(a)
Interpretation:
Equation for the parallel capacitance Cp should be determined.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
(b)
Interpretation:
Cp, charge on each capacitor and the total charge Qp should be calculated.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
(c)
Interpretation:
An equation for the total capacitance (Cs) of a series capacitor circuit should be determined.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
(d)
Interpretation:
Cs and the voltage drop across each capacitor should be calculated of a series capacitor circuit should be determined.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
(e)
Interpretation:
An equation for the total capacitance (Cs) of a series with two capacitor circuit should be determined.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
(f)
Interpretation:
The capacitance of the network, voltage across each capacitor and the charge on each capacitor should be calculated.
Concept introduction:
In a capacitor, the charge Q is directly proportional to the applied voltage.
Q = CV
V = Apply voltage
Q = quantity of the charge
C = Capacitance of capacitor
Want to see the full answer?
Check out a sample textbook solutionChapter 2 Solutions
Principles of Instrumental Analysis
- (a) A silicon sample maintained at T = 300 K is uniformly doped with Nd = 1016cm-3 donors. Calculate the resistivity of the sample.arrow_forwardIn a survey of 1000 large corporations, 250 said that, given a choice between a job candidate who smokes and an equally qualified nonsmoker, the nonsmoker would get the job (USA Today).(a) Let p represent the proportion of all corporations preferring a nonsmoking candidate. Find a point estimate for p.(b) Find a 0.95 confidence interval for p.(c) As a news writer, how would you report the survey results regarding the proportion of corporations that hire the equally qualified nonsmoker? What is the margin of error based on a 95% confidence interval?arrow_forwardI need step by step process solving [4.184x156(Tf-295)] + [4.184x85.2(Tf-368)] = 0. because my work is wrong. Thank you!!arrow_forward
- If Q=96500 Coul and t=8 min ,then I will be The value of Z for the electrolyte ZnCl2 will be O =201.04 microamp Z=65/1 I=12062.5 amp Z=65/2 O =201.04 amp Z=65/2arrow_forwardIn 2VO2+ (aq) + Zn(g) + 4H+ (aq) - 2VO2+ (aq) + Zn2+(aq) + 2H2O(l), 1. How many moles of electrons are transferred overall? 2. If E°cell = +1.76 V and Ecell = +1.25 V and [VO²⁺] and [VO₂⁺] are both 1.0 M, and the pH is 5.00, what is the [Zn²⁺]?arrow_forwardPts) |Xtag), X2+ (aq) |/ y3+ *(aq) | Y(s) Given the line notation: where: x2+ + e x+ E° = 0.48 V y3+ + 3 e → Y E° = -2.35 V Pt4+ + 4 e - Pt E° = 1.20 V Calculate the EMF. Input values only with 2 decimal places. Do not include the unit. If positive value: DO NOT include the positive (+) sign If negative value: Please include the negative (-) signarrow_forward
- The measured Eocell=+2.222 V. Using EoMg2+/Mg= -2.372 V, calculate Eo Sn2+/Sn in voltsarrow_forwardThe following data were obtained from the calibration of an air-displacement pipette by repetitive drawing 1000.0 microliters of pure water at 4.00 °C using this pipette and weighing them on an analytical balance, which gave the following readings, respectively: 1.003, 1.000, 1.005, 1.007 g. How many measurements would have to be averaged to obtain an S/N of 1000? Type your numeric answer and submitarrow_forward(b) The random error, r', on the result, R, is given by F = √()*² + ( )² R where v', and v, are the random errors on V', and Vt, respectively (1) Let V=26.00 mL, V = 24.00 mL; v' = ±0.01 (3) mL, vt = ±0.01 (2) mL. What is the percentage random error, r'/R x 100%, on R? (2) What is r'/Rx 100 if the conditions of each titration vary (e.g., different portions of the burette stem are used) so that V₁= 26.00 mL, V₁ = 24.00 mL; v' = ±0.05(2) mL, vt = ±0.04(8) mL?arrow_forward
- Part F The third variable (call it v) is v=x1-cx2 + x3, where c is a constant you need to determine so that the equation for v is the SHM equation. Determine v. The solution to the equation for vis v = 2B cos(t + b). Express your answer in terms of some, all, or none of the variables 21, 22, 23, and the appropriate constants. v = ΜΕ ΑΣΦ Submit Request Answer ?arrow_forwardYou have a solution containing two metal cations. You want to separate them by slowly and carefully adding a solution of an anion, until one metal cation precipitates as a compound with that anion, leaving the other metal cation still in solution. Your metal cations (M+ and M2+) and your anion M+= Cu^+ M^2+= Cd^2+ Anion= S^2- First Ksp(M+ w/anion)= 2.5 x 10-48 Second Ksp(M2+ w/anion)= 1.0 x 10-28 ----------------------------------------------------------------------------------- Starting concentrations of yourmetal ions in your initial solution: [M+]= 4.00 x 10-5 M [M2+]= 2.50 x 10-5 M Using these values, predict which metal will precipitate first, and at what concentration of anion the precipitation will begin. Clearly state the parameters of your particular problem at the beginning. What is M+, what is M2+, what are your concentrations, what are you solving for?arrow_forwardQ3)a) Discuss the any two applications of Beer’s law with suitable justification. (b) In an analytical laboratory a chemical compound namely Paracetamol (151.163 g/mol) is determined in a sample. A sample weighing 0.0295 g was dissolved in a solvent and diluted the solution to 1 L. The solution has λ max at 243 nm (ε=2.6×104 cm-1 mol-1 L). The solution exhibits an absorbance of 0.638 in a 2 cm cell. Calculate the percentage paracetamol in the sample. (c) Analyze any two causes of non-linearity of curve in the Beer’s law.arrow_forward
- Principles of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning