resistance = 10.000 N, dimensions of coil = 30…

Q: State in your own words/understanding those terms found below. Elaborate by an example if necessary.…

A: In this question we will write about columbs law, electric field and free space permittivity....…

Q: A 120 V potential difference is applied to a space heater whose resistance is 13Q when hot. (a) At…

A: Given: Potential difference V=120 V Resistance R=13 Ω

Q: curved bar in semicircular shape contains a charge Q = 60 µC the potential at point O of the origin…

A: We need to select correct option for potential due to charged semicircular bar at centre of…

Q: a parallel plates capacitor . the area of the one of ite plates A=5cm2 and the distance between…

A: electric field between the plates E=voltage difference across platedistance between plates.…

Q: A solenoid has a length of 88cm and has a core of free air. It is wound with 4600 turns of wire and…

A: In this question we will find area of solenoid with given data .

Q: potentials across the first and second insulator from the top are 8 kV and 11 kV respectively.…

A: The solution can be achieved as follows.

Q: Calculate the work required to bring a charge of 5.9 × 10-9 c from infinity to a point 28.7 cm from…

A: The work required to bring a charge q against field is given as: W=qV where V is the potential due…

Q: An energy meter is designed to make 100 revolutions of the disc for one unit of energy. Calculate…

A: Given:

Q: 3- The charge on the capacitor in the network of Fig. is 2 coulombs. If the switch K is closed at…

A: (a) E = 100 V The initial charge is q(0) = 2 C The initial voltage across the capacitor, VC(0) =…

Q: 4- Can value of the string efficiency being equal to 100%. Explain your answer

A: As per guidelines, the first question will be answered. The expression for the string efficiency is…

Q: Find the charge on the capacitor in the circuit shown in the figure. The capacitance of the…

Q: a surface current density K is measured in terms of: Select one: O a. A.m O b. A/m2 O C. A/m3 O d.…

A: Surface current density - current per unit area

Q: The parallel plates have an area of 2000 cm2 and are separated at 1.00 cm apart. The original…

A: The solution is given below

Q: 2

Q: The potential difference V is defined as the work done by an external source in moving a unit…

A: Given: The potential difference V is defined as the work done by an external source in moving a unit…

Q: (i) The base of a block of metal is square with each side of length X(metres) and the height of the…

Q: A hollow cylinder of length 2 m has its cross section as shown in Figure below. If the cylinder is…

A: Given: Length l =2m σ=105 mho S/m ρ=1105 Ωm a = 3 cm b = 5 cm

Q: Suppose we have a washer-shaped object with conductivity 50 S/m. The inner radius is a = 3 mm, the…

A: The solution is given below

Q: How many ohms of opposition does the series combination of resistor and capacitor offer? What name…

A: Given , Resistance R = 3 kohm Capacitive reactance (Xc) = 4 kohm Source voltage (Vs) = 5 V…

Q: R=4.4 ohm a) calculate the time constant T of the circuit? d) calculate how much charge will be…

A: In the question If the R=4.4 ohm a) calculate the time constant T of the circuit? B) calculate how…

Q: A 200-turn solenoid produces 400,000 Maxwell when excited by current of 2 amps. Calculate the…

Q: We have 2 + charges at a distance d. We then move them further apart. True or False: As the…

Q: In the figure shown the total resistance is 30 kN, and battery's emf is 18 V. If the time constant…

A: Time constant of RC is given by R*C. And time constant of circuit is 12 μs. Equating the two we get…

Q: 17) (a) Find the equivalent capacitance between terminals a and b of the circuit shown below. Ceq =…

Q: Q2- What are the limitations of Townsend's theory? Q3- In an experiment in a certain gas it was…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Calculate the inductance of the inductive sensor detecting a Carbon steel bar. (The Bar has an end…

A: Given values are N=137 turns t=3mm r=2mm d=2mm R=40m P=36m Permeability of IRON=5000 Permeability of…

Q: 1.) The terminal voltage of a voltage source is v = 6 sin 2t V. If the charge leaving the positive…

Q: R3 R1 R4 R2 For the circuit shown in Figure, find the charge in the capacitor in units of Micro…

A: Given ; R1 = 15ΩR2 =60ΩR3 = 35ΩR4=40ΩC =7μFε =6v We know that after a long time the capacitor…

Q: Given that a single point-like charge of -40 μC is fixed at the origin, calculate the work required…

A: q1=-40μCq2=60μCr1=14cm=0.14mr2=25cm=0.25m

Q: A 200-turn solenoid produces 400,000 Maxwell when excited by current of 2 amps. Calculate the…

Q: A 1,000 ft. of aluminum wire, whose diameter is 0.365 in., has a resistance of 0.13 Q at 20°C. What…

A: According to the question we have to find the value of percentage conductivity.

