Concept explainers
Whether, the pulse travels faster, slower or at a constant speed when it travels toward the ceiling.
Answer to Problem 1P
Pulse travels faster toward the ceiling.
Explanation of Solution
Introduction:
Speed of the pulse depends on the medium properties.
A pulse travelling on a rope or string depends on the tension in the rope/string and the linear mass density of the rope/string.
The relation between the speed and other two quantities is given as:
Where, T is the tension in the rope and m is the linear lass density which is the ratio of the mass of the rope and the length of the rope.
If one considers a small part of the rope near the ceiling, it is under the maximum tension as it is being pulled by rest of the length of the rope. The portion of the rope at the open end is under the least tension. Hence, the tension in the rope increases from open end to hanging end.
As speed is directly proportional to the tension, therefore, speed of the pulse will increase while travelling in upward direction.
Conclusion:
Thus, when the tension in the rope will increase, the pulse speed increases as it moves towards the ceiling.
Want to see more full solutions like this?
Chapter 15 Solutions
Physics for Scientists and Engineers
- The wave is a particular type of pulse that can propagate through a large crowd gathered at a sports arena (Fig. P13.54). The elements of the medium are the spectators, with zero position corresponding to their being seated and maximum position corresponding to their standing and raising their arms. When a large fraction of the spectators participates in the wave motion, a somewhat stable pulse shape can develop. The wave speed depends on peoples reaction time, which is typically on the order of 0.1 s. Estimate the order of magnitude, in minutes, of the time interval required for such a pulse to make one circuit around a large sports stadium. State the quantities you measure or estimate and their values.arrow_forwardAn ambulance with a siren (f=1.00kHz) blaring is approaching an accident scene. The ambulance is moving at 70.00 mph. A nurse is approaching the scene from the opposite direction, running at vo=7.00 m/s. What frequency does the nurse observe? Assume the speed of sound is v=343.00 m/s.arrow_forwardEquation 16.40 states that at distance r away from a point source with power (Power)avg, the wave intensity is I=(Power)avg4r2 Study Figure 16.25 and prove that at distance r straight in front of a point source with power (Power)avg moving with constant speed vS the wave intensity is I=(Power)avg4r2(vvSv)arrow_forward
- Porpoises emit sound waves that they use for navigation. If the wavelength of the sound wave emitted is 4.5 cm, and the speed of sound in the water is v=1530 m/s, what is the period of the sound?arrow_forwardA sound wave in air has a pressure amplitude equal to 4.00 103 Pa. Calculate the displacement amplitude of the wave at a frequency of 10.0 kHz.arrow_forwardA copper wire has a radius of 200 µ m and a length of 5.0 m. The wire is placed under a tension of 3000 N and the wire stretches by a small amount. The wire is plucked and a pulse travels down the wire. What is the propagation speed of the pulse? (Assume the temperature does not change: (=8.96gcm3,Y=1.11011Nm) .)arrow_forward
- The tensile stress in a thick copper bar is 99.5% of its elastic breaking point of 13.0 1010 N/m2. If 500-Hz sound wave is transmitted through the material, (a) what displacement amplitude will cause the bar to break? (b) What is the maximum speed of the elements of copper at this moment? (c) What is the sound intensity in the bar?arrow_forwardThe area of a typical eardrum is about 5.00 X 10-5 m2. (a) (Calculate the average sound power incident on an eardrum at the threshold of pain, which corresponds to an intensity of 1.00 W/m2. (b) How much energy is transferred to the eardrum exposed to this sound lor 1.00 mill?arrow_forwardThree metal rods are located relative to each other as shown in Figure P17.68. where Ls = L1 + L2. The speed of sound in a rod is given by = Y/p, where Y is Youngs modulus for the rod and is the density. Values of density and Young's modulus for the three materials are 1 = 2.70 X 103 kg/m3, Y1 = 7.00 1010 N/m, 2 = 11.3 103 kg/m3, = 1.60 1010 N/m2. s = 8.80 103 kg/m3 Ys = 11.0 1010N/m2. If L3 = 1.50m, what must the ratio L1/L2if a sound wave is to travel the length of rods 1 and 2 in the same time interval required for the wave to travel the length of rod 3?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning