Concept explainers
The dynamic reaction at
The dynamic reaction at
Answer to Problem 18.101P
The dynamic reactions at
The dynamic reactions at
Explanation of Solution
Given information:
Angular velocity of disk in z-direction is
The Figure-(1) shows a schematic diagram.
Figure (1)
Write the equation for the mass of the disk.
Here, weight of disk is
Write the expression for the angular momentum about point
Here, mass moment of inertia about the x-axis is
Write the expression for the angular velocity of disk in x direction.
Substitute
Here,
Write the expression for angular velocity in vector form.
Write the expression for rate of angular velocity of the reference frame
Write the expression for rate of total angular velocity.
Substitute
Write the expression for Matrix multiplication of the vector product for Equation (8).
Write the expression for the mass moment of inertia about the y-direction.
Here mass of the disk is
Write the expression for the mass moment of inertia about the z- direction.
Substitute
Write the expression for the velocity of mass centre of the disk.
Here, velocity of mass centre is
Write the expression for the matrix multiplication of the vector product for Equation (13).
Write the expression for the acceleration of the mass centre of the disk.
Write the expression for the matrix multiplication of the vector product for Equation (15).
Write the expression for the the sum of the forces acting on the system.
Write the expression for the force in terms of mass and acceleration.
Substitute
Here, force at
Substitute
Compare the coefficients of the unit vector of
Compare the coefficients of the unit vector of
Write the expression for the rate of angular momentum about
Here, distance between
Write the expression for
Here, distance from the centre of disk to point
Substitute
Write the expression for the matrix multiplication for vector product for equation (24).
Write the expression for the moment about
Here, length of
Write the expression for the matrix multiplication for the vector product for equation (26).
Here
Write the given expression for couple when system is at rest.
The sum of the moment at
Substitute
Compare the coefficients of the unit vector of
Compare the coefficients of the unit vector of
Compare the coefficients of the unit vector of
Substitute
Substitute
Write the expression for the angular velocity in terms of time in y-direction.
Here time is
Calculation:
Substitute
Substitute values of
Substitute
Substitute values of
Substitute values of
Hence, dynamic reaction at
Substitute values of
Substitute values of
Hence, dynamic reaction at
Conclusion:
The dynamic reactions at
The dynamic reactions at
Want to see more full solutions like this?
Chapter 18 Solutions
Vector Mechanics For Engineers
- The 10-oz disk shown spins at the rate w1= 750 rpm, while axle AB rotates as shown with an angular velocity w2 of magnitude 6 rad/s. Determine the dynamic reactions at A and B.arrow_forwardA homogeneous disk of weight W = 6 lb rotates at the constant rate w1 = 16 rad/s with respect to arm ABC, which is welded to a shaft DCE rotating at the constant rate w2 = 8 rad/s. Determine the dynamic reactions at D and E.arrow_forwardA vertical open-belt drive connects two pullets A and B the centres of which are 4 m a part. The belt has a mass of 1.15kg/m. Pulley A is 1m diameter, has radius of gyration of 420mm and a mass of 25kg. Pulley B is 0.5m diameter has radius of gyration of 225mm, and a mass of 18kg. when at rest the tension in the belt is 700N. Assuming that the belt obeys Hooke's law, If power of 1.5kW is being transmitted, and the speed of A being 180r.p.m. Neglect belt stretch over the pulleys. Determine: 1. The tension in the two portion of the belt between the pulleys and, 2. The kinetic energy of the belt and pulleys under this conditions.arrow_forward
- (3) The 12-lb lever OA with 10-in. radius of gyration about point O is initially at rest in the vertical position (8 = 90°), where the attached spring of stiffness k= 3 lb/in is unstretched. Calculate the constant moment M applied to the lever at O which will give the lever an angular velocity o = 4 rad/sec as the lever rotates to the horizontal position at 0 = 0. k = 3 lb/in. wwww 15 15arrow_forwardThe two identical links, each of length b= 500 mm and mass m = 20 kg may be treated as uniform slender bars. The distance between A and the instantaneous center of zero velocity of AB at the current location (0= 30°) isarrow_forwardThe turbine rotor of a ship has a mass of 4000 kg and a radius of gyration of 480 mm. It rotates at 2400 rev/min. clockwise when looking forward from the stern. In each of the following cases, determine the magnitude and indicate clearly with suitable diagrams the effect of the gyroscopic couple acting on the ship: (a) (b) (c) If the ship, when travelling at 15 ms¹ turns to starboard in a curve of 1000m radius. If the ship is pitching and the bow is descending with maximum velocity. The pitching motion is simple harmonic, the period being 20 seconds and the total angular movement is 12º. If the ship is rolling and at a certain instant has an angular velocity of 0.02 rad/sec. clockwise when looking forward from the stern.arrow_forward