Q: A single energy meter has a meter constant of 200rev/kwh. When supplying a non-inductive load of 4.4…

Q: QUESTION 1 In the circuit shown, determine the following: a.) The terminal voltage of battery E6 is…

A: To find the voltage difference and terminal voltage of the battery

Q: An inductance of 2 henries and a resistance of 20 ohms are connected in series with an emf of E…

Q: The University of Misan College of Science First year Electricity Dr. Munther Q1/ Three point…

A: as we know that coulomb's law state that, F=Kq1q2r2f=forceq=chargek=constantr=distance

Q: a) Find the mathematical expression for current İ2(t)

A: Find the mathematical expression for current İ2(t) as per our guidelines we are supposed to…

Q: It is possible to measure DC high voltages with the help of two spheres of equal radius placed on…

A: Given: Ed=30 kV/cm2 k=0.9 d= spacing of spheres =3 cm

Q: An inductance of 1 henry, a resistance of 1600 ohms, and a capacitance of 10-6 farad are connected…

A: Given, R = 1600 ohm L = 1 H C = 10^(-6) F emf, e(t) = 100 sin(600t) volts Initially…

Q: 1) L=850 mH C=280 uF For circuit; a) Find the time constant for t> 0. b) Find the equation for İ0…

Q: Assuming that there is no initial charge on the capacitors, compute the value for Vc if the switch…

A: When switch is moved to position 1 the circuit is

Q: Calculate the required number of turbines we need in a wind farm generating 12 MW if cach turbine…

A: Given in the questions: Length of the blades, L = 12m Velocity of wind, V = 12m/sec Air density,…

Q: Wind mill with 2 m diameter works on the principle of converting kinetic energy of the wind in to…

A: Diameter =2m Radius r=1 m. Area a=Πr²=3.14 Air density ρ=1.225kg/m³ Wind speed v=20 m/sec

Q: Q3: Determine 10mm×1mm×1mm sample, a magnetic field 0.2wb/m2 is superposed on applied voltage 1mV.…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

I want the solution in 30 min.

In an electrometer, the movable plate is 11 cm in diameter. When 12 kv is applied between the movable plate and the fixed plate, The force is 0.006N. what is The change in capacitance for 1.5 mm movement if the movable plate

Ans=0.125*10^-12 F

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
Here are the choices: Lorentz law charge Faraday's law Ohm's law Capacitance Resistivity of materials Resistance vs Strain
Two parallel wires made of copper are placed in air. The inductance of each wire is 0.9 µH/m with diameter of 2mm. The external inductance is? 0.85 µH/m 0.85 H/m - 0.85 µH/m 0.85 mH/m 0.85n µH/m None O uH/m - 0.85 µH/m -0.85n µH/m
Paramagnetic materials have relative permeability Equal to that ferromagnetic materials Slightly less than unity Slightly more than unity Equal to unity
question 22 What is the relative permeability of a ferromagnetic material whose absolute permeability is 750 * 10-6 Wb/At*m? (vacuum permeability is 4p 10 Wb/At*m) O 9.42 10 -10 O 597 O 16.75 O 0.1675
If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
equal * Calculate the equivalent inductance. L mm L = 5 Henry A mm mm Leg. ramm ma
If the number of turns is doubled, what will happen to the inductance?
Capacitance increases with O a. Increase in plate area and decrease in distance between the plates b. Decrease in the plate area and value of applied voltage c. Reduction in plate area and distance between the plates O d. Increase in the plate area and distance between the plates
Determine the waveform on the load: a) If this were a resistance b) If this were a capacitor
There is 50 mA of current through a coil with 250 turns. The flux is 150 µWb. What is the mmf? What is the reluctance of the circuit? A. Fm = 1.25 At - R=4.3x10-3 At/Wb B. Fm = 2.25 At - R=8.3x10-3 At/Wb C. Fm = 1.25 At - R=8.3x10-3 At/Wb D. Fm = 1.25 At - R=8.3x10-2 At/Wb
Calculate the inductance for a coil with 120 turns, a current of 0.47 mA, and a flux of 1.2x10Wb. a S w R lill