ANSWER IS NOT 110 The calcium ion binds to a certain protein to form a 1:1 complex. The following data were obtained in an experiment.Total Ca2+/µM60.9122186250.536Ca2+ bound to Protein/µM31.451.463.671.083.6Determine graphically the dissociation constant of the Ca2+-protein complex. The protein concentration was kept at 97 µM for each run. (1 µM = 1x10-6 M.)%3DKd110

The binding of ligand to a receptor is one of the most important activity in cell. This activity…

The calcium ion binds to a certain protein to form a 1:1 complex. The following data were obtained in an experiment. Total Ca2+/µM 60.9 122 186 250. 536 Ca²+ bound to Protein/µM 31.4 51.4 63.6 71.0 83.6 Determine graphically the dissociation constant of the Ca2+-protein complex. The protein concentration was kept at 97 µM for each run. (1 µM = 1×10-6 M.) Kg = 110

The calcium ion binds to a certain protein to form a 1:1 complex. The following data were obtained in an experiment. Total Ca2+/µM 60.9 122 186 250. 536 Ca²+ bound to Protein/µM 31.4 51.4 63.6 71.0 83.6 Determine graphically the dissociation constant of the Ca2+-protein complex. The protein concentration was kept at 97 µM for each run. (1 µM = 1×10-6 M.) Kg = 110

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter16: Applications Of Neutralization Titrations

Section: Chapter Questions

Problem 16.10QAP

See similar textbooks

Similar questions

The calcium ion binds to a certain protein to form a 1:1 complex. The following data were obtained in an experiment. Total Ca2+/µM 60.9 122 186 250. 536 Ca2+ bound to Protein/µM 31.4 51.4 63.6 71.0 83.6 Determine graphically the dissociation constant of the Ca²+-protein complex. The protein concentration was kept at 97 µM for each run. (1 µM = 1x10-6 M.) Kd =
The calcium ion binds to a certain protein to form a 1:1 complex. The following data was obtained in an experiment: Total Ca2+/uM 60 120 180 240 480 Ca2+ bound to Protein/uM 31.2 51.2 63.4 70.8 83.4 Determine graphically the dissociation constant of the Ca2+ - protein complex. The protein concentration was kept at 96uM for each run. (1uM = 1 x 10-6 M.)
The addition of a small amount of a salt, such as (NH4)2SO4, to a solution containing a charged protein increases the solubility of the protein in water. This observation is called the salting-in effect. However, the addition of large amounts of salt can decrease the solubility of the protein to such an extent that the protein precipitates from solution. This observation is called the salting-out effect and is used widely by biochemists to isolate and purify proteins. Consider the equilibrium PXν(s) ⇋ Pν+(aq) + ν X−(aq), where Pν+ is a polycationic protein of charge ν+ and X− is its counterion. Use Le Chatelier’s principle and the physical principles behind the Debye–Hückel theory to provide a molecular interpretation for the salting-in and salting-out effects.
7 How is the variation in sample composition in a powder random mix influenced by the proportion of active ingredient particles and by the total number of particles in the sample?
You carry out an experiment on the physical properties of 3 organic compounds and observe the following data: Substance Solubility in Water medium Compound A low Compound B high Compound C You know that the 3 organic compounds are an alkene, ketone and alcohol of equal hydrocarbon length. Match the compounds above to their specific organic compound type based upon their solubility. And give a structural reason for the solubility observations that are observed. Substance Identity Reason Compound A Compound B Compound C
A chemical solute has a partition coefficient of 11.2 between hexane and water. If the equilibrium concentration of solute in hexane is 0.00815 M, the equilibrium concentration of the solute in water is: a)7.59 x 10-4 M b) 0.0913 M c)0.00815 M d)1.37 x 103 e)None of These
Q3/ Calculate the solubility of barium carbonate BaSO4 in a solution containing MgSO4 0.04M taking into consideration the activities. Compare the result if the effectiveness is not taken into consideration, KSP BaSO4 = 1.08 x 10 -10
Liquid-liquid extraction is a means of separating the components of a mixture which relies on the differential partitioning of the components in two immiscible liquids. Define the term immiscible. O 1) Two solvents that do not mix together O 2) Two solvents that do mix together
How is the operation of an ion selective probe used to measure pH. How does it specifically relate to the probe interface?
The U.S. Federal Water Pollution Control Act P.L. 92-500,specifies legally acceptable methods for testing wastewater. The analysis of cyanide is performed according to the methods set out in the "Standard Methods for the Examination of Water Wastewater". This method indicates that it should be added prior to wastewater mercury chloride I (HgCl), to decompose the complex cyanides and thus be able to take a sample to perform the content analysis of cyanide. However, it should also be noted that the Illinois Pollution Control Board (IPCB) has established wastewater quality standards that limit the content of mercury (such as Hg) at 0.0005 ppm maximum in any effluent. A company that has a wastewater treatment plant applies 200 mg of mercury chloride per day before each cyanide analysis. a) Will this company comply with the maximum allowable limit of mercury according to the IPCB if discharges 100,000 gal/day of effluent and performs a daily cyanide analysis?
Two different proteins X and Y are dissolved in aqueous solution at 37 ∘C. The proteins bind in a 1:1 ratio to form XY. A solution that is initially 1.00 mM in each protein is allowed to reach equilibrium. At equilibrium, 0.17 mM of free X and 0.17 mM of free Y remain. What is Kc for the reaction? Express your answer using two significant figures.
Solution 1 Solution 2 Solution 3 Solution 4 Solution 5 Concentration iron(III) nitrate 0.00200 0.00200 0.00200 0.00200 0.00200 [Fe(NO3)3] (M) Concentration potassium thiocyanate 0.00200 0.00200 0.00200 0.00200 0.00200 [KSCN] (M) Volume Fe(NO3)3 (mL) 5.00 5.00 5.00 5.00 5.00 Volume KSCN (mL) 5.00 4.00 3.00 2.00 1.00 Volume DI water (mL) 0.00 1.00 2.00 3.00 4.00 Initial concentration [Fe3+] (M) 0.00100 0.00100 0.00100 0.00100 0.00100 Initial concentration [SCN‍] (M) 0.00100 0.000800 0.000600 0.000400 0.000200 Absorbance 0.269 0.192 0.154 0.104 0.052 Equilibrium [FeSCN2+] (M) 0.000198 0.000141 0.000113 0.0000765 0.000038 Equilibrium constant Kc Average Kc