The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure. Calculate: 1. Current in each section if without the interconnector 2. Power loss in the distributor if without the interconnector 3. Current in the interconnector

The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure. Calculate: 1. Current in each section if without the interconnector 2. Power loss in the distributor if without the interconnector 3. Current in the interconnector

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.30MCQ

See similar textbooks

Similar questions

The figure below shows a ring distributor with interconnector BD. The supply is given at point A. The resistances of go and return conductors of various sections are indicated in the figure, current in the interconnector and *voltage drop in the interconnector are
Which of the following statement is true? a. three phase ac secondary distributor has 4 conductors. b. three phase ac secondary distributor has 2 conductors. c. three phase ac secondary distributor has 3 conductors. d. three phase ac secondary distributor has one conductors.. Clear my choice
12 - Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters and three-wire cables up to ……... meters are used in standard designs. A) 10-150B) 40-500C) 50-195D) 30-230E) 200-1000
3. What are the classifications of Core Loss and Copper Loss?
b. traveler (ti)*) D. Several factors or conditions can cause conductors to overheat, but often overlooked is the possibility A a. induction heating b. ambient temperature C. the size of conductors d. grounding
INSULATORS A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.14 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135 KV. Find the Voltage distribution across each unit. Draw the diagram.
One advantages of load balancing is that each phase conductor carries the ? current value
3. The zero sequence current is times the current in neutral wire.
A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.05 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 90 KV. Find the Voltage distribution across each unit. Draw the diagram.
E A 2-wire d.c. ring distributor is 400 m long and is fed at 240 V at point A. At point B, 150 m from A, a load of 150 A is taken and at C, 100 m from B, with load of 40 A and at D, 25m in the opposite direction from A, a load of 200 A is taken. If the resistance per 100 m of single conductor is 0.04 22, find: (i) Current in each section of distributor (ii) Voltage at points B, C and D.
Discuss causes of insulation failures in high voltage engineering. High voltage engineering
A 2-wire d.c. distributor cable AB is 3 km long and supplies loads of 100A, 150A,200A and 50A situated 600 m, 1000 m, 1500 m and 2000 m from the feeding point A. Each conductor has a resistance of 0.02 ohm per 1000 m. Calculate the p.d. at each load point if a p.d. of 350 V is maintained at point A.