In power system scenario of Sultanate of Oman, the present installed capacity in year 2021 is 9000MW. The peak demand is 8500MW. The annual increase in peak demand is happening at the rate of 10%. (a) Calculate the Future Reserve margin of the system in year 2022 if no additional installed capacity is added to the system. I Write Future Reserve Margin as answer) (b) What is your inference for reporting to higher officials as a Electrical reliability Engineer from above mentioned calculation for year 2022? [Write your answer in one sentence]

In power system scenario of Sultanate of Oman, the present installed capacity in year 2021 is 9000MW. The peak demand is 8500MW. The annual increase in peak demand is happening at the rate of 10%. (a) Calculate the Future Reserve margin of the system in year 2022 if no additional installed capacity is added to the system. I Write Future Reserve Margin as answer) (b) What is your inference for reporting to higher officials as a Electrical reliability Engineer from above mentioned calculation for year 2022? [Write your answer in one sentence]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units (b) Give the assumption taken for the calculation of LOLP? [Write relevant Answers in 1 or 2 sentences in each part)
Mention and discuss the uncertainties affecting the power system operation and planning indices.
Discuss the role of power system protection in ensuring the safety and reliability of electrical grids.
Discuss the importance of power system stability and reliability in the context of electricity generation and distribution.
Give example scenarios in 'Power Grid Extension' and explain
Choose which answers are correct Which among the following , is not an objective of unit commitment ? a . Maintain Power balance b . Minimize the operating cost c . Commit minimum number generating units d . Commit sufficient generating units
Q5. An essential part of the design of power supply network is the calculation of the currents which flow in the components when faults of various types occur. Explain briefly why fault calculation is an essential part of the design of power systems. Discuss the TWO different types of faults that are common in power systems; their causes; and method of calculation.
Explain the concept of electrical grid reliability and its importance.
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.
(a) Give the condition for the loss of load in a power generation system in terms of outages in generation units. (b) Give the assumption taken for the calculation of LOLP?
What is the role of power system stability analysis in ensuring the reliable operation of the electrical grid? Discuss various stability issues and techniques for addressing them.
Power System Analysis (522EE) 431 It is recommended to use a software program to solve the nonlinear equation in Q2 (b). Question 1: Figure 1 shows a single-line diagram of a three-phase, 60-Hz synchronous generator, connected through a transformer and parallel transmission lines to an infinite bus. All reactances are given in per-unit on a common system base. If the infinite bus receives 1.0 per unit real power at 0.95 p.f. lagging, determine (a) the internal voltage of the generator and (b) the equation for the electrical power delivered by the generator versus its power angle 8. B12 B21 X12 = 0.20 G XTB = 0.10 B11 X = 0.30 Vous = 1.0 822 Xi3 - 0.10 = 0.20 B13 Figure 1