Three resistors are given with the following color codes Each of the m tions and the currents passing through each resistor are measured and volte omplete the data in the table, the multi-tester readings are shown below and on the next ge Resistor Color Resistance Nominal value (k) Measured Current (mA) Mesvared RI Red Black Red Gold R2 Orange Brown Red Gold R3 Yellow Green Red Gold Resistor 1 readings DIVA -88 150 2.5m DCV 50µ 25m DCA Ω 0.25 Resistor 2 readings 22 9 200 10 22% OCKA OCVA 800 183 -88 156 2341 1000 250 DCV 50 0.1 DCA Ω 10 0.25 2.5 4 229 20 128 100 150 ggo. 6 30 8 50 40 نستـ . 200 -28 100 01-> 683 200 DOVA OCVA OCVA- ACV ADV 2.5m DCV 50μ DCA Ω 0.25 Resistor 3 readings 222 1000 250 DCV 25m 50 0.1 DCA Ω 10 0.25 2.5 0 01 20 2.5 OCVA DCV 80 5 209 10 -28 6 20 100 150 50 235 30 40 0 200 0 10 250 50μ DCA Ω 2.5m 0.25 25m SDCVA ACV OCVA 50 -28 100 -10 7681 -5 1000 250 DCV 50 0.1 DCA Ω 10 0.25 2.5 -

Three resistors are given with the following color codes Each of the m tions and the currents passing through each resistor are measured and volte omplete the data in the table, the multi-tester readings are shown below and on the next ge Resistor Color Resistance Nominal value (k) Measured Current (mA) Mesvared RI Red Black Red Gold R2 Orange Brown Red Gold R3 Yellow Green Red Gold Resistor 1 readings DIVA -88 150 2.5m DCV 50µ 25m DCA Ω 0.25 Resistor 2 readings 22 9 200 10 22% OCKA OCVA 800 183 -88 156 2341 1000 250 DCV 50 0.1 DCA Ω 10 0.25 2.5 4 229 20 128 100 150 ggo. 6 30 8 50 40 نستـ . 200 -28 100 01-> 683 200 DOVA OCVA OCVA- ACV ADV 2.5m DCV 50μ DCA Ω 0.25 Resistor 3 readings 222 1000 250 DCV 25m 50 0.1 DCA Ω 10 0.25 2.5 0 01 20 2.5 OCVA DCV 80 5 209 10 -28 6 20 100 150 50 235 30 40 0 200 0 10 250 50μ DCA Ω 2.5m 0.25 25m SDCVA ACV OCVA 50 -28 100 -10 7681 -5 1000 250 DCV 50 0.1 DCA Ω 10 0.25 2.5 -

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 64PQ: Ralph has three resistors, R1, R2, and R3, connected in series. When connected to an ideal emf...

See similar textbooks

Similar questions

Determine the values of the current flowing through each of the resistors. Apply Nodal Analysis (don't answer if you already answered it, need other solution thank you)
An Op Amp network is given in the figure below. Find out the output voltages Vo. 20e kA. I5KL 600 k 30 ka 30 kA -20mV
Determine the values of the current flowing through each of the resistors. Apply Nodal Analysis (don't asbwer if you already answered it, need other perspectives thank you)
Quèstion 3 What is the smallest possible value of this resistor? A Moving to another question will save this response. W E R b caps lock uhift 1 In cui Dependable perforre Thoughtful deie donde d
DETERMINE THE VALUES OF ALL CURRENTS.FLOWING ON EACH OF THE RESISTROR USE MESH ANALYSIS
In the following phasor diagram 90° V O a. voltage lags O b. 'v' and T' are in phase O c. voltage leads O d. current leads
ut of Jestion R www Battery The measured value of the voltage is V = 5.9 + 0.4 V and that of the resistance is R = 14 + 0.5 O. The current through the circuit (in Ampere (A)) can be calculated using the formula, I =V/R. Calculate the, a) Current (in Ampere) = 0.42 b) Fractional uncertainty in the current = c) Absolute uncertainty (in Ampere) in the current =
Calculate the RTOTAL, ITOTAL, Individual Voltages and Individual currents across each resistors/loads
Inew A circuit with a resistance R = 73 Q is connected to a battery with potential difference across the terminals of AV = 8.5 V. Input an expression for the current passing through the circuit, I. What is the current in milliamps, mA? If the resistance of the circuit was increased by a factor of ten, Rnew = 10R, what is the new current in milliamps, mA?
In the below figures the current vs amper-hour rating plot of a 12Vbattery is given. The figure on the right is the circuit where this battery is utilized as the power supply. Consider the following operation conditionsi. R1 = 110Ω for 5 hourii. R1 = 30Ω for 5 houriii. R1 = 20Ω for 5 hourThe internal resistance of the battery is Rint = 10 Ω.Please, find the followinga) Amper-hour consumption for each operation.b) Rate of each consumption to the capacity of battery (Hint: Capacity is specified for certain operation currents)c) Total consumed capacity in percentages.d) Remaining capacity in percentages.e) Find the duration of operation with the remaining capacity (If any), if thecurrent drawn from the battery is 200mA.
The power rating of a resistoris the maximum power the resistor can safely dissipate without toogreat a rise in temperature and hence damage to the resistor. A 9.0 kΩ resistor is to be connected across a 120 V potential difference. What power rating is required?
Tow resistors R, and R2 are conneoted in parallel in an elec+ric aircuit.IP the resis tor Ri is ehanged Prom 16 to 6.2 ohn's aud Rz is changed From 22 to 21.8 ohm's, fiud the absolute change, * relative ehange aud percentage in the totel KEES resistance R.