- A stationary horizontal plate is attached to the ceiling by means ofa fixed vertical tube. A wheel of radius aa and mass mm is mounted on a light axle ACAC that is attached by means of a clevis at AA to a rod ABAB fitted inside the vertical tube. The rod ABAB is made to rotate with a constant angular velocity ΩΩ causing the wheel to roll on the lower face of the stationary plate. Determine the minimum angular velocity ΩΩ for which contact is maintained between the wheel and the plate. Consider the particular cases ( aa ) when the mass of the wheel is concentrated in the rim, (b) when the wheel is equivalent to a thin disk of radius aa also extend the problem using Kinematic and Kinetic analysisarrow_forwardQ4. A wobble plate device which consists of a horizontal shaft supported by bearings at A and B, and a thin disk is shown in figure below. At the instant shown, the shaft rotates at a constant rate N = 2 rad/s and the disk spins at a constant rate o = 8 rad/s relative to shaft AB. Given that the mass of the shaft AB is negligible, the disk has a radius of 0.5 m and a mass of 4 kg, tan 0 = 3/4, and L = 0.8 m, determine the absolute angular velocity and acceleration of the disk, (1) (ii) the angular momentum of the disk about point B, HB the effective moment of the disk about B and (ii) (iv) the dynamic reaction at the bearing support at A and B. (v) the kinetic energy of the wobble platearrow_forwardGears A and B of mass 15 kg and 60 kg have radii of gyration about their respective mass centers of k4 = 80 mm and kB = 150 mm. (Figure 1) Figure M = 10 Nm 0.1 m Part A If gear A is subjected to the couple moment M = 10 N-m when it is at rest, determine the angular velocity of gear B when t = 5 s. Express your answer to three significant figures and include the appropriate units. WB = Submit μA Value Request Answer < Return to Assignment Units Provide Feedback www ?arrow_forward
- A ring of mass m =1 kg and radius R = 1m is attached to a vertical shaft by means of a frictionless pin. Coordinates xyz are fixed to the ring as shown and the frictionless pin at A is aligned with the x-axis. The vertical shaft precesses about the Z-axis with constant angular velocity 2 = 1 rad/s. (a) At a particular moment when 0 = 30° and = 4 rad/s, find the value of Ö . This comes from a sum of the moments about the x-axis. Do not neglect gravity. (b) Find the torque or moment necessary that must be applied about the vertical shaft in order to keep it turning at a constant rate of N = 1 rad/s. Ring R XG A 1 Ixx = lyy =mR? G Iz = mR?arrow_forwardA rotor of 75 mm radius has a mass of 5 kg. It is mounted centrally in bearings which maintain its axle in horizontal plane. The rotor spins about its axle at a constant speed of 600 rpm clockwise when viewed from the left side bearing. While the axle precesses uniformly about the vertical at 30 rpm in anticlockwise direction. If the distance between the bearing is 100 mm. Find the resultant reaction at the right end bearing due to mass and gyroscopic effect.arrow_forwardA drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity g=9.81 m/s2 . (2) ) If the mass moment of inertia of the drum about point O is IO, and the angular acceleration of the drum is α, select the correct moment equation of the whole drum-block system about the point O._____________ A. mbgr=rmb(rα) B. 0 C. mbgr=Ioα +rmb(rα) D. mbgr=Ioαarrow_forward
- Elements Of ElectromagneticsMechanical EngineeringISBN:9780190698614Author:Sadiku, Matthew N. O.Publisher:Oxford University PressMechanics of Materials (10th Edition)Mechanical EngineeringISBN:9780134319650Author:Russell C. HibbelerPublisher:PEARSONThermodynamics: An Engineering ApproachMechanical EngineeringISBN:9781259822674Author:Yunus A. Cengel Dr., Michael A. BolesPublisher:McGraw-Hill Education
- Control Systems EngineeringMechanical EngineeringISBN:9781118170519Author:Norman S. NisePublisher:WILEYMechanics of Materials (MindTap Course List)Mechanical EngineeringISBN:9781337093347Author:Barry J. Goodno, James M. GerePublisher:Cengage LearningEngineering Mechanics: StaticsMechanical EngineeringISBN:9781118807330Author:James L. Meriam, L. G. Kraige, J. N. BoltonPublisher:WILEY