Refrigeration and Air Conditioning Technology (MindTap Course List)
8th Edition
ISBN: 9781305578296
Author: John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 16, Problem 5RQ
Pneumatic air must
A. be clean and dry.
B. have very high pressure.
C. encompass a large volume.
D. be hot.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Technician A says that coolant hoses should
be squeezed to check for hardening or
softening. Technician B says that coolant
hoses should be visually inspected for
swelling and cracks. Who is correct?
Select one:
a. Technician A only
b. Technician B only
c. Both A and B
d. Neither A nor B
4.a. You can usually check for a leak in a vacuum system by looking at or feelingA. at the vacuum gauge at the vacuum pump.B. for signs of dirt on the piping.C. at the exhaust of the vacuum pump.
4.b. When a pneumatic solenoid fails, the failure is normally due to aB. weak pilot.C. bad spool.D. ripped seal.
Using fluid liquid equation. fluid properties. Leakproof Vessel with water.
Chapter 16 Solutions
Refrigeration and Air Conditioning Technology (MindTap Course List)
Ch. 16 - True or False: Pneumatic controls are...Ch. 16 - Pneumatic controls are operated by A. water. B....Ch. 16 - One advantage of a modern control system is A....Ch. 16 - A control loop contains _______, _______, and...Ch. 16 - Pneumatic air must A. be clean and dry. B. have...Ch. 16 - The air supplied to a diaphragm is 20 psig, and...Ch. 16 - When a large volume of air is needed at a...Ch. 16 - Prob. 8RQCh. 16 - Prob. 9RQCh. 16 - An analog control signal A. has an infinite number...
Ch. 16 - Another term used to describe sensitivity in...Ch. 16 - Prob. 12RQCh. 16 - Prob. 13RQCh. 16 - One of the major components of a residential...Ch. 16 - Prob. 15RQCh. 16 - Describe a control device, and give three examples...Ch. 16 - Describe what a sensor does in a DDC system used...Ch. 16 - What is the difference between an active and a...Ch. 16 - A control system consists of what three basic...Ch. 16 - List six advantages that DDC control systems have...Ch. 16 - Describe the difference between the analog and...Ch. 16 - Describe the difference between an open-loop and a...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Hot water is transportedarrow_forwardWhen a u-tube (manometer) is connected to the atmosphere on one side and a pressurized tire on the other side, which is true? A. The height of the liquid on the tire side is higher due to more particle collisions with the liquid. B. The height of the liquid on the tire side is lower due to more particle collisions with the liquid. C. The height of the liquid on the tire side is higher due to fewer particle collisions with the liquid. D. The height of the liquid on the tire side is lower due to fewer particle collisions with the liquidarrow_forwardFLAKABLE LIQUID 3. One precaution that needs to be foliowed in a work area displaying the sign shown above is wear a leather apron. b. avoid using solvents. C. wear rubber gloves. d. prohibit welding. a.arrow_forward
- mass flow rate of the air (Ibm/s).arrow_forwardExcessive oil results in all of the following EXCEPΤ: Select one: a. low oil pressure. b. high oil pressure. c. drag. d. foaming.arrow_forwardused to express the difference between the pressure recorded and the local atmospheric pressure a. Zero Absolute Pressure b. Gauge pressure' c. Zero absolute pressure d. relative pressure e. absolute pressurearrow_forward
- I need GF,CF,CD asap pleasearrow_forwardselect the most accurate statement Select one: a. atmospheric pressure at sea level is zero b. none c. bourdon pressure gauge is more accurate than manometer d. manometer is more accurate than bourdon pressure gaugearrow_forwardTechnician A says that the same hydrometer can be used for both ethylene glycol and propylene glycol coolants. Technician B says that some hydrometers include a thermometer to compensate the reading based on coolant temperature. Who is correct? Select one: a. Technician A only b. Technician B only c. Both A and B d. Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Physics - Thermodynamics: (21 of 22) Change Of State: Process Summary; Author: Michel van Biezen;https://www.youtube.com/watch?v=AzmXVvxXN70;License: Standard Youtube License